ECISS/TC 26 - Tinmill products - Qualities, dimensions, tolerances and specific tests
Standardization of flat thin steel products (< 0,5 mm thick) intended primarily for packaging (tinmill products), such as tinplate, electrolytic chromium/chromium oxide coated steel (ECCS) and blackplate, in coil or sheet form.
Pokositrena in črna pločevina - vrste, mere, tolerance in posebni načini preskušanja
Standardization of flat thin steel products (< 0,5 mm thick) intended primarily for packaging (tinmill products), such as tinplate, electrolytic chromium/chromium oxide coated steel (ECCS) and blackplate, in coil or sheet form.
General Information
This European Standard specifies requirements for tinmill products in the form of sheets or coils for subsequent cutting into sheets. Tinmill products consist of single and double reduced low carbon mild steel electrolytically coated with either tin (tinplate) or chromium/chromium oxide (ECCS). Single reduced tinmill products are specified in nominal thicknesses that are multiples of 0,005 mm from 0,17 mm up to and including 0,49 mm. Double reduced tinmill products are specified in nominal thicknesses that are multiples of 0,005 from 0,13 mm up to and including 0,29 mm.
- Standard48 pagesEnglish languagesale 10% offe-Library read for1 day
This draft European Standard specifies requirements for single and double cold reduced blackplate in the form of coils which are intended for manufacturing tinplate or ECCS in accordance with EN 10 202 or En 203. Single reduced blackplate is specified in nominal thicknesses that are multiples of 0,005 mm from 0,17 mm up to and including 0,49 mm. Double reduced blackplate is specified in nominal thicknesses that are multiples of 0,005 from 0,14 mm up to and including 0,29 mm. This standard applies to coils in nominal minimum widths of 600 mm either with trimmed or untrimmed edges.
- Standard17 pagesEnglish languagesale 10% offe-Library read for1 day
This draft European standard specifies requirements for single and double cold reduced low carbon mild steel electrolytic tinplate in the form of sheets or coils for subsequent cutting into sheets. Single reduced tinplate is specified in nominal thicknesses that are multiples of 0,005 mm from 0,17 up to and including 0,49 mm. Double reduced tinplate is specified in nominal thicknesses that are multiples of 0,005 form 0,14 mm up to and including 0,29 mm. This standard applies to coils and sheets cut from coils in nominal minimum widths of 600 mm.
- Standard35 pagesEnglish languagesale 10% offe-Library read for1 day
- Standard34 pagesEnglish languagesale 10% offe-Library read for1 day