ETSI ETS 300 167 ed.1 (1993-08)

SLOVENSKI STANDARD
SIST ETS 300 167 E1:2003
01-december-2003
Prenos in multipleksiranje (TM) – Funkcijske karakteristike vmesnikov s hitrostjo 2
048 kbit/s
Transmission and Multiplexing (TM); Functional characteristics of 2 048 kbit/s interfaces
Ta slovenski standard je istoveten z: ETS 300 167 Edition 1
ICS:
33.040.20 Prenosni sistem Transmission systems
35.200 Vmesniška in povezovalna Interface and interconnection
oprema equipment
SIST ETS 300 167 E1:2003 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ETS 300 167 E1:2003

---------------------- Page: 2 ----------------------

SIST ETS 300 167 E1:2003
EUROPEAN ETS 300 167
TELECOMMUNICATION August 1993
STANDARD
Source: ETSI TC-TM Reference: DE/TM-3006
ICS: 33.020, 33.040.40
Transmission, multiplexing, interfaces
Key words:
Transmission and Multiplexing (TM);
Functional characteristics
of 2 048 kbit/s interfaces
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
F-06921 Sophia Antipolis CEDEX - FRANCE
Postal address:
650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
Office address:
c=fr, a=atlas, p=etsi, s=secretariat - secretariat@etsi.fr
X.400: Internet:
Tel.: +33 92 94 42 00 - Fax: +33 93 65 47 16
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1993. All rights reserved.
New presentation - see History box

---------------------- Page: 3 ----------------------

SIST ETS 300 167 E1:2003
Page 2
ETS 300 167: August 1993
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.

---------------------- Page: 4 ----------------------

SIST ETS 300 167 E1:2003
Page 3
ETS 300 167: August 1993
Contents
Foreword .5
1 Scope .7
2 Normative references.7
3 Definitions.7
4 Abbreviations.7
5 Requirements.7
History.10

---------------------- Page: 5 ----------------------

SIST ETS 300 167 E1:2003
Page 4
ETS 300 167: August 1993
Blank page

---------------------- Page: 6 ----------------------

SIST ETS 300 167 E1:2003
Page 5
ETS 300 167: August 1993
Foreword
This European Telecommunication Standard (ETS) has been produced by the Transmission and
Multiplexing (TM) Technical Committee of the European Telecommunications Standards Institute (ETSI).
This ETS aims at providing inter-vendor and inter-operator compatibility for synchronous frame structures
based on CCITT Recommendations G.704 [1] used at primary hierarchical levels and G.706 [2] on frame
alignment and Cyclic Redundancy Check (CRC) procedures relating to basic frame structures defined in
CCITT Recommendation G.704 [1].
The conformance testing requirements corresponding to the specifications contained in this ETS are to be
specified in a different ETS.

---------------------- Page: 7 ----------------------

SIST ETS 300 167 E1:2003
Page 6
ETS 300 167: August 1993
Blank page

---------------------- Page: 8 ----------------------

SIST ETS 300 167 E1:2003
Page 7
ETS 300 167: August 1993
1 Scope
This ETS describes the synchronous frame structures and the frame alignment and Cyclic Redundancy
Check (CRC) procedures relevant to 2 048 kbit/s interfaces based on CCITT Recommendations G.704 [1]
and G.706 [2].
2 Normative references
This ETS incorporates by dated or undated reference, provisions from other publications. These
normative references are cited at the appropriate places in the text and the publications are listed
hereafter. For dated references, subsequent amendments to or revisions of any of these publications
apply to this ETS only when incorporated in it by amendment or revision. For undated references the
...