SIST EN 302 536-2 V1.1.1:2008

SLOVENSKI STANDARD
01-maj-2008
(OHNWURPDJQHWQD]GUXåOMLYRVWLQ]DGHYHY]YH]L]UDGLMVNLPVSHNWURP(50
1DSUDYHNUDWNHJDGRVHJD65'5DGLMVNDRSUHPDNLGHOXMHYIUHNYHQþQHP
REPRþMXRGN+]GRN+]GHO+DUPRQL]LUDQL(1NL]DMHPDELVWYHQH
]DKWHYHþOHQDGLUHNWLYH5 77(
Electromagnetic compatibility and Radio spectrum Matters (ERM) - Short Range Devices
(SRD) - Radio equipment in the frequency range 315 kHz to 600 kHz - Part 2:
Harmonized EN covering essential requirements of article 3.2 of the R&TTE Directive
Ta slovenski standard je istoveten z: EN 302 536-2 Version 1.1.1
ICS:
33.060.20 Sprejemna in oddajna Receiving and transmitting
oprema equipment
33.100.01 Elektromagnetna združljivost Electromagnetic compatibility
na splošno in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

Harmonized European Standard (Telecommunications series)

Electromagnetic compatibility
and Radio spectrum Matters (ERM);
Short Range Devices (SRD);
Radio equipment in the frequency range 315 kHz to 600 kHz;
Part 2: Harmonized EN covering essential requirements
of article 3.2 of the R&TTE Directive

2 ETSI EN 302 536-2 V1.1.1 (2007-11)

Reference
DEN/ERM-TG30-004-2
Keywords
inductive, magnetic, regulation, SRD, testing
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2007.
All rights reserved.
TM TM TM
DECT , PLUGTESTS and UMTS are Trade Marks of ETSI registered for the benefit of its Members.
TM
TIPHON and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
ETSI
3 ETSI EN 302 536-2 V1.1.1 (2007-11)
Contents
Intellectual Property Rights.5
Foreword.5
1 Scope.6
2 References.6
3 Definitions, symbols and abbreviations .6
3.1 Definitions.6
3.2 Symbols.6
3.3 Abbreviations.6
4 Technical requirements and specifications.7
4.1 Environmental profile.7
4.2 Conformance requirements.7
4.2.1 Mechanical and electrical design .7
4.2.1.1 General.7
4.2.1.2 Antennas.7
4.2.1.3 Controls.7
4.2.1.4 Transmitter shut-off facility.7
4.2.2 Permitted frequency range of the modulation bandwidth .7
4.2.2.1 Definition.7
4.2.2.2 Limits.7
4.2.2.3 Conformance.7
4.2.3 Effective radiated field strength of the fundamental emission.8
4.2.3.1 H-field.8
4.2.3.1.1 Definition.8
4.2.3.1.2 Limit.8
4.2.3.1.3 Conformance .8
4.2.3.2 E-field.8
4.2.3.2.1 Definition.8
4.2.3.2.2 Limit.8
4.2.3.2.3 Conformance .8
4.2.4 Spurious emissions.8
4.2.4.1 Definition.8
4.2.4.2 Limits.8
4.2.4.3 Conformance.8
4.2.5 Spurious radiation of receivers .8
4.2.5.1 Definition.8
4.2.5.2 Limits.8
4.2.5.3 Conformance.9
5 Testing for compliance with technical requirements.9
5.1 Environmental conditions for testing .9
5.2 Interpretation of the measurement results .9
5.3 Essential radio test suites.9
5.3.1 Permitted frequency range of the modulation bandwidth .9
5.3.2 Effective radiated field strength of the fundamental emission.10
5.3.3 Spurious emissions.10
5.3.4 Spurious radiation of receivers .10
5.3.5 Normal and extreme test-conditions .10
5.3.6 Test power source .10
5.3.7 Choice of samples for test suites.10
Annex A (normative): HS Requirements and conformance Test specifications Table
(HS-RTT).11
Annex B (informative): The EN title in the official languages .13
ETSI
4 ETSI EN 302 536-2 V1.1.1 (2007-11)
Annex C (informative): Bibliography.15
History .16

