ECISS/TC 10/SC 1 - Structural steel - Hollow sections

TC - Modification to Table B.3

This part of this European Standard specifies the technical delivery requirements for cold formed welded structural hollow sections of circular, square or rectangular form and applies to structural hollow sections formed cold without subsequent heat treatment.   The specified requirements apply to non-alloy quality steel, fine grain non-alloy quality steel and fine grain alloy special steels as defined in EN 10020.  The grades, chemical composition and mechanical properties for the non-alloy quality steels are given in annex A.  The grades, chemical composition and mechanical properties for the fine grain non-alloy quality and alloy special steels are given in annex B.  The products specified in this part of this European Standard are intended for use in construction.   NOTE1: A range of steel grades is specified in this European Standard and the user should select the grade appropriate to the intended use and service conditions. The grades and mechanical properties of the finished hollow sections are compatible with those in EN 10025 and EN 10113 and some of those in EN 10149.  Requirements for tolerances, dimensions and sectional properties are contained in Part 2 of this European Standard (EN 10219-2).  This European standard does not apply to products covered by the following European Standards:  EN 10025 Hot-rolled products of non-alloy structural steels: Technical delivery conditions  EN 10113 Hot-rolled products in weldable fine grain structural steels  EN 10149 Hot-rolled flat products made of high yield strength steels for cold forming  EN 10155 Structural steels with improved atmospheric corrosion resistance: Technical delivery conditions.  EN 10210 Hot finished structural hollow sections of non-alloy and fine grain structural steels  EN 10225 Weldable structural steels for fixed offshore structures

This Part of this European Standard specifies the tolerances for hot finished  circular, square and rectangular structural hollow sections and gives the dimensions and sectional properties for a range of standard sizes.  For the technical delivery requirements, see EN 10210-1.

This Part of this European Standard specifies the tolerances for cold formed welded circular, square and rectangular structural hollow sections and gives the dimensions and sectional properties for a range of standard sizes.  For the technical delivery requirements see EN 10219-1.

This European Standard covers hot finished structural hollow sections in thicknesses up to and including 65 mm of circular, square or rectangular form and applies to hollow sections formed hot with or without subsequent heat treatment or formed cold with subsequent heat treatment to obtain equivalent metallurgical conditions to those obtained in the hot formed product.