Standard Guide for Analytical Testing of Substances of Very High Concern in Materials and Products

SIGNIFICANCE AND USE
5.1 The REACH Candidate list classifies substances as SVHCs thus making them subject to possible authorization. Compliance to the REACH regulation requires that any identified SVHC be present at a concentration of less than 0.1 % (w/w) of the total article weight to avoid triggering a reporting obligation. This guide is intended to assist in the identification of available test methods for quantitative analysis of the substance(s) of interest.  
5.2 When possible, industry accepted standard test methods are cited. However, industry vetted test methods are not available for all of the substances contained in the REACH Candidate List. Thus, some caution and due diligence must be exercised when applying some of the methods listed in this guide.  
5.3 In some cases, test methods for the identification and quantification of a specific substance are not available. An example would include CoCl2. Methods currently in practice involve the individual determination of Co and Cl concentrations and use other sources of information or chemical judgment to assign the expected CoCl2 concentration. This approach obviously has its limitations and pitfalls and must be used judiciously.  
5.4 Under the REACH regulation, EU manufacturers, importers or distributors of articles containing more than 0.1 % (w/w) of a substance that the Agency has listed as being an SVHC shall provide their customers with the name of the substance and information allowing the safe use of the article. Producers and distributors of articles containing SVHC shall also supply the same information to consumers, upon request. In situations where this information is not readily available from the supply chain it is incumbent upon the supplier to collect this information through actual chemical analysis or other means. This guide is intended to assist in the selection of appropriate test methods in the event that chemical analysis is required.
SCOPE
1.1 This guide contains a list of potential test methods for the analysis of Substances of Very High Concern (SVHC) as designated by ECHA, the European Chemicals Agency. Information on the test methods cited is publicly available and is drawn from a variety of sources. The guide is intended to assist in the selection of test methods that are applicable for the SVHCs identified.  
1.2 The specific SVHCs covered within this guide are compiled from the ECHA Candidate List of Substances of Very High Concern. This list is also referred to as the REACH Candidate List.  
1.3 This guide specifically addresses methods for the analysis of SVHCs in products. It is not intended to cover the many and varied analysis challenges associated in the manufacturing environment.  
1.4 Limitations:  
1.4.1 This guide is intended to provide a compilation of available test methods for the SVHCs listed on the ECHA Candidate list and is not intended to be exhaustive. The test methods within this guide are not the only ones available for any specific substances and this guide does not recommend any specific test method.  
1.4.2 Test methods for specific substances at the detection limits required for REACH reporting are not always available. In some cases, it is necessary to deduce the quantity of substance present through the analysis and quantification of its elements. Although this approach is routinely used some degree of uncertainty exists in the final result due to the reduced specificity of the test method.  
1.4.3 Although this guide is intended to be updated on a periodic basis to capture new developments in the field, there is no assurance that the information provided is the most current.  
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.  
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate...

General Information

Status
Historical
Publication Date
31-Jul-2017
Current Stage
Ref Project

Relations

Buy Standard

Guide
ASTM F2931-17 - Standard Guide for Analytical Testing of Substances of Very High Concern in Materials and Products
English language
112 pages
sale 15% off
Preview
sale 15% off
Preview
Guide
REDLINE ASTM F2931-17 - Standard Guide for Analytical Testing of Substances of Very High Concern in Materials and Products
English language
112 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: F2931 − 17
Standard Guide for
Analytical Testing of Substances of Very High Concern in
1
Materials and Products
This standard is issued under the fixed designation F2931; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope 1.5 The values stated in SI units are to be regarded as
standard. No other units of measurement are included in this
1.1 This guide contains a list of potential test methods for
standard.
the analysis of Substances of Very High Concern (SVHC) as
1.6 This standard does not purport to address all of the
designated by ECHA, the European Chemicals Agency. Infor-
safety concerns, if any, associated with its use. It is the
mation on the test methods cited is publicly available and is
responsibility of the user of this standard to establish appro-
drawnfromavarietyofsources.Theguideisintendedtoassist
priate safety, health and environmental practices and deter-
in the selection of test methods that are applicable for the
mine the applicability of regulatory limitations prior to use.
SVHCs identified.
1.7 This international standard was developed in accor-
1.2 The specific SVHCs covered within this guide are
dance with internationally recognized principles on standard-
compiledfromtheECHACandidateListofSubstancesofVery
ization established in the Decision on Principles for the
High Concern. This list is also referred to as the REACH
Development of International Standards, Guides and Recom-
Candidate List.
mendations issued by the World Trade Organization Technical
1.3 This guide specifically addresses methods for the analy-
Barriers to Trade (TBT) Committee.
sis of SVHCs in products. It is not intended to cover the many
and varied analysis challenges associated in the manufacturing 2. Referenced Documents
environment.
2
2.1 ASTM Standards:
1.4 Limitations: D1257 Specification for High-Gravity Glycerin
1.4.1 This guide is intended to provide a compilation of D1385 Test Method for Hydrazine in Water
D1971 Practices for Digestion of Water Samples for Deter-
available test methods for the SVHCs listed on the ECHA
Candidate list and is not intended to be exhaustive. The test minationofMetalsbyFlameAtomicAbsorption,Graphite
methods within this guide are not the only ones available for Furnace Atomic Absorption, Plasma Emission
anyspecificsubstancesandthisguidedoesnotrecommendany Spectroscopy, or Plasma Mass Spectrometry
specific test method. D3335 Test Method for Low Concentrations of Lead,
1.4.2 Test methods for specific substances at the detection Cadmium, and Cobalt in Paint by Atomic Absorption
Spectroscopy
limits required for REACH reporting are not always available.
In some cases, it is necessary to deduce the quantity of D3545 Test Method for Alcohol Content and Purity of
Acetate Esters by Gas Chromatography
substance present through the analysis and quantification of its
D4309 Practice for Sample Digestion Using Closed Vessel
elements. Although this approach is routinely used some
Microwave Heating Technique for the Determination of
degree of uncertainty exists in the final result due to the
Total Metals in Water
reduced specificity of the test method.
D5831 Test Method for Screening Fuels in Soils
1.4.3 Although this guide is intended to be updated on a
D7065 Test Method for Determination of Nonylphenol,
periodic basis to capture new developments in the field, there
Bisphenol A, p-tert-Octylphenol, Nonylphenol Monoeth-
is no assurance that the information provided is the most
oxylate and Nonylphenol Diethoxylate in Environmental
current.
Waters by Gas Chromatography Mass Spectrometry
D7485 Test Method for Determination of Nonylphenol,
1
This guide is under the jurisdiction of ASTM Committee F40 on Declarable
Substances in Materials and is the direct responsibility of Subcommittee F40.02 on
2
Management Practices and Guides. For referenced ASTM standards, visit the ASTM website, www.astm.org, or
Current edition approved Aug. 1, 2017. Published September 2017. Originally contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
ɛ1
approved in 2011. Last previous edition approved in 2016 as F2931 – 16 . DOI: Standardsvolume information, refer to the standard’s Document Summary page on
10.1520/F2931-17. the ASTM website.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
F2931 − 17
p-tert-Octylphenol, Nonylphenol Monoethoxylate and 3.2.5 plasticizer—any of a group of substances used in
Nonylphenol Diethoxylate in Environmental Waters by plastic
...

