SIST ETS 300 248 E1:2004/A1:2004

SLOVENSKI STANDARD
SIST ETS 300 248 E1:2004/A1:2004
01-oktober-2004
3RVORYQHWHOHNRPXQLNDFLMH%7&7HKQLþQH]DKWHYH]D]DJRWDYOMDQMHRGSUWRVWL
RPUHåLM'LJLWDOQL]DNXSOMHQLYRGL]DSUHQRVQRKLWURVWNELWVLQ]D
QHVWUXNWXULUDQHVLJQDOH'89PHVQLNWHUPLQDOVNHRSUHPH
Business TeleCommunications (BTC); Open Network Provision (ONP) technical
requirements; 2 048 kbit/s digital unstructured leased line (D2048U); Terminal equipment
interface
Ta slovenski standard je istoveten z: ETS 300 248/A1 Edition 1
ICS:
33.040.50 Vodi, zveze in tokokrogi Lines, connections and
circuits
SIST ETS 300 248 E1:2004/A1:2004 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST ETS 300 248 E1:2004/A1:2004

---------------------- Page: 2 ----------------------

SIST ETS 300 248 E1:2004/A1:2004
ETS 300 248
AMENDMENT A1
November 1995
Source: ETSI TC-BTC Reference: RE/BTC-02062
ICS: 33.120
Key words: ONP, leased lines, D2048U
This amendment A1 modifies
the European Telecommunication Standard ETS 300 248 (1993)
Business TeleCommunications (BTC);
Open Network Provision (ONP) technical requirements;
2 048 kbit/s digital unstructured leased line (D2048U);
Terminal equipment interface
ETSI
European Telecommunications Standards Institute
ETSI Secretariat
Postal address: F-06921 Sophia Antipolis CEDEX - FRANCE
Office address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE
X.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariat@etsi.fr
Tel.: +33 92 94 42 00 - Fax: +33 93 65 47 16
Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the
foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 1995. All rights reserved.

---------------------- Page: 3 ----------------------

SIST ETS 300 248 E1:2004/A1:2004
Page 2
ETS 300 248 October 1993/A1: November 1995
Whilst every care has been taken in the preparation and publication of this document, errors in content,
typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to
"ETSI Editing and Committee Support Dept." at the address shown on the title page.

---------------------- Page: 4 ----------------------

SIST ETS 300 248 E1:2004/A1:2004
Page 3
ETS 300 248 October 1993/A1: November 1995
Foreword
This amendment to ETS 300 248 (1993) has been produced by the Business TeleCommunications (BTC)
Technical Committee of the European Telecommunications Standards Institute (ETSI).
This amendment changes ETS 300 248 (1993) as described below:
The connector type specified, conforming to ISO/IEC 10173 (1991), cannot be manufactured. Since a
standardized connector is not available, the terminal equipment is required to provide either a point for
connection of solid conductors, or solid conductors themselves. In order to allow connection to be made
using other methods, the TE is permitted to be supplied with other connection schemes (e.g. connectors).
Transposition dates
Date of adoption of this amendment: 31 October 1995
Date of latest announcement of this amendment (doa): 31 January 1996
Date of latest publication or endorsement of this amendment (dop/e): 31 July 1996
Date of withdrawal of any conflicting National Standard (dow): 31 July 1996

---------------------- Page: 5 ----------------------

SIST ETS 300 248 E1:2004/A1:2004
Page 4
ETS 300 248 October 1993/A1: November 1995
Amendments
Page 7, amendment to clause 2
Delete reference [6].
Page 9, amendment to subclause 5.1
Replace subclause 5.1 with subclauses 5.1, 5.1.1 and 5.1.2 as given below:
"5.1 Physical characteristics
Currently no standardized connector is readily available. Consequently, the only method of connection that
can be specified in this ETS is the use of solid conductors of 0,4 to 0,6 mm. This ETS requires the TE to
be capable of presenting either a point for the attachment of unterminated solid conductors, or solid
conductors themselves (see subc
...