EN 71-1:1998/A6:2002
(Amendment)Safety of Toys - Part 1: Mechanical and physical properties
Safety of Toys - Part 1: Mechanical and physical properties
Amend the indent " - flotation aids such as arm bands (see C.24);" to
" - flotation aids such as arm bands and swim seats (see C.24);"
Sicherheit von Spielzeug - Teil 1: Mechanische und physikalische Eigenschaften
Sécurité des jouets - Partie 1: Propriétés mécaniques et physiques
Varnost igrač - 1. del: Mehanske in fizikalne lastnosti - Dopolnilo A6
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-september-2002
9DUQRVWLJUDþGHO0HKDQVNHLQIL]LNDOQHODVWQRVWL'RSROQLOR$
Safety of Toys - Part 1: Mechanical and physical properties
Sicherheit von Spielzeug - Teil 1: Mechanische und physikalische Eigenschaften
Sécurité des jouets - Partie 1: Propriétés mécaniques et physiques
Ta slovenski standard je istoveten z: EN 71-1:1998/A6:2002
ICS:
97.200.50 ,JUDþH Toys
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 71-1:1998/A6
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2002
ICS 97.200.50
English version
Safety of Toys - Part 1: Mechanical and physical properties
Sécurité des jouets - Partie 1: Propriétés mécaniques et Sicherheit von Spielzeug - Teil 1: Mechanische und
physiques physikalische Eigenschaften
This amendment A6 modifies the European Standard EN 71-1:1998; it was approved by CEN on 14 February 2002.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2002 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 71-1:1998/A6:2002 E
worldwide for CEN national Members.
Contents
page
Foreword.3
1 Scope.4
4.17 Projectiles (see C.23).4
4.17.1 General .4
Annex ZA (informative) Clauses of this European Standard addressin
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.