ISO 17992:2013
(Main)Iron ores — Determination of arsenic content — Hydride generation atomic absorption spectrometric method
Iron ores — Determination of arsenic content — Hydride generation atomic absorption spectrometric method
ISO 17992:2013 specifies a hydride generation atomic absorption spectrometric method for the determination of the arsenic content of iron ore. ISO 17992:2013 is applicable to mass fractions of arsenic between 0,000 66 % and 0,020 15 % in natural iron ores, iron ore concentrates and agglomerates, including sinter products.
Minerais de fer — Dosage de l'arsenic — Méthode par spectrométrie d'absorption atomique à génération d'hydrure
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 17992
First edition
2013-09-15
Iron ores — Determination of arsenic
content — Hydride generation atomic
absorption spectrometric method
Minerais de fer — Dosage de l’arsenic — Méthode par spectrométrie
d’absorption atomique à génération d’hydrure
Reference number
ISO 17992:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 17992:2013(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 17992:2013(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Principle . 1
4 Reagents . 1
5 Apparatus . 3
6 Sampling and samples . 4
6.1 Laboratory sample . 4
6.2 Preparation of predried test samples . 4
7 Procedure. 4
7.1 Number of determinations . 4
7.2 Test portion . 4
7.3 Blank test and check test . 4
7.4 Determination . 5
8 Expression of results . 7
8.1 Calculation of mass fraction of arsenic content . 7
8.2 General treatment of results . 7
8.3 Oxide factor .10
9 Test report .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.