ASTM F3005-22
(Specification)Standard Specification for Batteries for Use in Small Unmanned Aircraft Systems (sUAS)
Standard Specification for Batteries for Use in Small Unmanned Aircraft Systems (sUAS)
ABSTRACT
This standard specifies the requirements for batteries used in small Unmanned Aircraft Systems (sUAS). It covers the standard terminology for sUAS as well as the requirements with respect to cells, mechanical design and assembly, electrical design, and maintenance of the pack and the recording of maintenance data.
SCOPE
1.1 This standard defines the requirements for batteries used in small Unmanned Aircraft Systems (sUAS).
1.2 This standard does not define requirements for the systems in which sUAS battery packs may be utilized.
1.3 This standard is subordinate to Specification F2910.
1.4 If allowed by a nation’s GAA, certain sUAS may be exempt from this standard and may use commercial off-the-shelf (COTS) batteries in non-safety-critical payloads (lithium chemistries may not be exempted). Air transport regulations still shall be adhered to when air transport is used for COTS cells or batteries in bulk.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
General Information
Buy Standard
Standards Content (Sample)
This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the
Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Designation: F3005 −22
Standard Specification for
Batteries for Use in Small Unmanned Aircraft Systems
1
(sUAS)
This standard is issued under the fixed designation F3005; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope 2.2 Other Standards:
ANSI/ASQ Z1.4-2008 Sampling Procedures and Tables for
1.1 Thisstandarddefinestherequirementsforbatteriesused
3
Inspection by Attributes
in small Unmanned Aircraft Systems (sUAS).
4
UL 1642 Standard for Lithium Batteries
1.2 This standard does not define requirements for the
systems in which sUAS battery packs may be utilized.
3. Terminology
1.3 This standard is subordinate to Specification F2910.
3.1 Unique and Common Terminology—Terminology used
1.4 If allowed by a nation’s GAA, certain sUAS may be
in multiple standards is defined in F3341/F3341M, UAS
exempt from this standard and may use commercial off-the-
Terminology Standard and F3060, Aircraft Terminology Stan-
shelf (COTS) batteries in non-safety-critical payloads (lithium
dard.Terminology that is unique to this specification is defined
chemistries may not be exempted). Air transport regulations
in this section.
still shall be adhered to when air transport is used for COTS
3.2 Definitions and Acronyms—The standard terminology
cells or batteries in bulk.
forsUASasdefinedinhigherlevelstandardsappliesingeneral
1.5 This standard does not purport to address all of the
to this standard except as noted below.
safety concerns, if any, associated with its use. It is the
3.3 Definitions of Terms Specific to This Standard:
responsibility of the user of this standard to establish appro-
3.3.1 C-rating, n—maximum steady-state current (amps) at
priate safety, health, and environmental practices and deter-
which the battery cell or pack may be discharged without
mine the applicability of regulatory limitations prior to use.
having pack temperature exceed the CTT of its constituent
1.6 This international standard was developed in accor-
cell(s) or result in a reduction in cell life. C-rating is expressed
dance with internationally recognized principles on standard-
as a multiple of the capacity. For example, a battery with a
ization established in the Decision on Principles for the
nominal capacity of 4Ah may have a C-rating of 5C, meaning
Development of International Standards, Guides and Recom-
that 20 A would be considered its maximum safe current.
mendations issued by the World Trade Organization Technical
Barriers to Trade (TBT) Committee.
3.3.2 characteristic thermal threshold, CTT, n—the tem-
perature beyond which a rechargeable battery cell of particular
2. Referenced Documents
chemistry and structure will exhibit permanent deterioration of
2
its critical performance parameters as evident upon subsequent
2.1 ASTM Standards:
charge/discharge cycles. Cell capacity and internal resistance
F2910 Specification for Design and Construction of a Small
are critical performance parameters. CTTis rated at both upper
Unmanned Aircraft System (sUAS)
and lower thresholds.
F3060 Terminology for Aircraft
F3341/F3341M Terminology for Unmanned Aircraft Sys-
3.3.3 depth of discharge, DOD, n—ratio of cell or pack
tems
capacity expended relative to its nominal capacity.
3.3.4 pack, n—a single cell or composition of battery cells
connected in series or in parallel or both plus monitoring
1
This specification is under the jurisdiction of ASTM Committee F38 on
electronics, structure, and connector(s).
