EN 2812:2009

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Luft- und Raumfahrt - Abisolieren von elektrischen LeitungenSérie aérospatiale - Dénudages des câbles électriquesAerospace series - Stripping of electric cables49.060Aerospace electric equipment and systemsICS:Ta slovenski standard je istoveten z:EN 2812:2009SIST EN 2812:2009en01-oktober-2009SIST EN 2812:2009SLOVENSKI
STANDARD
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 2812August 2009ICS 49.060 English VersionAerospace series - Stripping of electric cablesSérie aérospatiale - Dénudages des câbles électriquesLuft- und Raumfahrt - Abisolieren von elektrischenLeitungenThis European Standard was approved by CEN on 20 June 2009.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre:
Avenue Marnix 17,
B-1000 Brussels© 2009 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 2812:2009: ESIST EN 2812:2009

1) Published as ASD Prestandard at the date of publication of this standard. SIST EN 2812:2009

Figure 1 — V shaped cutting blades Figure 2 — Shearing type blades
3.3.3 Stripping with power tools These tools use blades with the same general characteristics as those defined in 3.3.2. SIST EN 2812:2009

4.1.1 Identification An identification number marked on the main body is recommended in order to facilitate the follow-up of the inspection of the cutting blade. 4.1.2 Inspection
The inspection of cutting area is carried out visually at regular intervals. The inspection shall be completed by inspection of samples of stripped cable ends, see 5.3.1. SIST EN 2812:2009

An identification number shall be permanently marked on the main body of the tool and on the blade. In addition, each stripping tool shall have an individual inspection sheet including:  its identification number;  date of first commissioning;  dates of successi
...