CEN/TR 15068:2009

SLOVENSKI STANDARD
01-junij-2009
Oprema za plamensko varjenje - Merjenje hrupa, ki ga oddaja gorilnik za varjenje,
rezanje, segrevanje, trdo in mehko spajkanje - Merilna metoda
Gas welding equipment - Measurement of noise emitted by blowpipe for welding, cutting,
heating, brazing and soldering - Measurement method
Gasschweißgeräte - Messungen für von Brennern für Schweißen, Schneiden, Wärmen,
Hartlöten und Weichlöten erzeugte Geräusche - Messverfahren
Matériel de soudage aux gaz - Mesurage du bruit émis par les chalumeaux destinés au
soudage, brasage, coupage et chauffage - Méthode de mesurage
Ta slovenski standard je istoveten z: CEN/TR 15068:2009
ICS:
17.140.20 Emisija hrupa naprav in Noise emitted by machines
opreme and equipment
25.160.30 Varilna oprema Welding equipment
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

TECHNICAL REPORT
CEN/TR 15068
RAPPORT TECHNIQUE
TECHNISCHER BERICHT
March 2009
ICS 25.160.30
English Version
Gas welding equipment - Measurement of noise emitted by
blowpipe for welding, cutting, heating, brazing and soldering -
Measurement method
Matériel de soudage aux gaz - Mesurage du bruit émis par Gasschweißgeräte - Messungen für von Brennern für
les chalumeaux destinés au soudage, brasage, coupage et Schweißen, Schneiden, Wärmen, Hartlöten und Weichlöten
chauffage - Méthode de mesurage erzeugte Geräusche - Messverfahren
This Technical Report was approved by CEN on 17 February 2009. It has been drawn up by the Technical Committee CEN/TC 121.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TR 15068:2009: E
worldwide for CEN national Members.

Contents Page
Foreword .3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Measurement conditions .4
5 Procedure .6
6 Test results .6
7 Test report .6

Foreword
This document (CEN/TR 15068:2009) has been prepared by Technical Committee CEN/TC 121 “Welding”,
the secretariat of which is held by DIN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
1 Scope
This Technical Report specifies a test method for measuring the noise emitted by manual blowpipes according
to EN ISO 5172 used for welding, cutting and allied processes.
This test method is used only for comparative purposes between manual blowpipes when tested under
nominal conditions under clause 5.
2 Normative references
The following referenced documents are indispensable for the application
...