EN ISO 20347:2004/A1:2007

SLOVENSKI STANDARD
01-december-2007
Osebna varovalna oprema - Delovna obutev - Dopolnilo 1 (ISO 20347:2004/Amd
1:2007)
Personal protective equipment - Occupational footwear - Amendment 1 (ISO
20347:2004/Amd 1:2007)
Persönliche Schutzausrüstung - Berufsschuhe (ISO 20347:2004/Amd 1:2007)
Équipement de protection individuelle - Chaussures de travail - Amendement 1 (ISO
20347:2004/Amd 1:2007)
Ta slovenski standard je istoveten z: EN ISO 20347:2004/A1:2007
ICS:
13.340.50 =DãþLWQDREXWHY Protective footwear
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN ISO 20347:2004/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
September 2007
ICS 13.340.50
English Version
Personal protective equipment - Occupational footwear -
Amendment 1 (ISO 20347:2004/Amd 1:2007)
Équipement de protection individuelle - Chaussures de Persönliche Schutzausrüstung - Berufsschuhe - Änderung
travail - Amendement 1 (ISO 20347:2004/Amd 1:2007) 1 (ISO 20347:2004/Amd 1:2007)
This amendment A1 modifies the European Standard EN ISO 20347:2004; it was approved by CEN on 27 August 2007.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the CEN Management Centre or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2007 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 20347:2004/A1:2007: E
worldwide for CEN national Members.

Contents Page
Foreword.3

Foreword
This document (EN ISO 20347:2004/A1:2007) has been prepared by Technical Committee CEN/TC 161 "Foot
and leg protectors", the secretariat of which is held by BSI, in collaboration with Technical Committee ISO/TC
94 "Personal safety - Protective clothing and equipment".
This Amendment to the European Standard EN ISO 20347:2004 shall be given the status of a national
standard, either by publication of an identical text or by endorsement, at the latest by March 2008, and
conflicting national standards shall be withdrawn at the latest by March 2008.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EC Directive(s).
For relationship with EC Directive(s), see informative Annex ZA which is an integral part of this document.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Cyprus, Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.

Annex ZA
(informative)
Relationship between this International Standard and the Essential
Requirements of EU Directive 89/686/EEC

This International Standard has been prepared under a mandate given to CEN by the European Commission
and the European Free Trade Association to provide one means of conforming to Essential Requirements of
the New Approach Directive 89/686.

Once this standard is cited in the Official Journal of the European Communities under that Directive and has
been implemented as a national standard in at least one Member State, compliance with the normative
clauses of this standard given in Table ZA.1 confers, within the limits of the scope of this standard, a
presumption of conformity with the relevant Essential Requirements of that Directive and associated EFTA
regulations.
Table ZA.1 — Correspondence between this International Standardand Directive 89/686/EEC

Essential requirements (ERs) of Clause(s)/sub-clause(s) of this Qualifying remarks/Notes
EU Directive 89/686/EEC International standard
3.1.2 Prevention of falls due to 5.3.5; 6.4.1; 6.4.3 Subclause 5.3.4 is found in
slipping ISO 20347:2004/Amd1:2007.

WARNING: Other requirements and other EU Directives may be applicable to the products falling within the
scope of this standard.
INTERNATIONAL ISO
STANDARD 20347
First edition
2004-08-01
AMENDMENT 1
2007-09-01
Personal protective equipment —
Occupational footwear
AMENDMENT 1
Équipement de protection individuelle — Chaussures de travail
AMENDEMENT 1
Reference number
ISO 20347:2004/Amd.1:2007(E)
©
ISO 2007
ISO 20347:2004/Amd.1:2007(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO
...