ETSI EN 300 219 V2.1.1 (2016-08)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Land Mobile Service - Radio equipment transmitting signals to initiate a specific response in the receiver - Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU33.070.01Mobilni servisi na splošnoMobile services in general33.060.99Druga oprema za radijske komunikacijeOther equipment for radiocommunicationsICS:Ta slovenski standard je istoveten z:ETSI EN 300 219 V2.1.1 (2016-08)SIST EN 300 219 V2.1.1:2016en01-november-2016SIST EN 300 219 V2.1.1:2016SLOVENSKI
STANDARD



SIST EN 300 219 V2.1.1:2016



ETSI EN 300 219 V2.1.1 (2016-08) Land Mobile Service; Radio equipment transmitting signals to initiate a specific response in the receiver; Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU
HARMONISED EUROPEAN STANDARD SIST EN 300 219 V2.1.1:2016



ETSI ETSI EN 300 219 V2.1.1 (2016-08) 2
Reference REN/ERM-TGDMR-349 Keywords analogue, mobile, PMR, radio, signalling ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice The present document can be downloaded from: http://www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at https://portal.etsi.org/TB/ETSIDeliverableStatus.aspx If you find errors in the present document, please send your comment to one of the following services: https://portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2016. All rights reserved.
DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE™ are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM® and the GSM logo are Trade Marks registered and owned by the GSM Association. SIST EN 300 219 V2.1.1:2016



ETSI ETSI EN 300 219 V2.1.1 (2016-08) 3 Contents Intellectual Property Rights . 7 Foreword . 7 Modal verbs terminology . 7 1 Scope . 8 2 References . 8 2.1 Normative references . 8 2.2 Informative references . 9 3 Definitions, symbols and abbreviations . 10 3.1 Definitions . 10 3.2 Symbols . 10 3.3 Abbreviations . 10 4 Speech equipment with signalling . 11 4.1 Applicability . 11 4.1.1 General . 11 4.1.2 Equipment with speech and signalling functions . 11 4.1.3 Equipment with an add-on signalling unit . 11 5 General and operational requirements . 12 5.1 General . 12 5.1.1 Environmental profile . 12 5.1.2 Choice of model for testing . 12 5.2 Mechanical and electrical design . 12 5.2.1 General . 12 5.2.2 Controls . 12 5.2.3 Transmitter shut-off facility (time-out) . 12 6 Test conditions, power sources and ambient temperatures . 12 6.1 Normal and extreme test conditions . 12 6.2 Test power source . 12 6.3 Normal test conditions . 13 6.3.1 Normal temperature and humidity . 13 6.3.2 Normal test power source . 13 6.3.2.1 Mains voltage . 13 6.3.2.2 Regulated lead-acid battery power sources used on vehicles . 13 6.3.2.3 Other power sources . 13 6.4 Extreme test conditions . 13 6.4.1 Extreme temperatures . 13 6.4.2 Extreme test source voltages . 14 6.4.2.1 Mains voltage . 14 6.4.2.2 Regulated lead-acid battery power sources used on vehicles . 14 6.4.2.3 Power sources using other types of batteries . 14 6.4.2.4 Other power sources . 14 6.5 Procedure for tests at extreme temperatures . 14 6.5.0 Thermal balance . 14 6.5.1 Procedure for equipment designed for continuous transmission. 15 6.5.2 Procedure for equipment designed for intermittent transmission . 15 7 General conditions of measurement . 15 7.1 Arrangements for test signals at the input of the receiver . 15 7.2 Receiver mute or squelch facility . 15 7.3 Normal test signals, (wanted and unwanted signals) . 15 7.4 Encoder for receiver measurements . 16 7.5 Test Load (artificial antenna) . 16 7.6 Test sites and general arrangements for radiated measurements . 16 7.7 Transmitter automatic shut-off facility (time-out) . 16 SIST EN 300 219 V2.1.1:2016



