ISO 6855-3:2012
(Main)Mopeds — Measurement method for gaseous exhaust emissions and fuel consumption — Part 3: Fuel consumption measurement at a constant speed
Mopeds — Measurement method for gaseous exhaust emissions and fuel consumption — Part 3: Fuel consumption measurement at a constant speed
ISO 6855-3 specifies the methods of measurement for fuel consumption at a constant speed on the road and on the chassis dynamometer. It is applicable to mopeds as defined in ISO 3833 equipped with a spark ignition engine (four-stroke engine, two-stroke engine or rotary piston engine).
Cyclomoteurs — Méthode de mesure des émissions de gaz polluants et de consommation de combustible — Partie 3: Mesure de consommation de combustible à vitesse constante
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 6855-3
First edition
2012-09-15
Mopeds — Measurement method for
gaseous exhaust emissions and fuel
consumption —
Part 3:
Fuel consumption measurement at a
constant speed
Cyclomoteurs — Méthode de mesure des émissions de gaz polluants et
de consommation de combustible —
Partie 3: Mesure de consommation de combustible à vitesse constante
Reference number
ISO 6855-3:2012(E)
©
ISO 2012
---------------------- Page: 1 ----------------------
ISO 6855-3:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any
means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the
address below or ISO’s member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 6855-3:2012(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Symbols . 2
5 General requirements . 2
6 Road measurement method . 3
6.1 Rider and riding position . 3
6.2 Test track . 3
6.3 Ambient conditions for the road test . 3
6.4 Measuring instruments on the test moped for the road test . 4
6.5 Test method . 4
7 Chassis dynamometer measurement method . 5
7.1 Test method . 5
8 Presentation of results . 6
Annex A (normative) Determination method of fuel consumption . 7
Annex B (normative) Presentation of results of fuel consumption . 9
Bibliography .15
© ISO 2012 – All rights
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.