EN 1968:2002/A1:2005
(Amendment)Transportable gas cylinders - Periodic inspection and testing of seamless steel gas cylinders
Transportable gas cylinders - Periodic inspection and testing of seamless steel gas cylinders
This European Standard specifies the requirements for periodic inspection and testing of
seamless steel transportable gas cylinders (single or those from bundles) intended for
compressed and liquefied gases under pressure, of water capacity from 0,5 l up to 150 l.
NOTE As far as practicable, this standard may also be applied to cylinders of less than 0,5 l water
capacity and for tubes up to 3 000 l water capacity.
Ortsbewegliche Gasflaschen - Wiederkehrende Prüfung von nahtlosen Gasflaschen aus Stahl
Bouteilles à gaz transportables - Contrôles et essais périodiques des bouteilles à gaz sans soudure en acier
Premične plinske jeklenke – Periodični nadzor in preskus jeklenih jeklenk iz celega
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-marec-2006
3UHPLþQHSOLQVNHMHNOHQNH±3HULRGLþQLQDG]RULQSUHVNXVMHNOHQLKMHNOHQNL]FHOHJD
Transportable gas cylinders - Periodic inspection and testing of seamless steel gas
cylinders
Ortsbewegliche Gasflaschen - Wiederkehrende Prüfung von nahtlosen Gasflaschen aus
Stahl
Bouteilles a gaz transportables - Contrôles et essais périodiques des bouteilles a gaz
sans soudure en acier
Ta slovenski standard je istoveten z: EN 1968:2002/A1:2005
ICS:
23.020.30 7ODþQHSRVRGHSOLQVNH Pressure vessels, gas
MHNOHQNH cylinders
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 1968:2002/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
October 2005
ICS 23.020.30
English Version
Transportable gas cylinders - Periodic inspection and testing of
seamless steel gas cylinders
Bouteilles à gaz transportables - Contrôles et essais Ortsbewegliche Gasflaschen - Wiederkehrende Prüfung
périodiques des bouteilles à gaz sans soudure en acier von nahtlosen Gasflaschen aus Stahl
This amendment A1 modifies the European Standard EN 1968:2002; it was approved by CEN on 26 August 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Central Secretariat or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
CEN members are the
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.