SIST EN 300 444 V1.4.2:2003

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Digital Enhanced Cordless Telecommunications (DECT); Generic Access Profile (GAP)33.070.30'(&7Digital Enhanced Cordless Telecommunications (DECT)ICS:Ta slovenski standard je istoveten z:EN 300 444 Version 1.4.2SIST EN 300 444 V1.4.2:2003en01-december-2003SIST EN 300 444 V1.4.2:2003SLOVENSKI
STANDARD



SIST EN 300 444 V1.4.2:2003



ETSI EN 300 444 V1.4.2 (2003-02)European Standard (Telecommunications series) Digital Enhanced Cordless Telecommunications (DECT);Generic Access Profile (GAP)
SIST EN 300 444 V1.4.2:2003



ETSI ETSI EN 300 444 V1.4.2 (2003-02) 2
Reference REN/DECT-000219 Keywords access, DECT, generic, profile, radio, synchronization ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editor@etsi.org Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2003. All rights reserved.
DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. SIST EN 300 444 V1.4.2:2003



ETSI ETSI EN 300 444 V1.4.2 (2003-02) 3
Contents Intellectual Property Rights.9 Foreword.9 1 Scope.10 2 References.10 3 Definitions, symbols and abbreviations.11 3.1 Definitions.11 3.2 Symbols.13 3.3 Abbreviations.14 4 Feature definitions.15 4.1 Network (NWK) features.15 4.2 Application features.16 5 Service definitions.17 5.1 DLC service definitions.17 5.2 MAC service definitions.17 6 Inter-operability requirements.18 6.1 General.18 6.2 NWK features.19 6.3 DLC services.20 6.4 MAC services.20 6.5 Physical layer (PHL) services.20 6.6 Application features.21 6.7 NWK feature to procedure mapping.21 6.8 Service to procedure mapping.23 6.8.1 DLC service to procedure mapping.23 6.8.2 MAC service to procedure mapping.24 6.8.3 Application feature to procedure mapping.25 6.9 General requirements.25 6.9.1 NWK layer message contents.25 6.9.2 Transaction identifier.25 6.9.3 Length of a NWK layer message.25 6.9.4 Handling of error and exception conditions.25 6.9.5 GAP default setup attributes.26 6.9.6 Coexistence of MM and CC procedures.26 6.9.7 Coding rules for information elements.26 7 Procedure description.26 8 NWK layer procedures.27 8.1 Summary of outgoing call messages, normal cases.27 8.2 Outgoing call request.28 8.2.1 Associated procedures.29 8.2.1.1 Timer P- management.29 8.2.2 Exceptional cases.30 8.2.2.1 Timer P- expiry.30 8.2.2.2 PT releases the outgoing call request.30 8.2.2.3 FT rejects the outgoing call request.31 8.3 Overlap sending.31 8.3.1 Associated procedure.32 8.3.1.1 Timer F- management.32 8.3.2 Exceptional cases.32 8.3.2.1 PT releases the outgoing call request.32 8.3.2.2 FT rejects the outgoing call request.32 8.3.2.3 Timer F- expiry.33 SIST EN 300 444 V1.4.2:2003



