ISO 21308-6:2018

INTERNATIONAL ISO
STANDARD 21308-6
First edition
2018-10
Road vehicles — Product data
exchange between chassis and
bodywork manufacturers (BEP) —
Part 6:
Coding of hook loader bodywork
Véhicules routiers — Echange de données de produit entre les
fabricants de châssis et de carrosseries (BEP) —
Partie 6: Codage des bras hydrauliques pour bennes amovibles
Reference number
ISO 21308-6:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 21308-6:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 21308-6:2018(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Coding principles . 3
4.1 BEP codes of bodywork for hook loaders . 3
4.2 Units of BEP code values . 3
4.3 References for measurements . 4
4.3.1 Global coordinate system (X, Y, Z) . 4
4.3.2 Hook loader coordinate system . 4
4.4 Related XML coding . 6
5 Coding of geometrical data and space requirements . 7
5.1 Installation of hook loader on vehicle . 7
5.2 Main dimensions hook loaders . 9
5.2.1 Transport position . . 9
5.2.2 Tipping/dumping position . .12
5.2.3 Loading/unloading position .14
6 Coding of container dimensions and features necessary for the handling .17
7 Coding of masses .
...