SIST EN 60335-2-41:1997/A1:2002

SLOVENSKI STANDARD
SIST EN 60335-2-41:1997/A1:2002
01-maj-2002
Varnost gospodinjskih in podobnih električnih aparatov - 2-41. del: Posebne
zahteve za črpalke za tekočine, katerih temperatura ni višja od 35 °C (IEC 60335-2-
41:1996/A1:2000)
Safety of household and similar electrical appliances -- Part 2-41: Particular
requirements for pumps
Sicherheit elektrischer Geräte für den Hausgebrauch und ähnliche Zwecke -- Teil 2-41:
Besondere Anforderungen für Pumpen
Sécurité des appareils électrodomestiques et analogues -- Partie 2-41: Règles
particulières pour les pompes
Ta slovenski standard je istoveten z: EN 60335-2-41:1996/A1:2001
ICS:
13.120 Varnost na domu Domestic safety
23.080 Črpalke Pumps
SIST EN 60335-2-41:1997/A1:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN 60335-2-41:1997/A1:2002

---------------------- Page: 2 ----------------------
SIST EN 60335-2-41:1997/A1:2002
EUROPEAN STANDARD EN 60335-2-41/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM July 2001
ICS 13.120;23.080;97.180
English version
Safety of household and similar electrical appliances
Part 2-41: Particular requirements for pumps
(IEC 60335-2-41:1996/A1:2000)
Sécurité des appareils Sicherheit elektrischer Geräte für den
électrodomestiques et analogues Hausgebrauch und ähnliche Zwecke
Partie 2-41: Règles particulières pour Teil 2-41: Besondere Anforderungen
les pompes für Pumpen
(CEI 60335-2-41:1996/A1:2000) (IEC 60335-2-41:1996/A1:2000)
This amendment A1 modifies the European Standard EN 60335-2-41:1996; it was approved by
CENELEC on 2001-06-01. CENELEC members are bound to comply with the CEN/CENELEC Internal
Regulations which stipulate the conditions for giving this amendment the status of a national standard without
any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This amendment exists in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CENELEC member into its own language and notified to the
Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway,
Portugal, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2001 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60335-2-41:1996/A1:2001 E

---------------------- Page: 3 ----------------------
SIST EN 60335-2-41:1997/A1:2002
EN 60335-2-41:1996/A1:2001 - 2 -
Foreword
The text of amendment 1:2000 to the International Standard IEC 60335-2-41:1996, prepared by the IEC
Technical Committee 61, was submitted to the Unique Acceptance Procedure and was approved by
CENELEC as amendment A1 to EN 60335-2-41:1996 on 2001-06-01.
The following dates are applicable:
- latest date by which the amendment has to be
 implemented at national level by publication of an
 identical national standard or by endorsement(dop) 2002-08-01
- date on which national standards conflicting
 with the amendment have to be withdrawn (dow) 2004-08-01
This amendment supplements or modifies the corresponding clauses of EN 60335-2-41:1996.
There are no special national conditions causing a deviation from this amendment.
There are no national deviations from this amendment.
p NOTE  In this document, p is used in the margin to indicate instructions for preparing the printed version.
_____________
Introduction
An investigation by CENELEC TC 61 has shown that all risks from products within the scope of this
standard are fully covered by the Low Voltage Directive, 73/23/EEC. If the product has mechanical
moving parts, a risk assessment in accordance with the Machinery Directive, 89/392/EEC, has shown
that the risks are mainly of electrical origin and consequently this directive is not applicable. However,
the relevant essential safety requir
...