ETSI ETS 300 119-3 ed.1 (1994-01)

SLOVENSKI STANDARD
SIST ETS 300 119-3 E1:2006
01-februar-2006
,QåHQLULQJRSUHPH((±(YURSVNLWHOHNRPXQLNDFLMVNLVWDQGDUG]DSUDNVRSUL
RSUHPL±GHO7HKQLþQH]DKWHYH]DPHãDQHVHVWDYHRNYLURYLQRKLãLM
Equipment Engineering (EE); European telecommunication standard for equipment
practice; Part 3: Engineering requirements for miscellaneous racks and cabinets
Ta slovenski standard je istoveten z: ETS 300 119-3 Edition 1
ICS:
33.050.01 Telekomunikacijska Telecommunication terminal
terminalska oprema na equipment in general
splošno
SIST ETS 300 119-3 E1:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ETS 300 119-3 E1:2006

---------------------- Page: 2 ----------------------

SIST ETS 300 119-3 E1:2006
EUROPEAN ETS 300 119-3
TELECOMMUNICATION January 1994
STANDARD
Source: ETSI TC-EE Reference: DE/EE-3001.4
ICS: 33.080
Equipment, racks, cabinets
Key words:
Equipment Engineering (EE);
European telecommunication standard for equipment practice
Part 3: Engineering requirements for miscellaneous
racks and cabinets
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - secretariat@etsi.fr
X.400: Internet:
Tel.: +33 92 94 42 00 - Fax: +33 93 65 47 16
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1994. All rights reserved.
New presentation - see History box

---------------------- Page: 3 ----------------------

SIST ETS 300 119-3 E1:2006
Page 2
ETS 300 119-3: January 1994
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.

---------------------- Page: 4 ----------------------

SIST ETS 300 119-3 E1:2006
Page 3
ETS 300 119-3: January 1994
Contents
Foreword .5
1 Scope .7
2 Normative references.7
3 Dimensions for miscellaneous racks/cabinets .7
3.1 Height.7
3.2 Width.7
3.3 Depth .8
3.4 Other dimensions.8
4 Accessibility and line-up of miscellaneous racks/cabinets.8
5 Floor loading.8
5.1 Weight per unit area of fully equipped miscellaneous rack/cabinet.8
5.2 Weight per unit area of cable support structure and cabling .8
5.3 Point loading .9
6 Structural load on a miscellaneous rack/cabinet.9
6.1 Static load .9
6.2 Dynamic load .9
7 External cable access .9
8 Dimensions of packaged miscellaneous rack/cabinet .9
Annex A (informative): Illustrative figures.12
Annex B (informative): IEC Sub Committee 48D publication.16
History.17

---------------------- Page: 5 ----------------------

SIST ETS 300 119-3 E1:2006
Page 4
ETS 300 119-3: January 1994
Blank page

---------------------- Page: 6 ----------------------

SIST ETS 300 119-3 E1:2006
Page 5
ETS 300 119-3: January 1994
Foreword
This European Telecommunication Standard (ETS) has been produced by the Equipment Engineering
(EE) Technical Committee of the European Telecommunications Standards Institute (ETSI).
This ETS is part 3 of a 4 part ETS aimed at setting out, on a common basis, the installation engineering
requirements for telecommunication practice, for housing equipment forming part of a public
telecommunications network.
Part 1 is a general introduction, and explains the terminology used, Part 2 specifies the engineering
requirements for racks and cabinets. This part, Part 3, specifies the engineering requirements for
miscellaneous racks and cabinets, Part 4 covers engineering requirements for subracks in miscellaneous
racks and cabinets.
This ETS applies to all telecommunication equipment forming part of the public telecommunications
network. The requirements for miscellaneous racks and cabinets which this part lays down are based on
the work of IEC Sub Committee 48D (see Annex B).
Illustrative figures are contained in Annex A.

---------------------- Page: 7 ----------------------

SIST ETS 300 119-3 E1:2006
Page 6
ETS 300 119-3: January 1994
Blank page

---------------------- Page: 8 ----------------------

SIST ETS 300 119-3 E1:2006
Page 7
ETS 300 119-3: January 1994
1 Scope
This part of European Telecommunication Standard (ETS) 300 119 details requirements for
miscellaneous racks and cabinets supplied unequipped. The miscellaneous racks/cabinets shall be used
for housing telecommunication equipment forming part of a public telecommunication network installed
either on the public telecommunication operators' sites or in the premises of operator's customers. The
miscellaneous racks/cabinets shall be able to accommodate various equipments, e.g. subracks (see ETS
300 119-4 [3]) and shall have provision for doors or covers.
Part 1 of this ETS (ETS 300 119-1 [1]) defines the meaning of rack or cabinet in the context of this ETS.
2 Normative references
This ETS incorporates by dated or undated reference, provisions from other publications. These
normative references are cited at the appropriate places in the text and the publications are listed
hereafter. For dated references, subsequent amendments to or revisions of any of these publications
apply to this ETS only when incorporated in it by amendment or revision. For undated references the latest
edition of the publication referred to applies.
[1] ETS 300 119-1: "Equipment Engineering (EE); European
telecommunication standard for equipment practice Part 1: Introduction
and terminology".
[2] ETS 300 119-2: "Equipment Engineering (EE); European
telecommunication standard for equipment practice Part 2: Engineering
requirements for racks and cabinets".
[3] ETS 300 119-4: "Equipment Engineering (EE); European
telecommunication standard for equipment practice Part 4: Engineering
requirements for subracks in miscellaneous racks and cabinets".
3 Dimensions for miscellaneous racks/cabinets
3.1 Height
The height dimension (H) includes covers, feet or castors if these are an integral part of the miscellaneous
rack/cabinet structure.
For telecommunication centres and customer sites, H shall be 2 200 mm.
The miscellaneous rack/cabinet shall have provision within its height for the attachment of parts for
interfacing to any overhead structure.
The miscellaneous racks/cabinets shall also be provided with devices which can be height-adjusted to
compensate for any unevenness in the floor. The scope for height adjustment shall be at least 25 mm.
The nominal miscellaneous rack/cabinet height shall be measured when the adjustment devices are at
their fully retracted positions.
3.2 Width
The width dimen
...