ETSI EN 300 396-3 V1.2.1 (2004-12)

SLOVENSKI STANDARD
SIST EN 300 396-3 V1.2.1:2006
01-april-2006
3UL]HPQLVQRSRYQLUDGLR7(75$±7HKQLþQH]DKWHYH]DQHSRVUHGQLQDþLQ]YH]H
'02±GHO3URWRNROUDGLMVNHJDYPHVQLND$,RGPRELOQHSRVWDMHGRPRELOQH
SRVWDMH0606
Terrestrial Trunked Radio (TETRA); Technical requirements for Direct Mode Operation
(DMO); Part 3: Mobile Station to Mobile Station (MS-MS) Air Interface (AI) protocol
Ta slovenski standard je istoveten z: EN 300 396-3 Version 1.2.1
ICS:
33.070.10 Prizemni snopovni radio Terrestrial Trunked Radio
(TETRA) (TETRA)
SIST EN 300 396-3 V1.2.1:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 300 396-3 V1.2.1:2006

---------------------- Page: 2 ----------------------

SIST EN 300 396-3 V1.2.1:2006

ETSI EN 300 396-3 V1.2.1 (2004-12)
European Standard (Telecommunications series)


Terrestrial Trunked Radio (TETRA);
Technical requirements for Direct Mode Operation (DMO);
Part 3: Mobile Station to Mobile Station (MS-MS)
Air Interface (AI) protocol

---------------------- Page: 3 ----------------------

SIST EN 300 396-3 V1.2.1:2006
 2 ETSI EN 300 396-3 V1.2.1 (2004-12)



Reference
REN/TETRA-08064
Keywords
air interface, protocol, radio, TETRA
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2004.
All rights reserved.

TM TM TM
DECT , PLUGTESTS and UMTS are Trade Marks of ETSI registered for the benefit of its Members.
TM
TIPHON and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
ETSI

---------------------- Page: 4 ----------------------

SIST EN 300 396-3 V1.2.1:2006
 3 ETSI EN 300 396-3 V1.2.1 (2004-12)
Contents
Intellectual Property Rights.11
Foreword.11
1 Scope.12
2 References.12
3 Definitions and abbreviations.13
3.1 Definitions.13
3.2 Abbreviations.15
4 Overview of protocol.17
4.1 General.17
4.2 The DM channel.17
4.3 DM call procedures .18
4.3.1 Constraints on the frame structure .19
4.3.2 Setting up a call .19
4.3.2.1 Call set-up without presence check.19
4.3.2.1.1 Basic procedure.19
4.3.2.1.2 Procedure in frequency efficient mode.20
4.3.2.2 Call set-up with presence check .21
4.3.3 Changeover in a call .21
4.3.4 Pre-emption of a DM call .22
4.3.5 Terminating a call .23
4.3.6 DM short data call .23
4.3.6.1 Unacknowledged short data message.23
4.3.6.2 Acknowledged short data message .24
4.4 DM protocol layering .24
5 Layer 3 service description.25
5.1 Introduction.25
5.2 Services offered.25
5.3 Primitive description.26
5.3.1 DMCC-COMPLETE primitive.26
5.3.2 DMCC-RELEASE primitive.27
5.3.3 DMCC-REPORT primitive.27
5.3.4 DMCC-SDS DATA primitive .27
5.3.5 DMCC-SDS REPORT primitive.28
5.3.6 DMCC-SDS UNITDATA primitive.28
5.3.7 DMCC-SETUP primitive.29
5.3.8 DMCC-TPNI primitive.30
5.3.9 DMCC-TX CEASED primitive.30
5.4 Parameter description.30
5.5 States for DMCC-SAP.35
6 Layer 3 protocol .36
6.1 Introduction.36
6.1.1 DMCC protocol states .36
6.1.1.1 IDLE.36
6.1.1.2 CALL SETUP NORMAL ORIGINATING.36
6.1.1.3 CALL SETUP NORMAL TERMINATING .36
6.1.1.4 CALL SETUP PRES_CHECK ORIGINATING.36
6.1.1.5 CALL SETUP PRES_CHECK TERMINATING.36
6.1.1.6 PRE-EMPTION.36
6.1.1.7 CALL ACTIVE TX OCCUPATION.36
6.1.1.8 CALL ACTIVE TX RESERVATION.37
6.1.1.9 CALL ACTIVE RX OCCUPATION.37
6.1.1.10 CALL ACTIVE RX RESERVATION.37
6.1.1.11 WAIT RSP OCCUPATION .37
ETSI