ETSI ETSI EN 300 444 V1.4.2 (2003-02) 4
8.3.2.4 FT releases the outgoing call request.33 8.4 Outgoing call proceeding.34 8.4.1 Exceptional cases.34 8.4.1.1 PT releases the outgoing call request.34 8.4.1.2 FT releases the outgoing call request.35 8.5 Outgoing call confirmation.35 8.5.1 Exceptional cases.36 8.5.1.1 PT releases the outgoing call request.36 8.5.1.2 FT releases the outgoing call request.36 8.6 Outgoing call connection.37 8.7 Normal call release.37 8.7.1 Associated procedures.38 8.7.1.1 Timer P- management.38 8.7.1.2 Timer F- management.38 8.7.2 Exceptional cases.39 8.7.2.1 Release collisions.39 8.7.2.2 Timer F- expiry.39 8.7.2.3 Timer P- expiry.40 8.8 Abnormal call release.40 8.9 Partial release.41 8.10 Sending keypad information.42 8.11 Summary of incoming call related messages, normal cases.43 8.12 Incoming call request.43 8.12.1 Associated procedure.44 8.12.1.1 Timer F- management.44 8.12.2 Exceptional cases.45 8.12.2.1 FT releases the incoming call request.45 8.12.2.2 PT rejects the incoming call request.45 8.12.2.3 Timer F- expiry.46 8.12.3 Collective and group ringing.46 8.13 Incoming call confirmation.46 8.13.1 Exceptional cases.47 8.13.1.1 FT releases the incoming call transaction.47 8.13.1.2 PT releases the incoming call transaction.47 8.14 PT alerting.48 8.15 Incoming call connection.48 8.15.1 Associated procedure.49 8.15.1.1 Timer P- management.49 8.15.2 Exceptional cases.49 8.15.2.1 FT releases the incoming call transaction.49 8.15.2.2 PT releases the incoming call transaction.50 8.15.2.3 Timer P- expiry.50 8.16 Display.50 8.17 Terminal capability indication.51 8.18 Internal call setup.52 8.19 Internal call keypad.52 8.20 Service call setup.53 8.21 Service call keypad.53 8.22 Identification of PP.53 8.22.1 Associated procedure.54 8.22.1.1 Timer F- management.54 8.22.2 Exceptional cases.54 8.22.2.1 Identity not existing in the PT.54 8.22.2.2 Timer F- expiry.54 8.23 Authentication of FT.55 8.23.1 Associated procedure.55 8.23.1.1 Timer P- management.55 8.23.2 Exceptional cases.56 8.23.2.1 Authentication algorithm/key not supported.56 8.23.2.2 Authentication challenge RES has wrong value.56 8.23.2.3 Timer P- expiry.56 8.24 Authentication of PP.57 SIST EN 300 444 V1.4.2:2003



ETSI ETSI EN 300 444 V1.4.2 (2003-02) 5
8.24.1 Associated procedure.58 8.24.1.1 Timer F- management.58 8.24.2 Exceptional cases.58 8.24.2.1 Authentication algorithm/key not supported.58 8.24.2.2 Timer F- expiry.58 8.25 Authentication of user.58 8.25.1 Associated procedure.59 8.25.1.1 Timer F- management.59 8.25.2 Exceptional cases.59 8.25.2.1 Authentication algorithm/key not supported.59 8.25.2.2 Timer F- expiry.59 8.26 Incrementing the ZAP value.59 8.27 Storing the DCK.60 8.28 Location registration.60 8.28.1 Associated procedures.62 8.28.1.1 Timer P- management.62 8.28.1.2 Timer F- management.62 8.28.2 Exceptional cases.62 8.28.2.1 FT rejects the location registration procedure.62 8.28.2.2 Failure of location registration procedure.63 8.28.2.3 PT rejects the identity assignment.63 8.28.2.4 Timer F- expiry.63 8.29 Location update.64 8.30 Obtaining access rights.65 8.30.1 Associated procedure.67 8.30.1.1 Timer P- management.67 8.30.2 Exceptional cases.67 8.30.2.1 FT rejects the access rights.67 8.30.2.2 Timer P- expiry.67 8.31 FT terminating access rights.68 8.31.1 Associated procedure.69 8.31.1.1 Timer F- management.69 8.31.2 Exceptional cases.69 8.31.2.1 PT rejects the termination request.69 8.31.2.2 Timer F- expiry.69 8.32 Key allocation.69 8.32.1 Associated procedures.71 8.32.1.1 Timer F- management.71 8.32.1.2 Timer P- management.71 8.32.2 Exceptional cases.71 8.32.2.1 Timer F- expiry.71 8.32.2.2 Timer P- expiry.71 8.32.2.3 Allocation-type element is unacceptable.71 8.32.2.4 Authentication of PT fails.72 8.32.2.5 Authentication of FT fails.72 8.33 Cipher-switching initiated by FT.72 8.33.1 Associated procedure.73 8.33.1.1 Timer F- management.73 8.33.2 Exceptional cases.74 8.33.2.1 PT rejects the cipher request.74 8.33.2.2 Timer F- expiry.74 8.34 Cipher-switching initiated by PT.75 8.34.1 Associated procedure.76 8.34.1.1 Timer P- management.76 8.34.2 Exceptional cases.76 8.34.2.1 FT rejects the cipher request.76 8.34.2.2 Timer P- expiry.76 8.35 Indirect FT initiated link establishment.76 8.35.1 Associated procedure.77 8.35.1.1 Timer F- management.77 8.35.2 Exceptional cases.78 8.35.2.1 The IPUI received in the {LCE-PAGE-RESPONSE} does not match.78 SIST EN 300 444 V1.4.2:2003



ETSI ETSI EN 300 444 V1.4.2 (2003-02) 6
8.35.2.2 Timer expiry.78 8.35.2.3 Release from the higher entity.
...