ETSI ETSI EN 300 219 V2.1.1 (2016-08) 4 7.8 Modes of operation of the transmitter . 16 7.9 Facilities for access between the receiver demodulator output and its decoder . 16 7.10 Calling indicator . 17 7.11 Reset . 17 7.12 Reset time . 17 7.13 Test of equipment with a duplex filter . 17 8 Technical characteristic of the transmitter . 17 8.1 Frequency error . 17 8.1.0 Applicability . 17 8.1.1 Definition . 17 8.1.2 Method of measurement . 17 8.1.3 Limits . 18 8.2 Carrier power (conducted) . 18 8.2.0 Applicability . 18 8.2.1 Definitions . 18 8.2.2 Method of measurement . 19 8.2.3 Limits . 19 8.3 Effective radiated power (field strength) . 19 8.3.0 Applicability . 19 8.3.1 Definition . 19 8.3.2 Method of measurement . 19 8.3.3 Limits . 21 8.4 Adjacent and alternate channel power . 22 8.4.0 Applicability . 22 8.4.1 Definition . 22 8.4.2 Method of measurement . 22 8.4.3 Limits . 24 8.5 Transmitter spurious emissions . 24 8.5.0 Applicability . 24 8.5.1 Definition . 24 8.5.2 Method of measuring the power level . 24 8.5.3 Method of measuring the effective radiated power . 25 8.5.4 Transmitter spurious emissions . 26 8.6 Intermodulation attenuation. 27 8.6.0 Applicability . 27 8.6.1 Definition . 27 8.6.2 Method of measurement . 28 8.6.3 Limits . 29 8.7 Transmitter Attack Time . 29 8.7.0 Applicability . 29 8.7.1 Definition . 29 8.7.2 Method of measurement . 29 8.7.3 Limits . 30 8.8 Transmitter release time . 30 8.8.0 Applicability . 30 8.8.1 Definition . 30 8.8.2 Method of measurement . 30 8.8.3 Limits . 31 8.9 Transient frequency behaviour of the transmitter . 31 8.9.0 Applicability . 31 8.9.1 Definitions . 31 8.9.2 Method of measurement . 31 8.9.3 Limits . 35 9 Technical characteristics of the receiver . 35 9.1 Reference sensitivity (responses) . 35 9.1.1 Definition . 35 9.1.2 Reference sensitivity (response) . 35 9.2 Maximum usable sensitivity (responses, conducted) . 35 9.2.0 Applicability . 35 9.2.1 Definition . 35 SIST EN 300 219 V2.1.1:2016



ETSI ETSI EN 300 219 V2.1.1 (2016-08) 5 9.2.2 Method of measurement ("up-down method") . 36 9.2.3 Limits . 36 9.3 Average usable sensitivity (field strength, responses) . 36 9.3.0 Applicability . 36 9.3.1 Definition . 37 9.3.2 Method of measurement under normal test conditions . 37 9.3.3 Method of measurement of the average usable sensitivities under extreme test conditions . 38 9.3.4 References for degradation measurements . 39 9.3.4.1 Definition . 39 9.3.4.2 Procedures for measurements using the test fixture . 39 9.3.4.3 Procedures for measurements using the test site . 40 9.3.5 Limits . 40 9.4 Co-channel rejection. 41 9.4.0 Applicability . 41 9.4.1 Definition . 41 9.4.2 Method of measurement . 41 9.4.3 Limits . 42 9.5 Adjacent channel selectivity . 42 9.5.0 Applicability . 42 9.5.1 Definition . 42 9.5.2 Method of measurement . 43 9.5.3 Limits . 44 9.6 Spurious response rejection . 44 9.6.0 Applicability . 44 9.6.1 Definition . 44 9.6.2 Introduction to the method of measurement . 44 9.6.3 Method of search over the "limited frequency range" . 45 9.6.4 Method of measurement . 46 9.6.5 Limits . 47 9.7 Intermodulation response . 47 9.7.0 Applicability . 47 9.7.1 Definition . 47 9.7.2 Method of measurement . 47 9.7.3 Limits . 48 9.8 Blocking or desensitization . 48 9.8.0 Applicability . 48 9.8.1 Definition . 48 9.8.2 Method of measurement . 49 9.8.3 Limits . 50 9.9 Receiver spurious radiations. 50 9.9.0 Applicability . 50 9.9.1 Definition . 50 9.9.2 Method of measuring the power level . 50 9.9.3 Method of measuring the effective radiated power . 51 9.9.4 Limits . 52 10 Duplex operation . 52 10.0 Applicability . 52 10.1 Receiver desensitization (with simultaneous transmission and reception) . 52 10.1.1 Definition . 52 10.1.2 Method of measurement when the equipment operates with a duplex filter . 53 10.1.3 Method of measurement when the equipment operates with separate Tx and Rx antennas . 54 10.1.4 Limits . 54 10.2 Receiver spurious response rejection (with simultaneous transmission and reception) . 55 10.2.1 Definition . 55 10.2.2 Method of measurement . 55 10.2.3 Limits .
...