EN 16145:2012
(Main)Sanitary tapware - Extractable outlets for sink and basin mixers - General technical specification
Sanitary tapware - Extractable outlets for sink and basin mixers - General technical specification
This European Standard specifies:
- the dimensional, leaktightness, mechanical, hydraulic and acoustic characteristics with which extractable outlets with or without spray mode selector function need to comply;
- the procedures for testing these characteristics.
It applies to extractable outlets made from any material which is intended for equipping and supplementing sanitary tapware for sinks and wash-basins used for culinary or ablutionary purposes. Such extractable outlets shall only be connected downstream of the obturator of the tapware.
Extractable outlets with total closing device fitted after the obturator of the tapware are not covered by this standard. Such products will be tested in accordance with EN 200, EN 817, EN 1111, EN 1286 or EN 1287 (see [1], [2], [3], [5] and [6]).
The conditions of use and classification are specified in Table 1.
Sanitärarmaturen - Ausziehbare Ausläufe für Waschtisch- und Spülbeckenarmaturen - Allgemeine technische Spezifikation
Diese Europäische Norm legt Folgendes fest:
Maße und Dichtheit sowie mechanisches, hydraulisches und Geräuschverhalten, die/das ausziehbare Ablaufventile mit oder ohne Wahlfunktion der Art des Wasserstrahls aufweisen müssen;
die Verfahren zur Prüfung dieser Eigenschaften.
Die vorliegende Norm gilt unabhängig vom verwendeten Werkstoff für ausziehbare Ablaufventile, die als Ausrüstung und Ergänzung von Sanitärarmaturen für Wasch- und Spülbecken zur Verwendung in der Küche oder für die Körperhygiene vorgesehen sind. Derartige ausziehbare Ablaufventile dürfen nur nach dem Absperrorgan der Armatur angeschlossen werden.
Ausziehbare Ablaufventile mit einer nach dem Absperrorgan der Armatur angebrachten Vorrichtung zum vollständigen Verschließen werden von dieser Norm nicht abgedeckt. Derartige Produkte werden nach EN 200, EN 817, EN 1111, EN 1286 oder EN 1287 (siehe [1], [2], [3], [5] und [6]) geprüft.
Die Anwendungsbedingungen und die Klassifizierung sind in Tabelle 1 festgelegt.
Robinetterie sanitaire - Douchettes extractibles pour mitigeurs d'éviers et de lavabos - Spécifications techniques générales
La présente Norme européenne prescrit :
les caractéristiques dimensionnelles, d’étanchéité, de comportement mécanique, hydrauliques et acoustiques auxquelles doivent répondre les douchettes extractibles avec ou sans sélecteur de jet ;
les modes opératoires d’essai permettant de contrôler ces caractéristiques.
Elle s’applique aux douchettes extractibles constituées de tout matériau, destinées à équiper et à compléter les robinetteries sanitaires pour éviers et lavabos à usage culinaire ou pour l’hygiène corporelle. Ces douchettes extractibles doivent être connectées seulement à l’aval de l’obturateur de la robinetterie.
Les douchettes extractibles équipées d’un dispositif de fermeture totale raccordé après l’obturateur de la robinetterie ne sont pas couvertes par cette norme. Ces produits seront soumis à l’essai conformément à l’EN 200, l’EN 817, l’EN 1111, l’EN 1286 ou l’EN 1287 (voir [1], [2], [3], [5] et [6]).
Les conditions d’utilisation et la classification sont spécifiées dans le Tableau 1.
Sanitarne armature - Izvlečljivi priključki za armature umivalnikov in pomivalnih korit - Splošne tehnične specifikacije
Ta evropski standard določa: mere in tesnjenje ter mehanske, hidravlične in akustične značilnosti, ki jim morajo ustrezati izvlečljivi priključki z izbiralnikom z načinom pršenja ali brez; postopke za preskus teh lastnosti. Uporablja se za izvlečljive priključke iz katerih koli materialov, ki so namenjeni opremljanju in dopolnjevanju sanitarnih armatur za umivalnike in pomivalna korita, ki se uporabljajo v kuharske in čistilne namene. Take izvlečljive priključke je treba priključiti za tesnilom sanitarne armature. Izvlečljivi priključki s popolno zaporno napravo, ki so nameščeni za tesnilom sanitarne armature, niso zajeti v tem standardu. Ti izdelki morajo biti preskušeni v skladu s standardi EN 200, EN 817, EN 1111, EN 1286 ali EN 1287. Pogoji uporabe in klasifikacije so določeni v preglednici 1.
