EN IEC 61375-2-6:2018
(Main)Electronic railway equipment - Train communication network (TCN) - Part 2-6: On-board to ground communication
Electronic railway equipment - Train communication network (TCN) - Part 2-6: On-board to ground communication
IEC 61375-2-6:2018 establishes the specification for the communication between the on-board subsystems and the ground subsystems. The communication system, interfaces and protocols are specified as a mobile communication function, using any available wireless technology. This document provides requirements in order to: a) select the wireless network on the basis of QoS parameters requested by the application; b) allow TCMS and/or OMTS applications, installed on-board and communicating on the on-board communication network, to have a remote access to applications running on ground installations; c) allow applications running on ground installations to have a remote access to the TCMS and/or OMTS applications installed on-board.
Elektronische Betriebsmittel für Bahnen - Zug-Kommunikations-Netzwerk (TCN) - Teil 2-6: Kommunikation vom Zug zur Landseite
Matériel électronique ferroviaire - Réseau embarqué de train (TCN) - Partie 2-6: Communication train-sol
L'IEC 61375-2-6:2018 couvre la spécification pour la communication entre les sous-systèmes embarqués et les sous-systèmes au sol. Le système, les interfaces et les protocoles de communication sont spécifiés comme une fonction de communication mobile, utilisant toute technologie radio disponible. Le présent document spécifie des exigences pour: a) sélectionner le réseau radio sur la base des paramètres de Qualité de Service (QoS) requis par l'application; b) permettre aux applications du système de contrôle et de gestion de train (TCMS) et/ou du sous-système multimédia et télématique embarqué (OMTS), installées à bord du train et communiquant sur le réseau de communication embarqué, d'avoir un accès à distance aux applications s'exécutant au sol; c) permettre aux applications s'exécutant au sol d'avoir un accès à distance aux applications TCMS et/ou OMTS embarquées.
Železniške elektronske naprave - Komunikacijsko omrežje vlaka - 2-6. del: Komunikacija vlak-tla
Ta del IEC 61375 določa specifikacije za komunikacijo med podsistemi na krovu in podsistemi na tleh.
Komunikacijski sistem, vmesniki in protokoli so določeni kot funkcija mobilne komunikacije z uporabo katere koli razpoložljive brezžične tehnologije.
Ta dokument vsebuje zahteve, potrebne za:
a) izbiro brezžičnega omrežja na podlagi parametrov QoS, ki jih zahteva aplikacija;
b) to, da imajo aplikacije TCMS in/ali OMTS, ki so nameščene na krovu in komunicirajo v komunikacijskem omrežju na krovu, oddaljeni dostop do aplikacij, ki delujejo v sistemih na tleh;
c) to, da imajo aplikacije, ki delujejo v sistemih na tleh, oddaljeni dostop do aplikacij TCMS in/ali OMTS, nameščenih na krovu.
Ta dokument določa dodatne zahteve, ki omogočajo, da se aplikacije, ki se izvajajo na krovu, in aplikacije, ki delujejo na tleh, povezujejo med seboj prek navideznega/funkcionalnega mehanizma za naslavljanje, ki ga določa IEC 61375-2-3, ter izmenjujejo nabore podatkov aplikacij, ki jih proizvajajo ali porabljajo funkcije na krovu nameščenih naprav, povezanih z omrežjem TCN.
Poleg tega ta dokument zajema varnostne zahteve, ki omogočajo dostop samo overjenim in pooblaščenim aplikacijam ter omogočajo šifriranje izmenjanih podatkov.
Komunikacija podatkov, povezanih z varnostjo, med aplikacijami na krovu in aplikacijami na tleh ter storitev internetne povezave za potnike ne spadata na področje uporabe tega mednarodnega standarda.
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN IEC 61375-2-6:2019
01-september-2019
Železniške elektronske naprave - Komunikacijsko omrežje vlaka - 2-6. del:
Komunikacija vlak-tla
Electronic railway equipment - Train communication network - Part 2-6: On-board to
ground communication
Ta slovenski standard je istoveten z: EN IEC 61375-2-6:2018
ICS:
35.240.60 Uporabniške rešitve IT v IT applications in transport
prometu
45.060.01 Železniška vozila na splošno Railway rolling stock in
general
SIST EN IEC 61375-2-6:2019 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN IEC 61375-2-6:2019
---------------------- Page: 2 ----------------------
SIST EN IEC 61375-2-6:2019
EUROPEAN STANDARD EN IEC 61375-2-6
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2018
ICS 45.060.01
English Version
Electronic railway equipment - Train communication network
(TCN) - Part 2-6: On-board to ground communication
(IEC 61375-2-6:2018)
Matériel électronique ferroviaire - Réseau embarqué de Elektronische Betriebsmittel für Bahnen - Zug-
train (TCN) - Partie 2-6: Communication train-sol Kommunikations-Netzwerk (TCN) - Teil 2-6: Kommunikation
(IEC 61375-2-6:2018) vom Zug zur Landseite
(IEC 61375-2-6:2018)
This European Standard was approved by CENELEC on 2018-06-18. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden,
Switzerland, Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 61375-2-6:2018 E
---------------------- Page: 3 ----------------------
SIST EN IEC 61375-2-6:2019
EN IEC 61375-2-6:2018 (E)
European foreword
The text of document 9/2374/FDIS, future edition 1 of IEC 61375-2-6, prepared by IEC/TC 9 "Electrical
equipment and systems for railways" was submitted to the IEC-CENELEC parallel vote and approved
by CENELEC as EN IEC 61375-2-6:2018.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2019-05-16
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2021-11-16
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CENELEC by the European Commission
and the European Free Trade Association, and supports essential requirements of EU Directive(s).
For the relationship with EU Directive(s) see informative Annex ZZ, which is an integral part of this
document.
Endorsement notice
The text of the International Standard IEC 61375-2-6:2018 was approved by CENELEC as a
European Standard without any modification.
2
---------------------- Page: 4 ----------------------
SIST EN IEC 61375-2-6:2019
EN IEC 61375-2-6:2018 (E)
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the relevant
EN/HD applies.
NOTE 2 Up-to-date information on the latest versions of th
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.