SIST EN ISO 179-1:2001/A1:2005

DRAFT
EUROPEAN STANDARD
EN ISO 179-1:2000
NORME EUROPÉENNE
prA1
EUROPÄISCHE NORM
January 2004
ICS
English version
Plastics - Determination of Charpy impact properties - Part 1:
Non-instrumented impact test - Amendment 1 (ISO 179-
1:2000/DAM 1:2004)
Plastiques - Détermination des caractéristiques au choc Kunststoffe - Bestimmung der Charpy-Schlageigenschaften
Charpy - Partie 1: Essai de choc non instrumenté - - Teil 1: Nichtinstrumentierte Schlagzähigkeitsprüfung (ISO
Amendement 1 (ISO 179-1:2000/DAM 1:2004) 179-1:2000/DAM 1:2004)
This draft amendment is submitted to CEN members for parallel enquiry. It has been drawn up by the Technical Committee CEN/TC 249.
This draft amendment A1, if approved, will modify the European Standard EN ISO 179-1:2000. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status
as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 179-1:2000/prA1:2004 E
worldwide for CEN national Members.

---------------------- Page: 1 ----------------------

EN ISO 179-1:2000/prA1:2004 (E)
Foreword
This document (EN ISO 179-1:2000/prA1:2004) has been prepared by Technical Committee
ISO/TC 61 "Plastics" in collaboration with Technical Committee CEN/TC 249 "Plastics", the
secretariat of which is held by IBN.
This document is currently submitted to the parallel Enquiry.
NOTE FROM CMC The foreword is susceptible to be amended on reception of the German
language version. The confirmed or amended foreword, and when appropriate, the normative
annex ZA for the references to international publications with their relevant European publications
will be circulated with the German version.
Endorsement notice
The text of ISO 179-1:2000 has been approved by CEN as EN ISO 179-1:2000/prA1:2004 without
any modifications.
2

---------------------- Page: 2 ----------------------

DRAFT AMENDMENT ISO 179-1:2000/DAmd 1
ISO/TC 61/SC 2 Secretariat: AENOR
Voting begins on: Voting terminates on:
2004-01-29 2004-06-29
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Plastics — Determination of Charpy impact properties —
Part 1:
Non-instrumented impact test
AMENDMENT 1
Plastiques — Détermination des caractéristiques au choc Charpy —
Partie 1: Essai de choc non instrumenté
AMENDEMENT 1
ICS 83.080.01

ISO/CEN PARALLEL ENQUIRY
The CEN Secretary-General has advised the ISO Secretary-General that this ISO/DIS covers a subject
of interest to European standardization. In accordance with the ISO-lead mode of collaboration as
defined in the Vienna Agreement, consultation on this ISO/DIS has the same effect for CEN
members as would a CEN enquiry on a draft European Standard. Should this draft be accepted, a
final draft, established on the basis of comments received, will be submitted to a parallel two-month FDIS
vote in ISO and formal vote in CEN.
In accordance with the provisions of Council Resolution 15/1993 this document is circulated in
the English language only.
Conformément aux dispositions de la Résolution du Conseil 15/1993, ce document est distribué
en version anglaise seulement.
To expedite distribution, this document is circulated as received from the committee secretariat.
ISO Central Secretariat work of editing and text composition will be undertaken at publication
stage.
Pour accélérer la distribution, le présent document est distribué tel qu'il est parvenu du
secrétariat du comité. Le travail de rédaction et de composition de texte sera effectué au
Secrétariat central de l'ISO a
...