CEN/TS 17048:2024

SLOVENSKI STANDARD
01-maj-2024
Hidroizolacijski trakovi - Polimerni in elastomerni trakovi za hidroizolacijo
betonskih premostitvenih objektov in drugih betonskih prometnih površin -
Definicije in lastnosti
Flexible sheets for waterproofing - Plastic and rubber sheets for waterproofing of
concrete bridge decks and other trafficked areas of concrete - Definitions and
characteristics
Abdichtungsbahnen - Kunststoff- und Elastomerbahnen für Abdichtungen von
Betonbrücken und anderen Verkehrsflächen aus Beton - Definitionen und Eigenschaften
Feuilles souples d’étanchéité - Feuilles d’étanchéité de toiture plastiques et caoutchouc
de ponts et autre surface en béton circulables par les véhicules - Définitions et
caractéristiques
Ta slovenski standard je istoveten z: CEN/TS 17048:2024
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

CEN/TS 17048
TECHNICAL SPECIFICATION
SPÉCIFICATION TECHNIQUE
January 2024
TECHNISCHE SPEZIFIKATION
ICS 91.100.50
English Version
Flexible sheets for waterproofing - Plastic and rubber
sheets for waterproofing of concrete bridge decks and
other trafficked areas of concrete - Definitions and
characteristics
Feuilles souples d'étanchéité - Feuilles d'étanchéité de Abdichtungsbahnen - Kunstoff- und Elastomerbahnen
toiture plastiques et caoutchouc de ponts et autre für Abdichtungen von Betonbrücken und andere
surface en béton circulables par les véhicules - Verkehrsflächen aus Beton - Definition und
Définitions et caractéristiques Eigenschaften
This Technical Specification (CEN/TS) was approved by CEN on 10 December 2023 for provisional application.

The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to
submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard.

CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS
available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in
parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 17048:2024 E
worldwide for CEN national Members.

Contents Page
European foreword . 3
1 Scope . 4
2 Normative references . 4
3 Terms and definitions . 5
4 Product characteristics . 7
4.1 General . 7
4.2 Sheet characteristics . 7
4.2.1 Visible defects . 7
4.2.2 Dimensions, tolerances, and mass per unit area . 7
4.2.3 Tensile properties. 7
4.2.4 Water absorption . 8
4.2.5 Foldability at low temperature . 8
4.2.6 Flow resistance at elevated temperature . 8
4.2.7 Dimensional stability at elevated temperatures . 8
4.2.8 Artificial ageing behaviour . 8
4.3 Performance related characteristics . 9
4.3.1 General . 9
4.3.2 Bond strength . 9
4.3.3 Shear strength . 9
4.3.4 Crack bridging ability . 9
4.3.5 Compatibility by heat conditioning . 9
4.3.6 Resistance to compaction of an asphalt layer . 9
4.3.7 Behaviour of plastic and rubber sheets during application of mastic asphalt . 9
4.3.8 Bitumen compatibility .10
4.3.9 Watertightness .10
4.4 Dangerous substances .10
5 Test samples, testing and criteria .10
5.1 General .10
5.2 Test samples, testing and criteria .10
5.3 Test reports .12
6 Product data sheet .13
7 Marking, labelling, and packaging .13
Annex A (normative)  Determination of dimensional stability at 160 °C .14
A.1 General .14
A.2 Procedure.14
A.3 Precision of test method .14
A.4 Test report .14
Bibliography .15
European foreword
This document (CEN/TS 17048:2024) has been prepared by Technical Committee CEN/TC 254 “Flexible
sheets for waterproofing”, the secretariat of which is held by NEN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national standards body.
A complete listing of these bodies can be found on the CEN website.
According to the CEN/CENELEC Internal Regulations, the national standards organisations of the
following countries are bound to announce this Technical Specification: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and the
United Kingdom.
1 Scope
This document specifies characteristics and performances of plastic and rubber sheets for waterproofing
of concrete bridge decks and other concrete surfaces trafficable by vehicles where the waterproofing is
fully bonded to the concrete deck and fully bonded to the asphalt overlay.
This document does not cover concrete surfaces trafficable by vehicles where the waterproofing is not
fully bonded to the concrete and/or not fully bonded to an overlay.
This document also states the test methods used for verifying the characteristics and gives rules for the
assessment and verification of consistency of performance of the product.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
EN 495-5, Flexible sheets for waterproofing — Determination of foldability at low temperature — Part 5:
Plastic and rubber sheets for roof waterproofing
EN 1107-2, Flexible sheets for waterproofing — Determination of dimensional stability — Part 2: Plastic
and rubber sheets for roof waterproofing
EN 1110, Flexible sheets for waterproofing — Bitumen sheets for roof waterproofing — Determination of
flow resistance at elevated temperature
EN 1296, Flexible sheets for waterproofing — Bitumen, plastic and rubber sheets for roofing — Method of
artificial ageing by long term exposure to elevated temperature
EN 1548, Flexible sheets for waterproofing — Plastic and rubber sheets for roof waterproofing — Method
for exposure to bitumen
EN 1848-2, Flexible sheets for waterproofing — Determination of length, width, straightness and flatness
— Part 2: Plastic and rubber sheets for roof waterproofing
EN 1849-2, Flexible sheets for waterproofing — Determination of thickness and mass per unit area —
Part 2: Plastics and rubber sheets for roof waterproofing
EN 1850-2, Flexible sheets for waterproofing — Determination of visible defects — Part 2: Plastic and
rubber sheets for roof waterproofing
EN 12311-2, Flexible sheets for waterproofing — Determination of tensile properties — Part 2: Plastic and
rubber sheets for roof waterproofing
EN 13375, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Specimen preparation
EN 13416, Flexible sheets for waterproofing — Bitumen, plastic and rubber sheets for roof waterproofing
— Rules for sampling
EN 13596, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Determination of bond strength
EN 13653, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Determination of shear strength
EN 14223, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Determination of water absorption
EN 14224:2010, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other
concrete surfaces trafficable by vehicles — Determination of crack bridging ability
EN 14691, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Compatibility by heat conditioning
EN 14692:2017, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other
concrete surfaces trafficable by vehicles — Determination of the resistance to compaction of an asphalt layer
EN 14693, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Determination of the behaviour of waterproofing sheets during
application of mastic asphalt
EN 14694, Flexible sheets for waterproofing — Waterproofing of concrete bridge decks and other concrete
surfaces trafficable by vehicles — Determination of resistance to dynamic water pressure after damage by
pre-treatment
3 Terms and definitions
For the purposes of this document, the terms and definitions given in EN 13375 and EN 13416 and the
following apply.
3.1
waterproofing
action to protect the structure and
...