SIST EN 26802:2000

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Gummi- und Kunststoffschläuche und -schlauchleitungen mit Drahteinlage - Hydraulik-Impulsprüfung mit wechselnder Biegung (ISO 6802:1991)Tuyaux et flexibles en caoutchouc et en plastique renforcés par des fils métalliques - Essai d'impulsions hydrauliques avec flexions (ISO 6802:1991)Rubber and plastics hose and hose assemblies - Wire reinforced - Hydraulic impulse test with flexing (ISO 6802:1991)23.040.70Gumene cevi in armatureHoses and hose assembliesICS:Ta slovenski standard je istoveten z:EN 26802:1993SIST EN 26802:2000en01-december-2000SIST EN 26802:2000SLOVENSKI
STANDARD



SIST EN 26802:2000



SIST EN 26802:2000



SIST EN 26802:2000



INTERNATIONAL STANDARD 6802 Second edition 199 1-02-15 Rubber and plastics hose and hose assemblies with wire reinforcements - Hydraulic impulse test with flexing Tuyaux et f7exibles en caoutchouc et en plastique renforcb par des fils mktalliques - Essai d’impulsions hydrauliques avec flexions Reference number ISO 6802:1991(E) SIST EN 26802:2000



ISO 6802:1991(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national Standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Esch member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Inter- national Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 6802 was prepared by Technical Committee ISO/TC 45, Rubber and rubber producfs. This second edition cancels and replaces the first edition (ISO 6802:1982), clause 5 of which has been technically revised. 0 ISO 1991 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, eiectronic or mechanical, including photocopying and microfilm, without Permission in writing from the publisher. International Organization for Standardization Case Postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland ii SIST EN 26802:2000



ISO 6802:1991 (E) Introduction Hydraulic hoses and hose assemblies are frequently flexed in Service. As there may be a need to take this into account during testing, this International Standard provides a Standard method of flexing during impulse testing. . . . Ill SIST EN 26802:2000



This page intentionally left blank SIST EN 26802:2000



~.~- INTERNATIONAL STANDARD ISO 6802:1991(E) Rubber and plastics hose and hose assemblies with wire reinforcements - Hydraulic impulse test with flexing 1 Scope This International Standard specifies the method of flexing wire-reinforced hydraulic hoses and hose assemblies to a Standard cycle during impulse test- ing by the method of ISO 6803. 2 Normative reference The following Standard contains provisions whic
...