ETSI TR 101 611 V1.1.1 (2014-06)

ETSI TR 101 611 V1.1.1 (2014-06)






Technical Report
Intelligent Transport Systems (ITS);
Testing;
Conformance test specification for CALM Fast Services;
FNTP/FSAP/IICP validation report

---------------------- Page: 1 ----------------------
2 ETSI TR 101 611 V1.1.1 (2014-06)



Reference
DTR/ITS-0020048
Keywords
ITS, CALM, testing, validation
ETSI
650 Route des Lucioles
F-06921 Sophia Antipolis Cedex - FRANCE

Tel.: +33 4 92 94 42 00  Fax: +33 4 93 65 47 16

Siret N° 348 623 562 00017 - NAF 742 C
Association à but non lucratif enregistrée à la
Sous-Préfecture de Grasse (06) N° 7803/88

Important notice
The present document can be downloaded from:
http://www.etsi.org
The present document may be made available in electronic versions and/or in print. The content of any electronic and/or
print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any
existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the
print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat.
Users of the present document should be aware that the document may be subject to revision or change of status.
Information on the current status of this and other ETSI documents is available at
http://portal.etsi.org/tb/status/status.asp
If you find errors in the present document, please send your comment to one of the following services:
http://portal.etsi.org/chaircor/ETSI_support.asp
Copyright Notification
No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
and microfilm except as authorized by written permission of ETSI.
The content of the PDF version shall not be modified without the written authorization of ETSI.
The copyright and the foregoing restriction extend to reproduction in all media.

© European Telecommunications Standards Institute 2014.
All rights reserved.

TM TM TM
DECT , PLUGTESTS , UMTS and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members.
TM
3GPP and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and
of the 3GPP Organizational Partners.
GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association.
ETSI

---------------------- Page: 2 ----------------------
3 ETSI TR 101 611 V1.1.1 (2014-06)
Contents
Intellectual Property Rights . 4
Foreword . 4
Modal verbs terminology . 4
Introduction . 4
1 Scope . 5
2 References . 5
2.1 Normative references . 5
2.2 Informative references . 5
3 Abbreviations . 6
4 Validation report . 6
4.1 Validation level . 6
4.2 Source code evaluation . 6
4.2.1 TTCN-3 version . 6
4.2.2 TTCN-3 tools used for compilation . 7
4.3 Validation process . 7
4.3.1 Test platform . 7
4.3.2 Systems under test . 7
4.3.3 Validation status . 7
4.3.3.1 FNTP . 7
4.3.3.2 FSAP . 8
4.3.3.3 IICP . 9
4.4 Feedback to standardization process . 10
4.4.1 Base standard issues. 10
4.4.2 Test specification issues . 10
4.4.3 SUT issues . 10
History . 11

ETSI

---------------------- Page: 3 ----------------------
4 ETSI TR 101 611 V1.1.1 (2014-06)
Intellectual Property Rights
IPRs essential or potentially essential to the present document may have been declared to ETSI. The information
pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found
in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in
respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web
server (http://ipr.etsi.org).
Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee
can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web
server) which are, or may be, or may become, essential to the present document.
Foreword
This Technical Report (TR) has been produced by ETSI Technical Committee Intelligent Transport Systems (ITS).
Modal verbs terminology
In the present document "shall", "shall not", "should", "should not", "may", "may not", "need", "need not", "will",
"will not", "can" and "cannot" are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms
for the expression of provisions).
"must" and "must not" are NOT allowed in ETSI deliverables except when used in direct citation.
Introduction
In response to EC mandate M/453 [i.13], ETSI Technical Committee ITS has standardized test specifications for ITS
protocols according to base standards from ISO TC204 WG16. In a next step a prototype TTCN-3 test system was built
and validated. The present document describes the validation and design of the prototype TTCN-3 test system.
The action described in the present document supports the implementation of ITS standards by:
• Making available validated and standardized test specifications and thus enabling the application of reliable
certification schemes.
• Executing conformance validation framework against real Implementations Under Test (IUTs) from industry
and thus providing these companies a conformance assessment of their implementations. During the lifetime
of this action, the conformance validation framework was as well demonstrated at a meeting of ISO TC204 in
Kobe (Japan), and at an ETSI PlugTest.
• Releasing all software as open source and thus allowing industry to build and run their own conformance
validation framework.
ETSI

---------------------- Page: 4 ----------------------
5 ETSI TR 101 611 V1.1.1 (2014-06)
1 Scope
The present document is the validation report of the FNTP, FSAP and IICP conformance tests and it provides statistics
of executed and validated FNTP, FSAP and IICP conformance tests. The information provided has been produced by
validation against two prototype implementations from industry.
Furthermore, identified issues related to the base specifications ISO 29281-1 [i.5], ISO 24102-5 [i.4], ISO 24102-4 [i.3]
and test specification TS 102 985-1 [i.6], TS 102 985-2 [i.7], TS 102 985-3 [i.8], TS 102 797-1 [i.9],
TS 102 797-2 [i.10], TS 102 797-3 [i.11] are listed in the present document.
2 References
References are either specific (identified by date of publication and/or edition number or version number) or
non-specific. For specific references,only the cited version applies. For non-specific references, the latest version of the
referenced document (including any amendments) applies.
Referenced documents which are not found to be publicly available in the expected location might be found at
http://docbox.etsi.org/Reference.
NOTE: While any hyperlinks included in this clause were valid at the time of publication ETSI cannot guarantee
their long term validity.
2.1 Normative references
The following referenced documents are necessary for the application of the present document.
Not applicable.
2.2 Informative references
The following referenced documents are not necessary for the application of the present document but they assist the
user with regard to a particular subject area.
[i.1] ETSI TR 103 099 (V1.2.1): "Intelligent Transport Systems (ITS); Architectu
...