ISO/TS 21256-1:2020
(Main)Fine bubble technology — Cleaning applications — Part 1: Test method for cleaning salt (NaCl)-stained surfaces
Fine bubble technology — Cleaning applications — Part 1: Test method for cleaning salt (NaCl)-stained surfaces
This document describes the test method to evaluate the cleaning performance of ultrafine bubble water when used in high-pressure water jet to wash out salt-stained steel surfaces. The evaluation is carried out by measuring comparative removal of salt stain from the surface of a test plate with the ultrafine bubble water to that with control water.
Technologie des fines bulles — Applications de nettoyage — Partie 1: Méthode d’essai pour le nettoyage de surfaces dégradées par le sel (NaCl)
General Information
Standards Content (Sample)
TECHNICAL ISO/TS
SPECIFICATION 21256-1
First edition
2020-03
Fine bubble technology — Cleaning
applications —
Part 1:
Test method for cleaning salt (NaCl)-
stained surfaces
Technologie des fines bulles — Applications de nettoyage —
Partie 1: Méthode d’essai pour le nettoyage de surfaces dégradées par
le sel (NaCl)
Reference number
ISO/TS 21256-1:2020(E)
©
ISO 2020
---------------------- Page: 1 ----------------------
ISO/TS 21256-1:2020(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2020
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2020 – All rights reserved
---------------------- Page: 2 ----------------------
ISO/TS 21256-1:2020(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Principle of cleaning performance test. 1
5 Test apparatus for cleaning test . 2
5.1 High-pressure water jet . 2
5.1.1 Test conditions. 2
5.1.2 Characteristics of the high-pressure water jet . 2
5.2 Measuring instrument . 3
6 Salt-stained steel test plate for cleaning performance test . 3
7 Procedure. 3
7.1 General . 3
7.2 Measurement before cleaning the surface of the steel test plate . 3
7.3 Cleaning method of the surface of the steel test plate . 4
7.4 Measurement of salt stains after cleaning the surface of the steel test plate . 5
8 Calculation method of salt stain removal . 6
8.1 Calculation method of salt removal ratio . 6
8.2 Calculation method of salt removal quantity .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.