EN 62034:2006

SLOVENSKI STANDARD
01-september-2007
Samodejni preskušalni sistemi za baterijsko napajano nujnostno razsvetljavo
evakuacijskih poti (IEC 62034:2006)
Automatic test systems for battery powered emergency escape lighting (IEC
62034:2006)
Automatische Prüfsysteme für batteriebetriebene Sicherheitsbeleuchtung für
Rettungswege (IEC 62034:2006)
Systeme automatique de tests pour éclairage de sécurité sur batteries (IEC 62034:2006)
Ta slovenski standard je istoveten z: EN 62034:2006
ICS:
29.140.50 Instalacijski sistemi za Lighting installation systems
razsvetljavo
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 62034
NORME EUROPÉENNE
December 2006
EUROPÄISCHE NORM
ICS 29.140.50
English version
Automatic test systems
for battery powered emergency escape lighting
(IEC 62034:2006)
Système automatique de tests  Automatische Prüfsysteme
pour éclairage de sécurité sur batteries für batteriebetriebene
(CEI 62034:2006) Sicherheitsbeleuchtung
für Rettungswege
(IEC 62034:2006)
This European Standard was approved by CENELEC on 2006-09-12. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Central Secretariat: rue de Stassart 35, B - 1050 Brussels

© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 62034:2006 E
Foreword
The text of document 34D/855/FDIS, future edition 1 of IEC 62034, prepared by SC 34D, Luminaires, of
IEC TC 34, Lamps and related equipment, was submitted to the IEC-CENELEC parallel vote and was
approved by CENELEC as EN 62034 on 2006-09-12.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2007-07-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2011-10-01
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 62034:2006 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 61347-2-7 NOTE  Harmonized as EN 61347-2-7:2006 (not modified).
IEC 61347-2-11 NOTE  Harmonized as EN 61347-2-11:2001 (not modified).
__________
- 3 - EN 62034:2006
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year

1) 2)
IEC 60073 - Basic and safety principles for man-machine EN 60073 2002
interface, marking and identification - Coding
principles for indicators and actuators

IEC 60598-1 (mod) 2003 Luminaires EN 60598-1 2004
Part 1: General requirements and tests

IEC 60598-2-22 1997 Luminaires EN 60598-2-22 1998
(mod) Part 2-22: Particular requirements - + corr. December 2005
Luminaires for emergency lighting

IEC 61347-1 2000 Lamp controlgear EN 61347-1 2001
Part 1: General and safety requirements + corr. July 2003

IEC 61547 1995 Equipment for general lighting purposes - EN 61547 1995
EMC immunity requirements
1)
Undated reference.
2)
Valid edition at date of issue.

NORME CEI
INTERNATIONALE
IEC
INTERNATIONAL
Première édition
STANDARD
First edition
2006-05
Système automatique de tests pour éclairage
de sécurité sur batteries
Automatic test systems for battery powered
emergency escape lighting
 IEC 2006 Droits de reproduction réservés  Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch Web: www.iec.ch
CODE PRIX
S
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
МеждународнаяЭлектротехническаяКомиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue

62034  IEC:2006 – 3 –
CONTENTS
FOREWORD.5
INTRODUCTION.9

1 Scope.11
2 Normative references .11
3 Terms and definitions .11
4 Requirements .13
4.1 Safety, construction and installation instructions .13
4.2 Monitoring of the timing circuit.15
4.3 Functional requirements .15
4.4 Protection against system part failures and faults.17
4.5 Test of emergency lamp(s) .19
5 Test duration and interval .21
5.1 Functional test.21
5.2 Duration test .21
6 Protection of a building during the periods of test and subsequent recharge of the
emergency lighting system .21
6.1 General .21
6.2 Accuracy and protection of timing periods .23
6.3 Requirements for premises that may be occupied during test and recharge
periods .23
7 Indication and recording of results of tests that the equipment has to perform .27
7.1 General .27
7.2 Indication .27
7.3 Recording.29

Annex A (informative) Examples of typical automatic test systems.31
Annex B (informative) Classification of ATS types.41

Bibliography.43

Figure 1 – Stand-alone, self-contained luminaire with automatic test facilities.31
Figure 2 – Direct connection between luminaires and remote panel .33
Figure 3 – Alternative system luminaires connection is marshalled by a connection box
for transmission to remote indicators and control panel.35
Figure 4 – Direct connection between luminaires and remote panel .37

Table A.1 – Standards conformity guide.33
Table A.2 – Standards conformity guide.37
Table A.3 – Standards conformity guide.39

62034  IEC:2006 – 5 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
AUTOMATIC TEST SYSTEMS FOR BATTERY POWERED
EMERGENCY ESCAPE LIGHTING
FOREWORD
1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, IEC publishes International Standards, Technical Specifications,
Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC
Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested
in the subject dealt with may participate in this preparatory work. International, governmental and non-
governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely
with the International Organization for Standardization (ISO) in accordance with conditions determined by
agreement between the two organizations.
2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international
consensus of opinion on the relevant subjects since each technical committee has representation from all
interested IEC National Committees.
3) IEC Publications have the form of recommendations for international use and are accepted by IEC National
Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC
Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any
misinterpretation by any end user.
4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications
transparently to the maximum extent possible in their national and regional publications. Any divergence
between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in
the latter.
5) IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any
equipment declared to be in conformity with an IEC Publication.
6) All users should ensure that they have the latest edition of this publication.
7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and
members of its technical committees and IEC National Committees for any personal injury, property damage or
other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and
expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC
Publications.
8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is
indispensable for the correct application of this publication.
9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of
patent rights. IEC shall not be held responsible for identifying any or all such patent rights.
International Standard IEC 62034 has been prepared by subcommittee 34D: Luminaires, of
IEC technical committee 34: Lamps and related equipment.
The text of this standard is based on the following documents:
FDIS Report on voting
34D/855/FDIS 34D/858/RVD
Full information on the voting for the approval of this standard can be found in the report on
voting indicated in the above table.
This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.

62034  IEC:2006 – 7 –
The committee has decided that the contents of this publication will remain unchanged until
the maintenance result date indicated on the IEC web site under "http://webstore.iec.ch" in
the data related to the specific publication. At this date, the publication will be
• reconfirmed;
• withdrawn;
• replaced by a revised edition, or
• amended.
62034  IEC:2006
...