ISO/TC 135/SC 6 - Leak testing
Contrôle par détection de fuites
General Information
ISO 20486:2017 specifies the calibration of those leaks that are used for the adjustment of leak detectors for the determination of leakage rate in everyday use. One type of calibration method is a comparison with a reference leak. In this way, the leaks used for routine use become traceable to a primary standard. In other calibration methods, the value of vapour pressure was measured directly or calculated over a known volume. The comparison procedures are preferably applicable to helium leaks, because this test gas can be selectively measured by a mass spectrometer leak detector (MSLD) (the definition of MSLD is given in ISO 20484). Calibration by comparison (see methods A, As, B and Bs below) with known reference leaks is easily possible for leaks with reservoir and leakage rates below 10−7 Pa·m3/s. Figure 1 gives an overview of the different recommended calibration methods.
- Standard32 pagesEnglish languagesale 15% off
- Standard33 pagesFrench languagesale 15% off
ISO 20485:2017 describes the techniques to be applied for the detection of a leak, using a tracer gas and a tracer gas specific leak detector.
- Standard19 pagesEnglish languagesale 15% off
- Standard20 pagesFrench languagesale 15% off
ISO 20484:2017 defines the terms used in leak testing.
- Standard9 pagesEnglish languagesale 15% off
- Standard9 pagesFrench languagesale 15% off
Only leak detectors are described which have an integral high vacuum system to maintain the sensing element of the mass spectrometer at a low pressure. Two procedures are outlined, one to determine the minimum detectable leak rate and the other for determination of the minimum detectable concentration ratio.
- Standard10 pagesEnglish languagesale 15% off
- Standard10 pagesFrench languagesale 15% off
- Standard10 pagesFrench languagesale 15% off