ETSI EN 300 392-1 V1.3.1 (2005-06)

SLOVENSKI STANDARD
SIST EN 300 392-1 V1.3.1:2006
01-april-2006
Prizemni snopovni radio (TETRA) – Govor in podatki (V+D) – 1. del: Splošna
zasnova omrežja
Terrestrial Trunked Radio (TETRA); Voice plus Data (V+D); Part 1: General network
design
Ta slovenski standard je istoveten z: EN 300 392-1 Version 1.3.1
ICS:
33.070.10 Prizemni snopovni radio Terrestrial Trunked Radio
(TETRA) (TETRA)
SIST EN 300 392-1 V1.3.1:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 300 392-1 V1.3.1:2006

---------------------- Page: 2 ----------------------

SIST EN 300 392-1 V1.3.1:2006

ETSI EN 300 392-1 V1.3.1 (2005-06)
European Standard (Telecommunications series)


Terrestrial Trunked Radio (TETRA);
Voice plus Data (V+D);
Part 1: General network design

---------------------- Page: 3 ----------------------

SIST EN 300 392-1 V1.3.1:2006
 2 ETSI EN 300 392-1 V1.3.1 (2005-06)



Reference
REN/TETRA-03144
Keywords
air interface, TETRA, V+D
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
Individual copies of the present document can be downloaded from:
http://www.etsi.org
The present document may be made available in more than one electronic version or in print. In any case of existing or
perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF).
In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive
within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2005.
All rights reserved.

TM TM TM
DECT , PLUGTESTS and UMTS are Trade Marks of ETSI registered for the benefit of its Members.
TM
TIPHON and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members.
TM
3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners.
ETSI

---------------------- Page: 4 ----------------------

SIST EN 300 392-1 V1.3.1:2006
 3 ETSI EN 300 392-1 V1.3.1 (2005-06)
Contents
Intellectual Property Rights.12
Foreword.12
1 Scope.14
2 References.14
3 Definitions, symbols and abbreviations .16
3.1 Definitions.16
3.2 Symbols.21
3.3 Abbreviations.21
4 Circuit mode reference points .24
5 Packet mode reference points.24
6 Protocol architecture for V+D.24
7 Addressing and identities.24
7.1 Introduction.24
7.2 Subscriber identities.26
7.2.1 General.26
7.2.2 TSI.26
7.2.3 SSI.27
7.2.4 Composition of subscriber identities .28
7.2.5 Allocation principles for subscriber identities .28
7.2.6 Use of subscriber identities.29
7.2.7 NSAP addresses.29
7.2.8 Installation of TSIs.29
7.3 TETRA Management Identity (TMI).30
7.3.1 General.30
7.3.2 Composition of management identities.30
7.3.3 Use of management identities.30
7.4 Network layer SAP (NSAP) addresses.31
7.4.1 General.31
7.4.2 Static binding.31
7.4.3 Dynamic binding.31
7.4.3.1 General.31
7.4.3.2 Structure and contents of NSAP addresses .31
7.4.3.3 Use of NSAP addresses.31
7.4.3.4 Binding of NSAP addresses .31
7.5 TETRA Equipment Identity (TEI) .32
7.5.1 General.32
7.5.2 Contents of TEI.32
7.5.3 Allocation principles for TEI.32
7.5.4 Use of TEI.32
7.6 Mobile Network Identity (MNI).33
7.6.1 Contents of MNI .33
7.7 Layer 2 addresses and labels .33
7.7.1 Overview.33
7.7.2 Event labelling.33
7.7.3 Scrambling labelling.33
7.7.4 Use and implementation of layer 2 addresses.34
7.7.4.1 General requirement.34
7.7.4.2 Implementation of event labels .34
7.7.4.3 Implementation of scrambling labels .34
7.7.5 Use of identities for V+D control channels .34
7.7.6 Labelling of packet channels .35
7.7.6.1 Use of identities for uplink data transfers .35
ETSI

