85.080.30 - Cardboard

This document describes a method for the determination of the flat crush resistance of a corrugating medium after laboratory fluting using an A-flute geometry.
The procedure is applicable to any corrugating medium intended to be used, after fluting, in the manufacture of corrugated board.
NOTE ISO 7263-2 describes a method to determine the flat crush resistance using a B-flute geometry.

This document describes a method for the determination of the flat crush resistance of a corrugating medium after laboratory fluting using a B-flute geometry.
The procedure is applicable to any corrugating medium intended to be used, after fluting, in the manufacture of corrugated board.
NOTE ISO 7263-1 describes a method to determine the flat crush resistance using an A-flute geometry.

This document describes a method for the determination of the flat crush resistance of a corrugating medium after laboratory fluting using an A-flute geometry. The procedure is applicable to any corrugating medium intended to be used, after fluting, in the manufacture of corrugated board. NOTE ISO 7263-2 describes a method to determine the flat crush resistance using a B-flute geometry.

This document describes a method for the determination of the flat crush resistance of a corrugating medium after laboratory fluting using a B-flute geometry. The procedure is applicable to any corrugating medium intended to be used, after fluting, in the manufacture of corrugated board. NOTE ISO 7263-1 describes a method to determine the flat crush resistance using an A-flute geometry.

ISO 3037:2013 specifies an unwaxed edge method for the determination of the edgewise crush resistance of corrugated fibreboard. It is applicable to all corrugated fibreboard grades.

ISO 3037:2013 specifies an unwaxed edge method for the determination of the edgewise crush resistance of corrugated fibreboard. It is applicable to all corrugated fibreboard grades.

2011-01-14 EMA: // final draft received in ISO/CS (see notification in dataservice from 2011-01-13).

ISO 3034:2011 specifies a method for determining the single sheet thickness of corrugated fibreboard intended for use in the manufacture of packing cases. ISO 3034:2011 is applicable to all types of corrugated fibreboard.

ISO 3039:2010 specifies a method for determining the grammage of the component layers from which corrugated fibreboard has been made. ISO 3039:2010 is applicable to all types of corrugated fibreboard.

This European Standard describes basic types and constructions of corrugated or solid fibreboard packagings. Folding cartons are not covered by this European Standard.

Is applicable to all types of corrugated fibreboards and in particular to fibreboards in which a high degree of resistance to wet conditions is required. Sampling shall be carried out according to ISO/R 186.