UnmannedAircraftSystemsandisthedirectresponsibilityofSubcommitteeF38.01
on Airworthiness.
Current edition approved Oct. 1, 2022. Published December 2022. Originally
approved in 2014. Last previous edition approved in 2014 as F3005 – 14a. DOI:
3
10.1520/F3005-22. Available from American Society for Quality (ASQ), 600 N. Plankinton Ave.,
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or Milwaukee, WI 53203, http://www.asq.org.
4
contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Applicable only to 5.1 on cell suppliers.
Standards volume information, refer to the standard’s Document Summary page on Available from Underwriters Laboratories (UL), 2600 N.W. Lake Rd., Camas,
the ASTM website. WA 98607-8542, http://www.ul.com.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
F3005 − 22
3.3.5 pack assembler, n—that supplier whi
...
This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: F3005 − 14a F3005 − 22
Standard Specification for
Batteries for Use in Small Unmanned Aircraft Systems
1
(sUAS)
This standard is issued under the fixed designation F3005; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This standard defines the requirements for batteries used in small Unmanned Aircraft Systems (sUAS).
1.2 This standard does not define requirements for the systems in which sUAS battery packs may be utilized.
1.3 This standard is subordinate to Specification F2910.
1.4 If allowed by a nation’s GAA, certain sUAS may be exempt from this standard and may use commercial off-the-shelf (COTS)
batteries in non-safety-critical payloads (lithium chemistries may not be exempted). Air transport regulations still shall be adhered
to when air transport is used for COTS cells or batteries in bulk.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety safety, health, and healthenvironmental practices and determine the
applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization
established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued
by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents
2
2.1 ASTM Standards:
F2910 Specification for Design and Construction of a Small Unmanned Aircraft System (sUAS)
F3060 Terminology for Aircraft
F3341/F3341M Terminology for Unmanned Aircraft Systems
2.2 Other Standards:
3
ANSI/ASQ Z1.4-2008 Sampling Procedures and Tables for Inspection by Attributes
4
UL 1642 Standard for Lithium Batteries
1
This specification is under the jurisdiction of ASTM Committee F38 on Unmanned Aircraft Systems and is the direct responsibility of Subcommittee F38.01 on
Airworthiness.
Current edition approved June 1, 2014Oct. 1, 2022. Published July 2014December 2022. Originally approved in 2014. Last previous edition approved in 2014 as
F3005 – 14.F3005 – 14a. DOI: 10.1520/F3005-14A.10.1520/F3005-22.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards
volume information, refer to the standard’sstandard’s Document Summary page on the ASTM website.
3
Available from American Society for Quality (ASQ), 600 N. Plankinton Ave., Milwaukee, WI 53203, http://www.asq.org.
4
Applicable only to 5.1 on cell suppliers.
Available from Underwriters Laboratories (UL), 2600 N.W. Lake Rd., Camas, WA 98607-8542, http://www.ul.com.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1
---------------------- Page: 1 ----------------------
F3005 − 22
3. Terminology
3.1 Unique and Common Terminology—Terminology used in multiple standards is defined in F3341/F3341M, UAS Terminology
Standard and F3060, Aircraft Terminology Standard. Terminology that is unique to this specification is defined in this section.
3.2 Definitions and Acronyms—The standard terminology for sUAS as defined in higher level standards applies in general to this
standard except as noted below.
3.3 Definitions of Terms Specific to This Standard:
3.3.1 C-rating, n—maximum steady-state current (amps) at which the battery cell or pack may be discharged without having pack
temperature exceed the CTT of its constituent cell(s) or result in a reduction in cell life. C-rating is expressed as a multiple of the
capacity. For example, a battery with a nominal capacity of 4 Ah may have a C-rating of 5C, meaning that 20 A would be
considered its maximum safe current.
3.3.2 characteristic thermal threshold, CTT, n—the temperature beyond which a rechargeable battery cell of particular chemistry
and structure will exhibit permanent deterioration of its critical performance parameters as evident upon subsequent charge/
discharge cycles. Cell capacity and internal resistance are critical performance parameters. CTT is rated at both upper and lower
thresholds.
3.3.3 depth of discharge, DOD, n—ratio of cell or pack capacity expended relative to it
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.