CEN/TC 145/WG 4 - Two roll mills - Safety

This document deals with all significant hazards, hazardous situations or hazardous events relevant to two-roll mills for the processing of rubber and/or plastics (see Annex A), when used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer during all the phases of the life of the machine as described in EN ISO 12100:2010, 5.4.
This document covers two-roll mills as defined in 3.1.
This document covers two-roll mills intended to be used in normal production and two-roll mills intended to be used in laboratories (testing of mixtures by batchwise processing of small amounts, not continuously).
This document is applicable to the following ancillary equipment as integral part of the machine:
-   powered stock guides;
-   strip cutting device;
-   stock blender;
-   recovery conveyor belt;
-   retractable ploughs;
-   secondary roller;
-   supply of heating and/or cooling fluids.
This document does not apply to the design of a local exhaust ventilation system that might be necessary in specific applications of the machine not known by the manufacturer.
This document does not apply to two-roll mills manufactured before the date of its publication as a European Standard.

TC - Corrections in the numbering of the last two figures.

This standard covers the essential health and safety requirements for all two roll mills for the processing of rubber and plastics. Significant hazards are listed in clause 4 and are covered by this standard.
Figure 1 shows the principal parts of a two roll mill.
This standard does not cover requirements for the design of an exhaust system.
This standard applies to two roll mills which are manufactured after the date of issue of this standard.

This standard covers the essential health and safety requirements for all two roll mills for the processing of rubber and plastics. Significant hazards are listed in clause 4 and are covered by this standard.   Figure 1 [not shown in the scope] shows the principal parts of a two roll mill.   This standard does not cover requirements for the design of an exhaust system.   This standard applies to two roll mills which are manufactured after the date of issue of this standard.