EN ISO 8537:1994/A1:2000

SLOVENSKI STANDARD
01-november-2001
Sterilne injekcijske brizge za insulin za enkratno uporabo, z iglo ali brez nje (ISO
8537:1991/DAM 1:2000))
Sterile single-use syringes, with or without needle, for insulin (ISO 8537:1991/DAM
1:2000)
Sterile Insulin-Einmalspritzen mit oder ohne Kanüle (ISO 8537:1991/DAM 1:2000)
Seringues a insuline stériles non réutilisables avec ou sans aiguille (ISO 8537:1991/DAM
1:2000)
Ta slovenski standard je istoveten z: EN ISO 8537:1994/A1:2000
ICS:
11.040.25 Injekcijske brizge, igle in Syringes, needles an
katetri catheters
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

INTERNATIONAL ISO
STANDARD 8537
First edition
1991-05-01
AMENDMENT 1
2000-11-01
Sterile single-use syringes, with or without
needle, for insulin
AMENDMENT 1
Seringues à insuline stériles non réutilisables avec ou sans aiguille
AMENDEMENT 1
Reference number
ISO 8537:1991/Amd.1:2000(E)
©
ISO 2000
ISO 8537:1991/Amd.1:2000(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not
be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this
area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters
were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event
that a problem relating to it is found, please inform the Central Secretariat at the address given below.
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body
in the country of the requester.
ISO copyright office
Case postale 56 � CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.ch
Web www.iso.ch
Printed in Switzerland
ii © ISO 2000 – All rights reserved

ISO 8537:1991/Amd.1:2000(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical
committees. Each member body interested in a subject for which a technical committee has been established has
the right to be represented on that committee. International organizations, governmental and non-governmental, in
liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3.
Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this Amendment may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to International Standard ISO 8537:1991 was prepared by Technical Committee ISO/TC 84, Medical
devices for injections.
Amendment 1 t
...