ISO 16358-1:2013
(Main)Air-cooled air conditioners and air-to-air heat pumps — Testing and calculating methods for seasonal performance factors — Part 1: Cooling seasonal performance factor
Air-cooled air conditioners and air-to-air heat pumps — Testing and calculating methods for seasonal performance factors — Part 1: Cooling seasonal performance factor
ISO 16358-1:2013 specifies the testing and calculating methods for seasonal performance factor of equipment covered by ISO 5151, ISO 13253 and ISO 15042. ISO 16358-1:2013 also specifies the seasonal performance test conditions and the corresponding test procedures for determining the seasonal performance factor of equipment, as specified above, under mandatory test conditions and is intended for use only in marking, comparison, and certification purposes. For the purposes of ISO 16358-1:2013, the rating conditions are those specified under T1 in the reference standards above. The procedures in ISO 16358-1:2013 may be used for other temperature conditions. ISO 16358-1:2013 does not apply to the testing and rating of: water-source heat pumps or water-cooled air conditioners; portable units having a condenser exhaust duct; individual assemblies not constituting a complete refrigeration system; or equipment using the absorption refrigeration cycle.
Climatiseurs à condenseur à air et pompes à chaleur air/air — Essais et méthodes de calcul des coefficients de performance saisonniers — Partie 1: Coefficient de performance saisonnier de refroidissement (COPSR)
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 16358-1
First edition
2013-04-15
Air-cooled air conditioners and air-
to-air heat pumps — Testing and
calculating methods for seasonal
performance factors —
Part 1:
Cooling seasonal performance factor
Climatiseurs à condenseur à air et pompes à chaleur air/air — Essais
et méthodes de calcul des coefficients de performance saisonniers —
Partie 1: Coefficient de performance saisonnier de refroidissement
(COPSR)
Reference number
ISO 16358-1:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 16358-1:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 16358-1:2013(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 3
5 Tests . 5
5.1 General . 5
5.2 Test conditions . 5
5.3 Test methods . 6
6 Calculations. 7
6.1 Cooling seasonal performance factor (CSPF) and total cooling seasonal performance
factor (TCSPF) . 7
6.2 Defined cooling load . 7
6.3 Outdoor temperature bin distribution for cooling . 7
6.4 Cooling seasonal characteristics of fixed capacity units . 8
6.5 Cooling seasonal characteristics of two-stage capacity units . 9
6.6 Cooling seasonal characteristics of multi-stage capacity units .10
6.7 Cooling seasonal characteristics of variable capacity units .11
7 Test report .13
Annex A (informative) Figures
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.