SIST ISO 5599-1:2002/Cor 1:2014
(Corrigendum)Pneumatic fluid power - Five-port directional control valves - Part 1: Mounting interface surfaces without electrical connector
Pneumatic fluid power - Five-port directional control valves - Part 1: Mounting interface surfaces without electrical connector
This part of ISO 5599 specifies the requirements for a mounting interface surface without electrical connector for fiveport pneumatic directional control valves, for use at a maximum rated pressure of [ 1)]. It gives
— dimensions and tolerances of the interface features,
— port identification, and
— identification of the result of control-mechanism actuation.
It is not applicable to the functional characteristics of interfaces.
Transmissions pneumatiques - Distributeurs à cinq orifices principaux - Partie 1: Plans de pose sans connecteur électrique
Fluidna tehnika - Pnevmatika - Petpotni ventili - 1. del: Priključne površine brez električnih priključkov - Popravek
Ta del standarda ISO 5599 določa zahteve za priključno površino brez električnega priključka za petpotne pnevmatske ventile za uporabo pri največjem nazivnem tlaku [ 1)]. Vsebuje
– dimenzije in odstopanja za lastnosti vmesnika,
– opredelitev vhodov in
– opredelitev rezultata proženja nadzornega mehanizma.
Ne uporablja se za funkcijske značilnosti vmesnikov.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Transmissions pneumatiques - Distributeurs à cinq orifices principaux - Partie 1: Plans de pose sans connecteur électriquePneumatic fluid power - Five-port directional control valves - Part 1: Mounting interface surfaces without electrical connector23.100.50Krmilni sestavni deliControl componentsICS:Ta slovenski standard je istoveten z:ISO 5599-1:2001/Cor 1:2007SIST ISO 5599-1:2002/Cor 1:2014en,fr01-januar-2014SIST ISO 5599-1:2002/Cor 1:2014SLOVENSKI
STANDARD
SIST ISO 5599-1:2002/Cor 1:2014
ICS
23.100.50 Ref. No. ISO 5599-1:2001/Cor.1:2007(E)©
ISO 2007 – All rights reserved Published in Switzerland
INTERNATIONAL STANDARD ISO 5599-1:2001 TECHNICAL CORRIGENDUM 1 Published 2007-02-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION •
• ORGANISATION INTERNATIONALE DE NORMALISATION
Pneumatic fluid p
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.