ETSI TS 100 392-18-1 V1.7.1 (2015-03)

ETSI TS 100 392-18-1 V1.7.1 (2015-03)






TECHNICAL SPECIFICATION
Terrestrial Trunked Radio (TETRA);
Voice plus Data (V+D) and Direct Mode Operation (DMO);
Part 18: Air interface optimized applications;
Sub-part 1: Location Information Protocol (LIP)

---------------------- Page: 1 ----------------------
2 ETSI TS 100 392-18-1 V1.7.1 (2015-03)



Reference
RTS/TCCE-03232
Keywords
air interface, location, radio, TETRA, V+D
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
The present document can be downloaded from:
http://www.etsi.org/standards-search
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
https://portal.etsi.org/People/CommiteeSupportStaff.aspx
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2015.
All rights reserved.

TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI

---------------------- Page: 2 ----------------------
3 ETSI TS 100 392-18-1 V1.7.1 (2015-03)
Contents
Intellectual Property Rights . 8
Foreword . 8
Modal verbs terminology . 9
1 Scope . 10
2 References . 10
2.1 Normative references . 10
2.2 Informative references . 10
3 Definitions, symbols and abbreviations . 11
3.1 Definitions . 11
3.2 Symbols . 11
3.3 Abbreviations . 11
4 Location information protocol . 12
4.1 General . 12
4.2 Location information protocol system architecture . 13
4.3 Location information protocol service description . 16
4.3.1 General on services . 16
4.3.2 Services available at the LIP-SAP . 16
4.3.3 Service primitives at the LIP-SAP . 17
4.3.4 Service primitive parameters at the LIP-SAP . 17
4.5.5 State description . 17
5 Location information protocol description . 18
5.1 Description of information elements . 18
5.1.1 General on accuracies and uncertainties . 18
5.1.2 Acknowledgement request . 18
5.1.2a Backlog information elements . 18
5.1.3 Basic parameters . 18
5.1.4 Confidence level . 18
5.1.5 Direction of travel and direction of travel accuracy . 18
5.1.6 Horizontal position and horizontal position accuracy . 19
5.1.7 Horizontal velocity and horizontal velocity accuracy . 19
5.1.8 Location altitude and location altitude accuracy . 19
5.1.9 Location information destination . 19
5.1.10 Location message reference . 19
5.1.11 Location shape . 20
5.1.12 Maximum information age . 20
5.1.13 Maximum reporting distance . 20
5.1.14 Maximum reporting interval . 20
5.1.15 Maximum response time . 20
5.1.16 Minimum reporting interval . 20
5.1.17 Reason for sending. 20
5.1.18 Report type. 20
5.1.19 Request priority . 20
5.1.20 Requested/required . 21
5.1.21 Start time . 21
5.1.22 Stop time . 21
5.1.23 Terminal or location identification . 21
5.1.24 Trigger definition . 22
5.1.25 Trigger type . 22
5.1.26 Velocity type . 22
5.1.27 Vertical velocity and vertical velocity accuracy . 22
5.2 Information flows . 22
5.2.1 General on information flows . 22
5.2.2 Pre-programmed MS sending reports . 23
5.2.3 Pre-programmed MS sending reports and receiving acknowledgement . 23
ETSI

---------------------- Page: 3 ----------------------
4 ETSI TS 100 392-18-1 V1.7.1 (2015-03)
5.2.4 MS receiving basic parameters . 24
5.2.5 MS receiving basic parameters and sending response . 24
5.2.6 MS reporting basic parameters . 25
5.2.7 MS receiving immediate report request and sending response . 25
5.2.8 MS receiving immediate report request and asking acknowledgement . 26
5.2.9 MS receiving trigger definitions and sending reports . 26
5.2.10 MS receiving trigger definitions and sending reports and asking acknowledgements. 27
5.2.11 MS receiving trigger definitions and sending modification . 27
5.2.12 MS receiving trigger definitions and rejecting triggers . 28
5.2.13 MS receiving trigger definitions and sending reports to other location information destination . 28
5.2.14 MS receiving trigger definitions via location server and sending reports to another location
information destination . 29
5.2.15 Trigger removal . 30
5.2.16 Trigger reporting . 30
5.2.17 Location reporting enabling . 31
5.2.18 Location reporting disabling . 31
5.2.19 Location reporting temporary control . 32
5.2.20 Backlog information flows . 33
5.2.21 Allocation of entities . 33
5.3 Procedures . 34
5.3.1 Relations to flow charts . 34
5.3.2 General on control messages . 34
5.3.3 Accuracy control in control messages . 34
5.3.4 General on location report sending . 35
5.3.5 General on location report reception . 35
5.3.6 MS sending unsolicited reports . 35
5.3.7 MS receiving basic parameters . 36
5.3.8 MS reporting basic parameters . 36
5.3.9 MS sending immediate reports . 36
5.3.10 MS sending immediate report request . 36
5.3.11 Triggered report request sending . 36
5.3.12 MS receiving triggered reports requests . 37
5.3.13 MS sending triggered reports . 37
5.3.14 MS receiving triggered reports . 38
5.3.15 Triggered report reception in location server . 38
5.3.16 Trigger removal . 38
5.3.17 Report trigger request . 38
5.3.18 Location report enable/disable request . 38
5.3.19 Trigger configuration request . 39
5.3.20 Trigger and report type interactions . 39
5.3.21 Location message reference usage . 40
5.3.22 Triggers for Lost and Regained ability to determine location. 40
5.3.23 Trigger for Ambience Listening call . 40
5.3.24 Temporary control of location reporting . 41
5.3.25 Track retrieval . 41
5.3.25.1 General on track retrieval . 41
5.3.25.2 Backlog requesting entity actions . 42
5.3.25.3 MT or application actions . 42
5.3.25.3.1 Backlog location reporting . 42
5.3.25.3.2 Backlog location report recording enabling and disabling . 43
5.3.25.3.3 Backlog location report triggers . 43
5.3.25.3.4 Result code usage . 44
5.3.26 Trigger for call setup. 44
5.4 Management of time . 44
6 Location information protocol coding requirements . 45
6.1 General on coding requirements . 45
6.2 Location information protocol PDU description tables . 46
6.2.1 SHORT LOCATION REPORT PDU . 46
6.2.2 LONG LOCATION REPORT PDU . 46
6.2.3 LOCATION REPORT ACKNOWLEDGEMENT PDU . 47
6.2.4 BASIC LOCATION PARAMETERS REQUEST PDU . 47
ETSI