ETSI
5 ETSI EN 302 536-2 V1.1.1 (2007-11)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://webapp.etsi.org/IPR/home.asp).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee
Electromagnetic compatibility and Radio spectrum Matters (ERM).
The present document has been produced by ETSI in response to a mandate from the European Commission issued
under Council Directive 98/34/EC (as amended) laying down a procedure for the provision of information in the field of
technical standards and regulations.
The present document is intended to become a Harmonized Standard, the reference of which will be published in the
Official Journal of the European Communities referencing the Directive 1999/5/EC of the European Parliament and of
the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual
recognition of their conformity ("the R&TTE Directive").
Technical specifications relevant to Directive 1999/5/EC are given in annex A.
The present document is part 2 of a multi-part deliverable covering Radio Equipment in the frequency range 315 kHz to
600 kHz for Ultra Low Power Animal Implant Devices and accessory peripheral systems including devices that are
intended to be outside the body but in very close proximity to it in normal operation, as identified below:
Part 1: "Technical characteristics and test methods";
Part 2: "Harmonized EN covering essential requirements of article 3.2 of the R&TTE Directive".

National transposition dates
Date of adoption of this EN: 19 October 2007
Date of latest announcement of this EN (doa): 31 January 2008
Date of latest publication of new National Standard
or endorsement of this EN (dop/e): 31 July 2008
Date of withdrawal of any conflicting National Standard (dow): 31 July 2009

ETSI
6 ETSI EN 302 536-2 V1.1.1 (2007-11)
1 Scope
The present document applies to Ultra Low Power Animal Implant (ULP-AID) transmitters and receivers operating in
any part or all of the band from 315 kHz to 600 kHz and any associated radio apparatus transmitting in the frequency
range of 315 kHz to 600 kHz including external programmers and related telecommunication devices using digital
modulation techniques such as, but not limited to, FSK or pulse position modulation.
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the R&TTE Directive will apply to equipment within the scope of the present document.
2 References
The following documents contain provisions which, through reference in this text, constitute provisions of the present
document.
• References are either specific (identified by date of publication and/or edition number or version number) or
non-specific.
• For a specific reference, subsequent revisions do not apply.
• For a non-specific reference, the latest version applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication ETSI cannot guarantee
their long term validity.
[1] ETSI EN 302 536-1 (V1.1.1): "Electromagnetic compatibility and Radio spectrum Matters (ERM);
Short Range Devices (SRD); Radio equipment in the frequency range 315 kHz to 600 kHz;
Part 1: Technical characteristics and test methods".
[2] ETSI TR 100 028 (V1.4.1) (all parts): "Electromagnetic compatibility and Radio Spectrum Matters
(ERM); Uncertainties in the measurement of mobile radio equipment characteristics".
3 Definitions, symbols and abbreviations
3.1 Definitions
For the purposes of the present document, the terms and definitions given in the R&TTE Directive and
EN 302 536-1 [1] apply.
3.2 Symbols
For the purposes of the present document, the symbols given in EN 302 536-1 [1] apply.
3.3 Abbreviations
For the purposes of the present document, the abbreviations given in EN 302 536-1 [1] apply.
ETSI
7 ETSI EN 302 536-2 V1.1.1 (2007-11)
4 Technical requirements and specifications
4.1 Environmental profile
The technical requirements of the present document apply under the environmental profile for operation of the
equipment, which shall be declared by the manufacturer. The equipment shall comply with all the technical
requirements of the present document at all times when operating within the boundary limits of the declared operational
environmental profile.
4.2 Conformance requirements
4.2.1 Mechanical and electrical design
4.2.1.1 General
The equipment shall be designed, constructed and manufactured in accordance with sound engineering practice and
with the aim of minimizing harmful disturbance to other equipment and services and should not be disturbed by harmful
interference from other electronic devices. Transmitters and receivers may be individual or combination units.
4.2.1.2 Antennas
Equipment operating in the ULP-AID band shall have an integral antenna, an external dedicated antenna or both. If
provision for an external antenna connection is made, the connector shall be a unique type to prevent use of an antenna
other than a dedicated antenna supplied by the manufacturer.
4.2.1.3 Controls
Those controls that, if maladjusted, might increase the disturbing potentialities o
...