ISO 12647-6:2012/Amd 1:2015

INTERNATIONAL ISO
STANDARD 12647-6
Second edition
2012-12-15
AMENDMENT 1
2015-10-01
Graphic technology — Process
control for the production of half-
tone colour separations, proofs and
production prints —
Part 6:
Flexographic printing
AMENDMENT 1
Technologie graphique — Contrôle des processus de confection de
sélections couleurs tramées, d’épreuves et de tirages —
Partie 6: Processus flexographique
AMENDEMENT 1
Reference number
ISO 12647-6:2012/Amd.1:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 12647-6:2012/Amd.1:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 12647-6:2012/Amd.1:2015(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the di
...