---------------------- Page: 4 ----------------------
5 ETSI TS 100 392-18-1 V1.7.1 (2015-03)
6.2.5 BASIC LOCATION PARAMETERS RESPONSE PDU . 48
6.2.6 REPORT BASIC LOCATION PARAMETERS REQUEST PDU . 48
6.2.7 REPORT BASIC LOCATION PARAMETERS RESPONSE PDU . 49
6.2.8 ADD/MODIFY TRIGGER REQUEST PDU . 50
6.2.9 ADD/MODIFY TRIGGER RESPONSE PDU . 51
6.2.10 REMOVE TRIGGER REQUEST PDU . 52
6.2.11 REMOVE TRIGGER RESPONSE PDU . 52
6.2.12 REPORT TRIGGERS REQUEST PDU . 52
6.2.13 REPORT TRIGGER RESPONSE PDU . 53
6.2.14 LOCATION REPORTING ENABLE/DISABLE REQUEST PDU . 54
6.2.15 LOCATION REPORTING ENABLE/DISABLE RESPONSE PDU . 54
6.2.16 IMMEDIATE LOCATION REPORT REQUEST PDU . 55
6.2.17 LOCATION REPORTING TEMPORARY CONTROL REQUEST PDU . 56
6.2.18 LOCATION REPORTING TEMPORARY CONTROL RESPONSE PDU . 56
6.2.19 BACKLOG REQUEST PDU . 56
6.2.20 BACKLOG RESPONSE PDU . 57
6.2.21 Backlog PDUs . 58
6.2.21.1 BACKLOG ADD/MODIFY TRIGGERS REQUEST PDU . 58
6.2.21.2 BACKLOG ADD/MODIFY TRIGGERS RESPONSE PDU . 59
6.2.21.3 BACKLOG CONFIGURATION REQUEST PDU . 60
6.2.21.4 BACKLOG CONFIGURATION RESPONSE PDU . 60
6.2.21.5 BACKLOG REMOVE TRIGGERS REQUEST PDU . 60
6.2.21.6 BACKLOG REMOVE TRIGGERS RESPONSE PDU . 60
6.2.21.7 BACKLOG REPORT TRIGGERS REQUEST PDU . 61
6.2.21.8 BACKLOG REPORT TRIGGERS RESPONSE PDU . 61
6.2.21.9 BACKLOG RETRIEVAL REQUEST PDU . 61
6.2.21.10 BACKLOG RETRIEVAL RESPONSE PDU . 62
6.3 Location information protocol PDU information elements . 62
6.3.1 Acknowledgement request . 62
6.3.2 Address or identification type . 62
6.3.3 Angle . 63
6.3.4 Backlog information elements . 63
6.3.4.1 Backlog continuation state . 63
6.3.4.2 Backlog denominator rule . 63
6.3.4.3 Backlog distance interval rule . 64
6.3.4.4 Backlog information available . 64
6.3.4.5 Backlog retrieval action . 64
6.3.4.6 Backlog retrieval rules . 64
6.3.4.7 Backlog location reports present . 65
6.3.4.8 Backlog location reports requested . 65
6.3.4.9 Backlog order of processing . 65
6.3.4.10 Backlog PDU Type . 65
6.3.4.11 Backlog time frame rule . 66
6.3.4.12 Backlog time interval rule . 66
6.3.4a Confidence level . 66
6.3.4b Default enable/disable lifetime . 66
6.3.5 Direction of travel . 66
6.3.6 Direction of travel extended. 67
6.3.7 Direction of travel accuracy . 67
6.3.8 Direction of travel and direction of travel accuracy . 67
6.3.9 Direction of travel uncertainty . 68
6.3.10 Extended user defined data . 68
6.3.11 External subscriber number . 68
6.3.12 Half of major axis . 68
6.3.13 Half of minor axis . 68
6.3.14 Horizontal position accuracy . 68
6.3.15 Horizontal position and horizontal position accuracy . 69
6.3.16 Horizontal position uncertainty. 69
6.3.17 Horizontal velocity . 69
6.3.18 Horizontal velocity accuracy . 70
6.3.19 Horizontal velocity and horizontal velocity accuracy . 71
6.3.20 Horizontal velocity and vertical velocity . 71
ETSI

---------------------- Page: 5 ----------------------
6 ETSI TS 100 392-18-1 V1.7.1 (2015-03)
6.3.21 Horizontal velocity and vertical velocity with uncertainty . 71
6.3.22 Horizontal velocity and vertical velocity with direction of travel extended and uncertainty . 71
6
...