SIST EN 933-5:1999/A1:2005
(Amendment)Tests for geometrical properties of aggregates - Part 5: Determination of percentage of crushed and broken surfaces in coarse aggregate particles
Tests for geometrical properties of aggregates - Part 5: Determination of percentage of crushed and broken surfaces in coarse aggregate particles
1 Modification in clause 1 Scope
Amend the existing "NOTE" to read "NOTE 1" and add the following "NOTE 2":
"NOTE 2 For coarse aggregate between 4 mm and 20 mm the percentage of crushed or broken surfaces is linked to the flow coefficient and can therefore be used in association with the test method specified in EN 933-6."
Prüfverfahren für geometrische Eigenschaften von Gesteinskörnungen - Teil 5: Bestimmung des Anteils an gebrochenen Körnern in groben Gesteinskörnungen
Essais pour déterminer les propriétés géométriques des granulats - Partie 5: Détermination du pourcentage de surfaces cassées dans les gravillons
Preskusi geometričnih lastnosti agregatov - 5. del: Določevanje odstotka lomljenih površin zrn grobega agregata
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 933-5:1999/A1:2005
01-februar-2005
3UHVNXVLJHRPHWULþQLKODVWQRVWLDJUHJDWRYGHO'RORþHYDQMHRGVWRWNDORPOMHQLK
SRYUãLQ]UQJUREHJDDJUHJDWD
Tests for geometrical properties of aggregates - Part 5: Determination of percentage of
crushed and broken surfaces in coarse aggregate particles
Prüfverfahren für geometrische Eigenschaften von Gesteinskörnungen - Teil 5:
Bestimmung des Anteils an gebrochenen Körnern in groben Gesteinskörnungen
Essais pour déterminer les propriétés géométriques des granulats - Partie 5:
Détermination du pourcentage de surfaces cassées dans les gravillons
Ta slovenski standard je istoveten z: EN 933-5:1998/A1:2004
ICS:
91.100.15 Mineralni materiali in izdelki Mineral materials and
products
SIST EN 933-5:1999/A1:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 933-5:1999/A1:2005
---------------------- Page: 2 ----------------------
SIST EN 933-5:1999/A1:2005
EUROPEAN STANDARD
EN 933-5:1998/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2004
ICS 91.100.15
English version
Tests for geometrical properties of aggregates - Part 5:
Determination of percentage of crushed and broken surfaces in
coarse aggregate particles
Essais pour déterminer les propriétés géométriques des Prüfverfahren für geometrische Eigenschaften von
granulats - Partie 5: Détermination du pourcentage de Gesteinskörnungen - Teil 5: Bestimmung des Anteils an
surfaces cassées dans les gravillons gebrochenen Körnern in groben Gesteinskörnungen
This amendment A1 modifies the European Standard EN 933-5:1998; it was approved by CEN on 16 September 2004.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Central Secretariat or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
CEN members are the national stan
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.