This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
´1
Designation: F2931 − 16 F2931 − 17
Standard Guide for
Analytical Testing of Substances of Very High Concern in
1
Materials and Products
This standard is issued under the fixed designation F2931; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1
ε NOTE—Keywords were added editorially in March 2017.
1. Scope
1.1 This guide contains a list of potential test methods for the analysis of Substances of Very High Concern (SVHC) as
designated by ECHA, the European Chemicals Agency. Information on the test methods cited is publicly available and is drawn
from a variety of sources. The guide is intended to assist in the selection of test methods that are applicable for the SVHCs
identified.
1.2 The specific SVHCs covered within this guide are compiled from the ECHA Candidate List of Substances of Very High
Concern. This list is also referred to as the REACH Candidate List.
1.3 This guide specifically addresses methods for the analysis of SVHCs in products. It is not intended to cover the many and
varied analysis challenges associated in the manufacturing environment.
1.4 Limitations:
1.4.1 This guide is intended to provide a compilation of available test methods for the SVHCs listed on the ECHA Candidate
list and is not intended to be exhaustive. The test methods within this guide are not the only ones available for any specific
substances and this guide does not recommend any specific test method.
1.4.2 Test methods for specific substances at the detection limits required for REACH reporting are not always available. In
some cases, it is necessary to deduce the quantity of substance present through the analysis and quantification of its elements.
Although this approach is routinely used some degree of uncertainty exists in the final result due to the reduced specificity of the
test method.
1.4.3 Although this guide is intended to be updated on a periodic basis to capture new developments in the field, there is no
assurance that the information provided is the most current.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety safety, health and healthenvironmental practices and determine the
applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization
established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued
by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents
2
2.1 ASTM Standards:
D1257 Specification for High-Gravity Glycerin
D1385 Test Method for Hydrazine in Water
D1971 Practices for Digestion of Water Samples for Determination of Metals by Flame Atomic Absorption, Graphite Furnace
Atomic Absorption, Plasma Emission Spectroscopy, or Plasma Mass Spectrometry
D3335 Test Method for Low Concentrations of Lead, Cadmium, and Cobalt in Paint by Atomic Absorption Spectroscopy
1
This guide is under the jurisdiction of ASTM Committee F40 on Declarable Substances in Materials and is the direct responsibility of Subcommittee F40.02 on
Management Practices and Guides.
Current edition approved July 1, 2016Aug. 1, 2017. Published August 2016September 2017. Originally approved in 2011. Last previous edition approved in 20152016
ɛ1
as F2931 – 15.F2931 – 16 . DOI: 10.1520/F2931-16E01.10.1520/F2931-17.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
Standardsvolume information, refer to the standard’s Document Summary page on the ASTM website.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
F2931 − 17
D3545 Test Method for Alcohol Content and Purity of Acetate Esters by Gas Chromatography
D4309 Practice for Sample Digestion Using Closed Vessel Microwave Heating Technique for the Determination of Total Metals
in Water
D5831 Test Method for Screening
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.