---------------------- Page: 5 ----------------------

SIST EN 300 396-3 V1.2.1:2006
 4 ETSI EN 300 396-3 V1.2.1 (2004-12)
6.1.1.12 WAIT RSP RESERVATION.37
6.1.1.13 ACK'D SHORT DATA INITIATED.37
6.1.1.14 UNACK'D SHORT DATA INITIATED.37
6.2 Circuit mode calls.37
6.2.1 Procedures for call set-up without presence check .38
6.2.1.1 Outgoing call.38
6.2.1.2 Incoming call.40
6.2.1.3 Temporary group address.41
6.2.2 Procedures for call set-up with presence check .41
6.2.2.1 Outgoing call.41
6.2.2.2 Incoming call.43
6.2.3 Usage of DM-OCCUPIED PDU .44
6.2.3.1 Sending of DM-OCCUPIED PDU by master DM-MS.44
6.2.3.2 Late entry by slave DM-MS.44
6.2.4 Procedures during occupation.44
6.2.4.1 Master DM-MS.44
6.2.4.2 Slave DM-MS.45
6.2.4.3 Transmitting Party Number Identification (TPNI).47
6.2.5 Procedures during reservation.47
6.2.5.1 Master DM-MS.47
6.2.5.2 Slave DM-MS.49
6.2.5.3 Pre-emption of short data sent as a transaction within a circuit mode call.51
6.2.6 Procedures to set up a new call by pre-emption.51
6.3 Short Data Service (SDS) procedures .52
6.3.1 Sending short data.53
6.3.1.1 Sending short data on a free channel.53
6.3.1.1.1 Sending unacknowledged short data on a free channel .53
6.3.1.1.2 Sending acknowledged short data on a free channel .55
6.3.1.2 Sending short data by pre-emption.57
6.3.1.3 Sending short data during circuit mode transmission.58
6.3.1.4 Sending short data as a transaction within a circuit mode call.59
6.3.1.4.1 Pre-emption to send short data as a transaction within a circuit mode call .59
6.3.1.4.2 Changeover to send short data as a transaction within a circuit mode call.60
6.3.1.4.3 Sending the short data as master of the circuit mode call.60
6.3.2 Receiving short data.60
6.3.2.1 Receiving unacknowledged short data.60
6.3.2.2 Receiving acknowledged short data.61
6.3.3 Additional addressing.61
6.3.4 Extended error protection .61
6.3.5 SDS-TL service in DMO .62
6.3.5.1 Service primitives at the DMTL-SDS-SAP .62
6.3.5.2 DMTL-SDS primitives' parameters .65
6.3.5.3 DMTL-SDS PDUs.67
6.3.5.4 DMTL-SDS procedures.67
6.4 Usage of DMA-UNITDATA primitive.70
7 Layer 2 service description.71
7.1 Introduction.71
7.2 Layer 2 architecture.72
7.2.1 Lower layer management in layer 2.73
7.3 Service descriptions.73
7.3.1 Services at the DMA-SAP .73
7.3.1.1 Services provided to layer 3.73
7.3.1.2 Service primitives at the DMA-SAP .74
7.3.1.2.1 DMA-REPORT primitive.74
7.3.1.2.2 DMA-UNITDATA primitive.74
7.3.2 Services at the DMC-SAP .75
7.3.2.1 Services provided to layer 3.75
7.3.2.2 Service primitives at the DMC-SAP .75
7.3.2.2.1 DMC-CONFIGURE primitive.76
7.3.2.2.2 DMC-REPORT primitive.76
7.3.3 Services at the DMD-SAP .76
ETSI

---------------------- Page: 6 ----------------------

SIST EN 300 396-3 V1.2.1:2006
 5 ETSI EN 300 396-3 V1.2.1 (2004-12)
7.3.3.1 Services provided to the U-plane application.76
7.3.3.2 Service primitives at the DMD-SAP .76
7.3.3.2.1 DMD-REPORT primitive.77
7.3.3.2.2 DMD-UNITDATA primitive.77
7.4 Parameter listing.77
7.4.1 Air interface encryption information .77
7.4.2 Air interface encryption state.77
7.4.2A Called party in ongoing call.78
7.4.3 Call release.78
7.4.4 Call set-up after pre-emption or changeover.78
7.4.5 Changeover request held during occupation.78
7.4.5A Channel selection information .78
7.4.6 Circuit mode information.78
7.4.7 Circuit mode type.78
7.4.8 Communication type.78
7.4.9 Destination address.78
7.4.10 Destination address type .79
7.4.10A DM channel.79
7.4.11 DM-SDU.79
7.4.12 DM-SDU length.79
7.4.12A Dual watch information.79
7.4.13 FCS flag.79
7.4.14 Half slot condition .79
7.4.15 Half slot content.79
7.4.16 Half slot importance.79
7.4.17 Half slot position.79
7.4.18 Half slot synchronization .80
7.4.19 Handle to the request .80
7.4.20 Immediate retransmission.80
7.4.21 Incomplete DM-SDS DATA/ACK received .80
7.4.21A Lower layer quality information .80
7.4.21B Master of ongoing call .80
7.4.22 Message type.80
7.4.23 New call pre-emption.80
7.4.24 Number of repeats.81
7.4.25 Priority.81
7.4.26 Priority of ongoing call .81
7.4.27 Recent user changeover request.81
7.4.28 Recent user priority.81
7.4.29 Report.81
7.4.30 Reservation time.81
7.4.31 SDS transaction type.81
7.4.32 Source address.81
7.4.33 Source address type .81
7.4.34 Stealing priority.82
7.4.35 Stolen indication.82
7.4.36 Type of pre-emption .82
7.4.37 Valid addresses.82
8 Layer 2 protocol .82
8.1 Introduction.82
8.1.1 Functions of lower MAC .82
8.1.2 Functions of upper MAC .83
8.2 Interface between lower and upper MAC.83
8.2.1 Logical channels defined at the DMV-SAP.83
8.2.2 Service primitives at the DMV-SAP.84
8.2.3 PDU mapping of the logical channels at the DMV-SAP.85
8.2.4 Scrambling mechanism.86
8.2.5 PDU error detection.86
8.2.6
...