---------------------- Page: 5 ----------------------

SIST EN 300 392-1 V1.3.1:2006
 4 ETSI EN 300 392-1 V1.3.1 (2005-06)
7.7.6.2 Use of identities for downlink data transfers.35
7.7.7 System information broadcast.36
7.7.8 Reserved value of group address for user information broadcast .36
7.8 Use of individual addresses.36
7.8.1 Air interface addressing functions .36
7.8.2 Address placement in primitives and PDUs .36
7.8.2.1 Use of ISSI at layer 2 .36
7.8.2.2 Use of ITSI/ISSI at layer 3.38
7.8.2.2.1 Void.38
7.8.2.2.2 Use of ITSI/ISSI by CMCE.38
7.8.3 Routing principles.39
7.8.3.1 Routing of intra-TETRA calls (within one TETRA network) .39
7.8.3.2 Routing of inter-TETRA calls (between two TETRA networks).39
7.8.3.3 Routing of external calls (to/from non-TETRA networks) .40
7.8.4 Address and identity comparison.40
7.9 Addressing in interworking and roaming with other telecommunication networks .40
8 Circuit mode basic services.40
9 Mobility Management (MM) in MS .41
10 MLE mobility scenarios and functionalities.41
11 Technical realization of SDS.41
12 Void.41
13 Void.41
14 General on supplementary services.41
Annex A (informative): Circuit mode reference points.42
A.1 Introduction.42
A.2 Reference configuration.42
A.2.1 Configuration examples of TETRA LMNs .43
A.3 TETRA LMN access.44
A.3.1 MS access.44
A.3.1.1 MS functional groups.44
A.3.1.2 MS access points and reference points .44
A.3.2 Void.45
A.3.3 Inter System Interface (ISI) access.45
A.3.4 Location of TETRA functionality .45
A.3.5 TETRA terminals.45
Annex B (informative): Protocol architecture for V+D .46
B.1 Introduction.46
B.2 Mobile/base protocol architecture.46
B.2.1 Overview.46
B.2.2 Air interface layer 1.46
B.2.3 Air interface layer 2.47
B.2.3.1 Medium Access Control (MAC).47
B.2.3.2 Logical Link Control (LLC) .49
B.2.4 Air interface layer 3.49
B.2.4.1 Mobile/Base Link control Entity (MLE/BLE).49
B.2.4.2 Sub-Network Access Functions (SNAF) .50
B.2.4.2.1 Mobility Management (MM) .50
B.2.4.2.2 Circuit Mode Control Entity (CMCE).50
B.2.4.2.3 Packet data handling .51
B.2.4.2.4 TETRA packet data protocol (PDP).51
B.2.4.2.5 Void.51
B.2.5 Mobile/base protocol stack.51
ETSI

---------------------- Page: 6 ----------------------

SIST EN 300 392-1 V1.3.1:2006
 5 ETSI EN 300 392-1 V1.3.1 (2005-06)
B.3 Lower Layer Management Entity (LLME) and other layers interaction.52
B.3.1 General description.52
Annex C (informative): Overview of circuit mode basic services .53
C.1 Introduction.53
C.2 Functional groupings in circuit switched mode calls .53
C.2.1 Circuit switched call control, C-plane .53
C.2.2 Circuit switched call, user data, U-plane.53
C.3 Protocols.53
C.3.1 TNP1.53
C.3.2 Void.53
C.3.3 TNP3.53
C.3.4 TNP4.54
C.3.5 AI1.54
C.3.6 AI2.54
C.3.7 TLC1.54
C.3.8 V.24T.54
C.4 Example configuration.54
C.4.1 MS to MS .54
C.4.2 Void.55
C.4.3 Void.55
C.4.4 MS to MS over ISI .55
Annex D (informative): Individual circuit mode call scenarios.57
D.1 Introduction.57
D.2 Procedures - message trunked systems .57
D.2.1 Call set-up - on/off hook signalling.57
D.2.1.1 Call set-up - on/off hook signalling flow.57
D.2.1.2 Traffic channel assignment.58
D.2.2 Call set-up - direct set-up signalling.58
D.2.2.1 Call set-up - direct set-up signalling flow.58
D.2.2.2 Traffic channel assignment.59
D.2.3 Request-to-transmit.60
D.2.4 Response to request-to-transmit .61
D.2.5 Permission to transmit withdrawn .61
D.2.6 Permission to continue with withdrawn call.61
D.2.7 End of transmission.61
D.2.8 Stop-transmission order.61
D.2.9 Call clearing.62
D.2.9.1 Mobile originated.62
D.2.9.2 SwMI originated.63
D.3 Procedures - transmission trunked systems.63
D.3.1 Call set-up - on/off hook signalling.63
D.3.1.1 Call set-up - on/off hook signalling flow.63
D.3.1.2 Traffic assignment.64
D.3.2 Call set-up - direct set-up signalling.64
D.3.2.1 Call set-up - direct set-up signalling flow.64
D.3.2.2 Traffic channel assignment.65
D.3.3 Request-to-transmit.65
D.3.4 Response to request-to-transmit .66
D.3.5 Permission to transmit withdrawn .67
D.3.6 Permission to continue with withdrawn call.67
D.3.7 End of transmission.67
D.3.8 Stop-transmission order.67
D.3.9 Call clearing.67
D.3.9.1 Mobile originated.67
D.3.9.2 SwMI originated.68
ETSI

---------------------- Page: 7 ----------------------

SIST EN 300 392-1 V1.3.1:2006
 6 ETSI EN 300 392-1 V1.3.1 (2005-06)
D.4 Procedures - quasi-transmission trunked systems .69
D.4.1 Call set-up - on/off hook signalling.69
D.4.1.1 Call set-up - on/off hook signalling flow.69
D.4.1.2 Traffic assignment.70
D.4.2 Call set-up - direct set-up signalling.70
D.4.2.1 Call set-up - direct set-up signalling flow.70
D.4.2.2 Traffic assignment.71
D.4.3 Request-to-transmit.72
D.4.4 Response to request-to-transmit .73
D.4.5 Permission to transmit withdrawn .73
D.
...