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Sanitärarmaturen - Ausziehbare Ausläufe für Waschtisch- und Spülbeckenarmaturen - Allgemeine technische SpezifikationRobinetterie sanitaire - Douchettes extractibles pour mitigeurs d'éviers et de lavabos - Spécifications techniques généralesSanitary tapware - Extractable outlets for sink and basin mixers - General technical specification91.140.70Sanitarne napraveSanitary installationsICS:Ta slovenski standard je istoveten z:EN 16145:2012SIST EN 16145:2013en,fr,de01-december-2013SIST EN 16145:2013SLOVENSKI
STANDARD
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 16145
December 2012 ICS 91.140.70 English Version
Sanitary tapware - Extractable outlets for sink and basin mixers -General technical specification
Robinetterie sanitaire - Douchettes extractibles pour mitigeurs d'éviers et de lavabos - Spécifications techniques générales
Sanitärarmaturen - Ausziehbare Ausläufe für Waschtisch- und Spülbeckenarmaturen - Allgemeine technische Spezifikation This European Standard was approved by CEN on 10 November 2012.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2012 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 16145:2012: ESIST EN 16145:2013
Pressure take-off tee . 25Bibliography . 28 SIST EN 16145:2013
This standard provides no information as to whether the product may be used without restriction in any of the Member States of the EU or EFTA. It should be noted that, while awaiting the adoption of verifiable European criteria, existing national regulations concerning the use and/or the characteristics of these products remain in force. This European Standard specifies requirements for shower outlets suitable for use in water supply systems of Type 1 and Type 2. SIST EN 16145:2013
system Operating range of extractable shower outlets Flow rate classes Acoustics Marking Limits Recommended
See Clause 13 See Clause 4 Type 1
see Figure 1
Dynamic Pressure
(0,05 to 0,5) MPa
((0,5 to 5,0) bar)
Dynamic Pressure
(0,1 to 0,3) MPa
((1,0 to 3,0) bar)
ZE (0,066 7 ≤ Q < 0,12) l/s ((4 ≤ Q < 7,2) l/min) Group I
for exampleI A
Z (0,12 ≤ Q < 0,15) l/s ((7,2 ≤ Q < 9) l/min) A (0,15 ≤ Q < 0,25) l/s ((9 ≤ Q < 15) l/min) S (0,25 ≤ Q < 0,33) l/s ((15 ≤ Q < 20) l/min) B (0,33 ≤ Q < 0,42) l/s ((20 ≤ Q < 25) l/min) C (0,42 ≤ Q < 0,50) l/s ((25 ≤ Q < 30) l/min) D (0,50 ≤ Q < 0,63) l/s ((30 ≤ Q < 38) l/min) Type 2
see Figure 2
Dynamic Pressure > (0,01 to 0,2) MPa ((0,1 to 2,0) bar)
Dynamic Pressure (0,02 to 0,1) MPa((0,2 to 1,0) bar) EE (0,025 ≤ Q < 0,06) l/s ((1,5 ≤ Q < 3,6) l/min) at 0,01 MPa (0,1 bar) (unclassified)
E (0,06 ≤ Q < 0,14) l/s ((3,6 ≤ Q < 8,4) l/min) at 0,01 MPa (0,1 bar) H (Q ≥ 0,14) l/s ((Q ≥ 8,4) l/min) at 0,01 MPa (0,1 bar) Temperature T < 70 °C T < 42 °C (wash-basin) T < 60 °C (sink)
For low pressure extractable outlets complying with this standard there are no acoustical requirements. Low pressure extractable outlets complying with this standard may also be used with inlet supply pressures in the range from 0,1 MPa to 0,2 MPa (1,0 bar to 2,0 bar) on condition that acoustical performance is not a requirement of the installation. SIST EN 16145:2013
Key 1 cold water 2 hot Water 3 mains supply pipe (supply pressures up to 1 MPa (10 bar))
4 water heater Figure 1 — Supply system type 1 with a pressure range of 0,05 MPa to 1,0 MPa (0,5 bar to 10 bar) SIST EN 16145:2013
Key 1 cold water storage cistern (cover omitted for clarity) 2 warning pipe 3 vent pipe 4 hot water cylinder
5 alternative cistern fed cold supply to sanitary appliances
6 to boiler 7 mains supply pipe (supply pressures up to 1 MPa (10 bar)) Figure 2 — Supply system type 2 with a pressure range of 0,01 MPa to 1,0 MPa (0,1 bar - 10 bar). A vented domestic hot water and cold water supply system incorporating gravity hot water, mains cold water and alternative gravity cold water supply to sanitary appliances SIST EN 16145:2013
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.