prEN 14695

SLOVENSKI STANDARD
01-januar-2018
+LGURL]RODFLMVNLWUDNRYL2MDþHQLELWXPHQVNLWUDNRYL]DWHVQMHQMHEHWRQVNLK
SUHPRVWLWYHQLKREMHNWRYLQGUXJLKEHWRQVNLKSRYR]QLKSRYUãLQ'HILQLFLMHLQ
ODVWQRVWL
Flexible sheets for waterproofing - Reinforced bitumen sheets for waterproofing of
concrete bridge decks and other trafficked areas of concrete - Definitions and
characteristics
Abdichtungsbahnen - Bitumenbahnen mit Trägereinlage für die Abdichtung von
Betonbrücken und anderen Verkehrsflächen aus Beton - Definitionen und Eigenschaften
Feuilles souples d'étanchéité - Feuilles bitumineuses armées pour l'étanchéité des
tabliers de ponts en béton et autres surfaces en béton circulables par les véhicules -
Définitions et caractéristiques
Ta slovenski standard je istoveten z: prEN 14695
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

DRAFT
EUROPEAN STANDARD
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2017
ICS 91.100.50 Will supersede EN 14695:2010
English Version
Flexible sheets for waterproofing - Reinforced bitumen
sheets for waterproofing of concrete bridge decks and
other trafficked areas of concrete - Definitions and
characteristics
Feuilles souples d'étanchéité - Feuilles bitumineuses Abdichtungsbahnen - Bitumenbahnen mit
armées pour l'étanchéité des tabliers de ponts en béton Trägereinlage für die Abdichtung von Betonbrücken
et autres surfaces en béton circulables par les véhicules und anderen Verkehrsflächen aus Beton - Definitionen
- Définitions et caractéristiques und Eigenschaften
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee
CEN/TC 254.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC
Management Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are
aware and to provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without
notice and shall not be referred to as a European Standard.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 14695:2017 E
worldwide for CEN national Members.

Contents Page
European foreword . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 6
4 Product characteristics . 8
4.1 General . 8
4.2 Sheet characteristics . 8
4.2.1 Visible defects . 8
4.2.2 Dimensions, tolerances and mass per unit area . 8
4.2.3 Initial amount of mineral surface protection . 9
4.2.4 Tensile properties. 9
4.2.5 Water absorption . 9
4.2.6 Flexibility at low temperature. 9
4.2.7 Flow resistance at elevated temperature . 9
4.2.8 Dimensional stability at elevated temperatures . 9
4.2.9 Artificial ageing behaviour . 10
4.3 Performance related characteristics . 10
4.3.1 General . 10
4.3.2 Bond strength . 10
4.3.3 Shear strength . 10
4.3.4 Crack bridging ability . 10
4.3.5 Compatibility by heat conditioning . 10
4.3.6 Resistance to compaction of an asphalt layer . 10
4.3.7 Behaviour of bitumen sheets during application of mastic asphalt . 11
4.3.8 Watertightness . 11
4.4 Dangerous substances . 11
5 Assessment and verification of constancy of performance - AVCP . 11
5.1 General . 11
5.2 Type testing . 11
5.2.1 General . 11
5.2.2 Test samples, testing and compliance criteria . 12
5.2.3 Test reports . 14
5.2.4 Shared other party results . 14
5.3 Factory production control (FPC) . 14
5.3.1 General . 14
5.3.2 Requirements . 15
5.3.3 Product specific requirements . 18
5.3.4 Initial inspection of factory and of FPC . 19
5.3.5 Continuous surveillance of FPC . 19
5.3.6 Procedure for modifications . 19
5.3.7 One-off products, pre-production products (e.g. prototypes) . 20
6 Product data sheet . 20
7 Marking, labelling and packaging . 21
Annex A (normative) Determination of dimensional stability at 160 °C . 22
A.1 General . 22
A.2 Procedure . 22
A.3 Precision of test method . 22
A.4 Test report . 22
Annex B (informative) Example of a product data sheet . 23
Annex C (normative) Determination of the initial amount of mineral surface protection . 25
C.1 General . 25
C.2 Apparatus and materials . 25
C.3 Procedure . 25
C.4 Calculations and expression of results . 25
C.5 Precision of the test method . 25
C.6 Test report . 25
Annex ZA (informative) Clauses of this European Standard addressing provisions of the EU
Construction Products Regulation . 26
ZA.1 Scope and relevant characteristics . 26
ZA.2 System of Assessment and Verification of Constancy of Performance (AVCP) . 27
ZA.3 Assignment of AVCP tasks . 27
Bibliography . 29

European foreword
This document (prEN 14695:2017) has been prepared by Technical Committee CEN/TC 254 “Flexible
sheets of waterproofing”, the secretariat of which is held by NEN.
This document is currently submitted to the CEN Enquiry.
This document will supersede EN 14695:2010.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association,
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
1 Scope
This European Standard specifies characteristics and performance of reinforced bitumen sheets for
waterproofing of concrete bridge decks and other tr
...