SIST EN 61280-1-1:2013

SLOVENSKI STANDARD
01-oktober-2013
1DGRPHãþD
SIST EN 61280-1-1:1999
2VQRYQLSUHVNXVQLSRVWRSNL]DRSWLþQHNRPXQLNDFLMVNHSRGVLVWHPHGHO
3UHVNXVQLSRVWRSNL]DVSORãQHNRPXQLNDFLMVNHSRGVLVWHPH0HULWHYRSWLþQHPRþL
QDL]KRGXRGGDMQLND]DHQRURGQLRSWLþQLNDEHO
Fibre optic communication subsystem basic test procedures - Part 1-1: Test procedures
for general communication subsystems - Transmitter output optical power measurement
for single-mode optical fibre cable
Procédures d'essai de base des sous-systèmes de télécommunication à fibres optiques -
Partie 1-1: Procédures d'essai des sous-systèmes généraux de télécommunication -
Mesure de la puissance optique des émetteurs couplés à des câbles à fibres optiques
unimodales
Ta slovenski standard je istoveten z: EN 61280-1-1:2013
ICS:
33.180.01 6LVWHPL]RSWLþQLPLYODNQLQD Fibre optic systems in
VSORãQR general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 61280-1-1
NORME EUROPÉENNE
August 2013
EUROPÄISCHE NORM
ICS 33.180.01 Supersedes EN 61280-1-1:1998

English version
Fibre optic communication subsystem basic test procedures -
Part 1-1: Test procedures for general communication subsystems -
Transmitter output optical power measurement
for single-mode optical fibre cable
(IEC 61280-1-1:2013)
Procédures d'essai de base des sous- Lichtwellenleiter-
systèmes de télécommunication à fibres Kommunikationsuntersysteme -
optiques - Grundlegende Prüfverfahren -
Partie 1-1: Procédures d'essai des sous- Teil 1-1: Prüfverfahren für allgemeine
systèmes généraux de télécommunication Kommunikationsuntersysteme -
- Mesure de la puissance optique des Messung der Senderausgangsleistung für
émetteurs couplés à des câbles à fibres Einmoden-LWL-Kabel
optiques unimodales (IEC 61280-1-1:2013)
(CEI 61280-1-1:2013)
This European Standard was approved by CENELEC on 2013-06-25. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

CEN-CENELEC Management Centre: Avenue Marnix 17, B - 1000 Brussels

© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 61280-1-1:2013 E
Foreword
The text of document 86C/1065/CDV, future edition 2 of IEC 61280-1-1, prepared by SC 86C "Fibre
optic systems and active devices" of IEC/TC 86 "Fibre optics" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN 61280-1-1:2013.

The following dates are fixed:
(dop) 2014-03-25
• latest date by which the document has to be
implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2016-06-25
standards conflicting with the
document have to be withdrawn
This document supersedes EN 61280-1-1:1998.

EN 61280-1-1:1998:
- inclusion of Annex A on how to account for uncertainties;
- editorial corrections throughout the document and updates to references.

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.
Endorsement notice
The text of the International Standard IEC 61280-1-1:2013 was approved by CENELEC as a
European Standard without any modification.

- 3 - EN 61280-1-1:2013
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year
IEC 61300-3-35 - Fibre optic interconnecting devices and EN 61300-3-35 -
passive components - Basic test and
measurement procedures -
Part 3-35: Examinations and measurements
- Fibre optic connector endface visual and
automated inspection
IEC 61315 - Calibration of fibre-optic power meters EN 61315 -

IEC 61280-1-1 ®
Edition 2.0 2013-05
INTERNATIONAL
STANDARD
Fibre optic communication subsystem basic test procedures –

Part 1-1: Test procedures for general communication subsystems – Transmitter

output optical power measurement for single-mode optical fibre cable

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
PRICE CODE
J
ICS 33.180.01 ISBN 978-2-83220-803-8

– 2 – 61280-1-1 © IEC:2013(E)
CONTENTS
FOREWORD . 3
1 Scope and object . 5
2 Normative references . 5
3 Apparatus . 5
3.1 Optical power meter . 5
3.2 Input signal source . 5
3.3 Test cord . 5
3.4 Calibration . 6
4 Test sample . 6
5 Procedure . 6
6 Calculation . 7
7 Test results. 7
7.1 Required information . 7
7.2 Available information . 7
Annex A (informative) Taking into account uncertainties . 8
Bibliography . 9

Figure 1 – Transmitter output power measurement configuration . 6

61280-1-1 © IEC:2013(E) – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
FIBRE OPTIC COMMUNICATION SUBSYSTEM
BASIC TEST PROCEDURES –
Part 1-1: Test procedures for general communication subsystems –
Transmitter output optical power measurement
for single-mode optical fibre cable

FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by an
...