SIST-TP CEN/TR 16349:2012

SLOVENSKI STANDARD
01-julij-2012
2NYLU]DVSHFLILNDFLMR]DSUHSUHþHYDQMHDONDOQRVLOLNDWQHUHDNFLMH$65YEHWRQX
Framework for a specification on the avoidance of a damaging Alkali-Silica Reaction
(ASR) in concrete
Rahmen für eine Spezifikation für die Vermeidung von Alkali-Siliciumdioxid-Reaktionen
in Beton
Cadre d'une spécification destinée à prévenir les dommages causés au béton par l'alcali-
réaction
Ta slovenski standard je istoveten z: CEN/TR 16349:2012
ICS:
91.100.30 Beton in betonski izdelki Concrete and concrete
products
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

TECHNICAL REPORT
CEN/TR 16349
RAPPORT TECHNIQUE
TECHNISCHER BERICHT
April 2012
ICS 91.100.30
English Version
Framework for a specification on the avoidance of a damaging
Alkali-Silica Reaction (ASR) in concrete
Cadre d'une spécification destinée à prévenir les Anwendung von Qualitätsregelkarten bei der Herstellung
dégradations causées au béton par l'alcali-réaction von Beton

This Technical Report was approved by CEN on 14 February 2012. It has been drawn up by the Technical Committee CEN/TC 104.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.

EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TR 16349:2012: E
worldwide for CEN national Members.

Contents Page
Foreword .3
Introduction .4
1 Scope .5
2 Alkali-Silica Reaction (ASR) .5
3 Elements of specifications .5
4 Characterisation of environment .5
5 Precautionary measures appropriate to concrete .6
5.1 General remarks.6
5.2 Use of cement with a low effective alkali content .7
5.3 Use of slag, fly ash, silica fume or other pozzolana (in cement or as an addition) .7
5.4 Limiting the effective alkali content of the concrete .7
5.5 Verification of the suitability of a concrete mix in a performance test .8
5.6 Use of a non-reactive aggregate combination .8
6 Summary .8
Bibliography .9

Foreword
This document (CEN/TR 16349:2012) has been prepared by Technical Committee CEN/TC 104 “Concrete
and related products”, the secretariat of which is held by DIN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
This Technical Report is partly based on the recommendation of RILEM TC ACS (Part 1 of AAR-7) [6].

Introduction
This Technical Report has been prepared by the Joint Working Group (JWG) on Alkali-Silica Reaction (ASR)
that was set up by the chairmen of CEN/TC 51, CEN/TC 104 and CEN/TC 154 and composed of
representatives from CEN/TC 51, CEN/TC 104, CEN/TC 154 and RILEM TC ACS.
The following is a list of the members of the JWG on ASR:
Name Represents
Michel Delort CEN/TC 51
Christer Ljungkrantz CEN/TC 51
Tom Harrison CEN/TC 104
Christoph Müller CEN/TC 104
Philip Nixon (until 2009) CEN/TC 154
Robert Gossling (from 2010) CEN/TC 154
Jean-Marc Vanbelle CEN/TC 154
Terje F. Ronning RILEM
Ingmar Borchers (VDZ) Guest
In CEN member countries, ASR has been recognised as a problem in concrete structures since the
1970s.Consequently, a number of countries have established provisions to avoid a damaging ASR. These
provisions are currently set out in national guidance documents and specifications.
Provisions vary in the different CEN member countries and depend on local experiences; some member
countries have not yet found the need to set up specifications.
The JWG was established to review the situation and to see whether it is possible to go further in providing
pragmatic and unified economic European specifications for the avoidance of a damaging ASR in concrete.
The JWG concluded that, unless there is any sound scientific explanation of a damaging ASR which can be
used uniformly all over Europe, it is premature to have harmonised classes for alkali-reactivity of aggregates
and provisions for avoiding a damaging ASR on a European level. Additionally, safety margins are determined
at national level and are related to the reliability at which a damaging ASR will not occur. Nevertheless, a
framework for the specification of the avoidance of a damaging ASR in concrete can be given.
1 Scope
This Technical Report gives guidance for avoiding a damaging Alkali-Silica Reaction (ASR) in concrete.
2 Alkali-Silica Reaction (ASR)
Alkali-Silica Reactions in concrete are a result of reaction between the alkaline pore solution in concrete and
reactive mineral species (as reactive silica and silicates) in the aggregate. The reaction leads to the formation
of a gel that can absorb water and exert an expansive force on the concrete. In certain conditions, these
reactions can lead to damaging expansions and cracking in the concrete. For such damaging expansion to
occur, all of the following conditions must be present simultaneously:
 a critical amount of reactive mineral species;
 a sufficiently high alkali hydroxide concentration in the pore solution;
 a sufficient supply of water.
Effective specifications to avoid damage from the reaction are based on ensuring that at least one of these
conditions is absent.
NOTE Another type of reaction between reactive mineral species in the aggregates and the alkaline pore solution,
which has been reported (e.g. from Canada and China), is the alkali-carbonate reaction. As alkali-carbonate reaction has
not been recognised as a significant problem in Europe, it is not covered by this Technical Report.
3 Elements of specifications
In order to promote the sustainable use of locally available materials, it is important to tailor the precautions to
the environment that the structure is exposed to as well as to local experience in building practice. Based on
these principles, specifications for avoiding a damaging ASR in concrete are given within the following
structure:
a) characterisation of the environment (environmental category):
1) degree of saturation of the concrete with water;
2) alkali supply;
3) further aggravating factors.
b) undertaking recommendations for precautionary measures appropriate to concrete, depending on the
environmental category.
4 Characterisation of environment
When all the necessary compositional factors are present, the likelihood and extent of damaging alkali-silica
reaction is dependent on the environment. Three levels of categorisation of environment are therefore
appropriate:
 E1: the concrete is essentially protected from extraneous moisture;
 E2: the concrete is exposed to extraneous moisture;
 E3: the concrete is exposed to extraneous moisture and additionally to aggravating factors, such as
de-icing agents, freezing and thawing (or wetting and drying in a marine environment) or fluctuating
loads.
More details on the factors affecting the environmental categorisation are given in Table 1.
Table 1 — Environmental categorie
...