EN ISO 22649:2016

SLOVENSKI STANDARD
01-julij-2016
1DGRPHãþD
SIST EN 12746:2000
SIST EN 12746:2000/A1:2005
Obutev - Preskusne metode za notranjike in vložke - Absorpcija in desorpcija vode
(ISO 22649:2016)
Footwear - Test methods for insoles and insocks - Water absorption and desorption (ISO
22649:2016)
Schuhe - Prüfverfahren für Brandsohlen und Decksohlen - Wasseraufnahme und
Wasserabgabe (ISO 22649:2016)
Chaussures - Méthodes d'essai applicables aux premières de montage et aux premières
de propreté - Absorption et désorption d'eau (ISO 22649:2016)
Ta slovenski standard je istoveten z: EN ISO 22649:2016
ICS:
61.060 Obuvala Footwear
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN ISO 22649
EUROPEAN STANDARD
NORME EUROPÉENNE
May 2016
EUROPÄISCHE NORM
ICS 61.060 Supersedes EN 12746:2000
English Version
Footwear - Test methods for insoles and insocks - Water
absorption and desorption (ISO 22649:2016)
Chaussures - Méthodes d'essai applicables aux Schuhe - Prüfverfahren für Brandsohlen und
premières de montage et aux premières de propreté - Decksohlen - Wasseraufnahme und Wasserabgabe (ISO
Absorption et désorption d'eau (ISO 22649:2016) 22649:2016)
This European Standard was approved by CEN on 15 April 2016.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2016 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 22649:2016 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
European foreword
This document (EN ISO 22649:2016) has been prepared by Technical Committee ISO/TC 216
“Footwear” in collaboration with Technical Committee CEN/TC 309 “Footwear” the secretariat of which
is held by AENOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by November 2016, and conflicting national standards
shall be withdrawn at the latest by November 2016.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent
rights.
This document supersedes EN 12746:2000.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
Endorsement notice
The text of ISO 22649:2016 has been approved by CEN as EN ISO 22649:2016 without any modification.

INTERNATIONAL ISO
STANDARD 22649
Second edition
2016-05-01
Footwear — Test methods for insoles
and insocks — Water absorption and
desorption
Chaussures — Méthodes d’essai applicables aux premières de montage
et aux premières de propreté — Absorption et désorption d’eau
Reference number
ISO 22649:2016(E)
©
ISO 2016
ISO 22649:2016(E)
© ISO 2016, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2016 – All rights reserved

ISO 22649:2016(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Apparatus and material . 1
4.1 Method A . 1
4.2 Method B . 2
5 Sampling and conditioning . 3
5.1 Method A . 3
5.2 Method B . 4
6 Test method . 4
6.1 Method A . 4
6.1.1 Determination of the water absorption . 4
6.1.2 Determination of the water desorption . 4
6.2 Method B . 4
6.2.1 Principle . 4
6.2.2 Determination of the water absorption . 4
6.2.3 Determination of the water desorption . 5
7 Expression of results . 5
7.1 Method A . 5
7.1.1 Water absorption . . 5
7.1.2 Water desorption. 5
7.2 Method B . 6
7.2.1 Water absorption . . 6
7.2.2 Water desorption. 6
8 Test report . 6
8.1 Method A . 6
8.2 Method B . 7
ISO 22649:2016(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of
any patent rights identified during the development of the document will be in the Introduction and/or
on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity
assessment, as well as information about ISO’s adherence to the WTO principles in the Technical
Barriers to Trade (TBT) see the following URL: Foreword - Supplementary information
ISO 22649 was prepared by the European Committee Standardization (CEN) Technical Committee
CEN/TC 309, Footwear, in collaboration with ISO Technical Committee TC 216, Footwear, in accordance
with the agreement on technical cooperation between ISO and CEN (Vienna Agreement).
This second edition cancels and replaces the first edition (ISO 22649:2003), which has been technically
revised.
iv © ISO 2016 – All rights reserved

INTERNATIONAL STANDARD ISO 22649:2016(E)
Footwear — Test methods for insoles and insocks — Water
absorption and desorption
1 Scope
This International Standard specifies two test methods for determining the water absorption and
desorption of insoles and insocks, irrespective of the material.
These methods are as follows.
— Method A: Determination of the static water absorption and desorption of insoles and insocks.
— Method B: Determination of the dynamic water absorption and desorption of insoles and insocks.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any
...