CEN/TC 266/WG 4 - Thermoplastic tanks made by the blow moulding and/or the rotational moulding processes, for the storage of oils having a flash point above 55 °C or 60 °C
To establish standards for static, thermoplastics tanks fabricated by the blow moulding and/or the rotational moulding processes, for the storage of oils having a flash point above 55° C.
Thermoplastic tanks made by the blow moulding and/or the rotational moulding processes, for the storage of oils having a flash point above 55 °C or 60 °C
To establish standards for static, thermoplastics tanks fabricated by the blow moulding and/or the rotational moulding processes, for the storage of oils having a flash point above 55° C.
General Information
This document specifies requirements for materials, physical properties and performance of single blow moulded and rotationally moulded polyethylene tanks or polyamide 6 (by anionic polymerisation) tanks, with or without reinforcements, for above ground storage of domestic heating oil, kerosene and diesel fuels.
It is only applicable to static blow moulded and rotationally moulded polyethylene tanks and polyamide 6 (by anionic polymerisation) tanks that are subject to atmospheric pressure and have a capacity from 450 l up to 10 000 l.
This document does not consider the consequences of wind or snow loading which is considered to be an installation issue.
- Standard33 pagesEnglish languagesale 10% offe-Library read for1 day