EN ISO 14889:2003

SLOVENSKI STANDARD
SIST EN ISO 14889:2003
01-september-2003
1DGRPHãþD
SIST EN ISO 14889:2000
2þHVQDRSWLND6WHNODRþDO7HPHOMQH]DKWHYH]DQHEUXãHQDJRWRYDVWHNOD,62

Ophthalmic optics - Spectacle lenses - Fundamental requirements for uncut finished
lenses (ISO 14889:2003)
Augenoptik - Brillengläser - Grundlegende Anforderungen an rohkantige fertige
Brillengläser (ISO 14889:2003)
Optique ophtalmique - Verres de lunettes - Exigences fondamentales relatives aux
verres finis non détourés (ISO 14889:2003)
Ta slovenski standard je istoveten z: EN ISO 14889:2003
ICS:
11.040.70 Oftalmološka oprema Ophthalmic equipment
SIST EN ISO 14889:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 14889:2003

---------------------- Page: 2 ----------------------

SIST EN ISO 14889:2003
EUROPEAN STANDARD
EN ISO 14889
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2003
ICS 11.040.70 Supersedes EN ISO 14889:1997
English version
Ophthalmic optics - Spectacle lenses - Fundamental
requirements for uncut finished lenses (ISO 14889:2003)
Optique ophtalmique - Verres de lunettes - Exigences Augenoptik - Brillengläser - Grundlegende Anforderungen
fondamentales relatives aux verres finis non détourés (ISO an rohkantige fertige Brillengläser (ISO 14889:2003)
14889:2003)
This European Standard was approved by CEN on 16 April 2003.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2003 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 14889:2003 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 14889:2003
EN ISO 14889:2003 (E)
CORRECTED  2003-07-16
Foreword
This document (EN ISO 14889:2003) has been prepared by Technical Committee ISO/TC 172
"Optics and optical instruments" in collaboration with Technical Committee CEN/TC 170
"Ophthalmic optics", the secretariat of which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of
an identical text or by endorsement, at the latest by November 2003, and conflicting national
standards shall be withdrawn at the latest by November 2003.
This document supersedes EN ISO 14889:1997.
This document has been prepared under a mandate given to CEN by the European Commission
and the European Free Trade Association, and supports essential requirements of EU
Directive(s).
For relationship with EU Directive(s), see informative Annex ZB, which is an integral part of this
document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of
the following countries are bound to implement this European Standard: Austria, Belgium, Czech
Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and
the United Kingdom.
Endorsement notice
The text of ISO 14889:2003 has been approved by CEN as EN ISO 14889:2003 without any
modifications.
NOTE Normative references to International Standards are listed in Annex ZA (normative).
2

---------------------- Page: 4 ----------------------

SIST EN ISO 14889:2003
EN ISO 14889:2003 (E)
Annex ZA
(normative)
Normative references to international publications
with their relevant European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of
any of these publications apply to this European Standard only when incorporated in it by
amendment or revision. For undated references the latest edition of the publication referred to
applies (including amendments).
NOTE Where an International Publication has been modified by common modifications, indicated
by (mod.), the relevant EN/HD applies.
Publication Year Title EN Year
ISO 8980-1 1996 Ophthalmic optics - Uncut finished EN ISO 8980-1 1997
spectacle lenses - Part 1:
Specifications for single-vision
and multifocal lenses
ISO 8980-2 1996 Ophthalmic optics - Uncut finished EN ISO 8980-2 1997
spectacle lenses - Part 2:
Specifications for progressive
power lenses
ISO 8980-3 1999 Ophthalmic optics - Uncut finished EN ISO 8980-3 1999
spectacle lenses - Part 3:
Transmittance specifications and
test methods
ISO 8980-4 2000 Ophthalmic optics - Uncut finished EN ISO 8980-4 2000
spectacle lenses - Part 4:
Specifications and test methods
for anti-reflection coatings
ISO 13666 1998 Ophthalmic optics - Spectacles EN ISO 13666 1998
lenses - Vocabulary
3

---------------------- Page: 5 ----------------------

SIST EN ISO 14889:2003
EN ISO 14889:2003 (E)
Annex ZB
(informative)
Clauses of this European Standard addressing essential requirements or
other provisions of EU Directives.
This European standard has been prepared under a mandate given to CEN by the European
Commission and the European Free Trade Association and supports essential requirements of
EU Directive 93/42/EEC.
WARNING : Other requirements and other EU Directives may be applicable to the product(s)
falling within the scope of this standard.
The following clauses of this standard, as detailed in table ZA.1, are likely to support
requirements of Directive: 93/42/EEC.
Compliance with the clauses of this standard provides one means of conforming with the specific
essential requirements of the Directive concerned and associated EFTA regulations.
Table ZA.1: Correspondence between this European Standard and EU Directives
Clauses/ Sub-clauses of this Corresponding Comments
European Standard fundamental requirements of
Directive 93/42/EEC
4, 5 I.1, I.3
4.2 I.2, I.6
4.3.1, 4.3.2, 4.4, 5.2, 5.3 II.7.1
4.4, 5.3 II.9.2
4.3.2, 5.2 II.9.3
6 II.13.1, II.13.3
4

---------------------- Page: 6 ----------------------

SIST EN ISO 14889:2003

INTERNATIONAL ISO
STANDARD 14889
Second edition
2003-05-15


Ophthalmic optics — Spectacle lenses —
Fundamental requirements for uncut
finished lenses
Optique ophtalmique — Verres de lunettes — Exigences
fondamentales relatives aux verres finis non détourés




Reference number
ISO 14889:2003(E)
©
ISO 2003

---------------------- Page: 7 ----------------------

SIST EN ISO 14889:2003
ISO 14889:2003(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


©  ISO 2003
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2003 — All rights reserved

---------------------- Page: 8 ----------------------

SIST EN ISO 14889:2003
ISO 14889:2003(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 14889 was prepared by Technical Committee ISO/TC 172, Optics and optical instruments, Subcommittee
SC 7, Ophthalmic optics and instruments.
This second edition cancels and replaces the first edition (ISO 14889:1997), which has been technically
revised.
© ISO 2003 — All rights reserved iii

---------------------- Page: 9 ----------------------

SIST EN ISO 14889:2003

---------------------- Page: 10 ----------------------

SIST EN ISO 14889:2003
INTERNATIONAL STANDARD ISO 14889:2003(E)

Ophthalmic optics — Spectacle lenses — Fundamental
requirements for uncut finished lenses
1 Scope
This International Standard specifies fundamental requirements for uncut finished spectacle lenses. This
International Standard is not applicable to protective spectacle lenses.
This International Standard takes precedence over the corresponding requirements of other standards, if
differences exist.
2 Normative references
The following referenced documents are indispensable for the a
...