SIST EN 50341-2-5:2018

SLOVENSKI STANDARD
SIST EN 50341-2-5:2018
01-februar-2018
1DG]HPQLHOHNWULþQLYRGL]DL]PHQLþQHQDSHWRVWLQDGN9GHO1DFLRQDOQD
QRUPDWLYQDGRORþLOD11$]D'DQVNRQDSRGODJL(1
Overhead electrical lines exceeding AC 1 kV – Part 2-5: National Normative Aspects
(NNA) for DENMARK (based on EN 50341-1:2012)
Lignes électriques aériennes dépassant 1 kV en courant alternatif - Partie 2-5: Aspects
normatifs nationaux (NNA)pour le DANEMARK (basé sur l'EN 50341-1:2012)
Ta slovenski standard je istoveten z: EN 50341-2-5:2017
ICS:
29.240.20 Daljnovodi Power transmission and
distribution lines
SIST EN 50341-2-5:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 50341-2-5:2018

---------------------- Page: 2 ----------------------

SIST EN 50341-2-5:2018


EUROPEAN STANDARD EN 50341-2-5

NORME EUROPÉENNE

EUROPÄISCHE NORM
February 2017
ICS 29.240.20

English Version
Overhead electrical lines exceeding AC 1 kV - Part 2-5: National
Normative Aspects (NNA) for DENMARK
(based on EN 50341-1:2012)
Lignes électriques aériennes dépassant 1 kV en courant
alternatif - Partie 2-5: Aspects normatifs nationaux
(NNA)pour le DANEMARK (basé sur l'EN 50341-1:2012)
This European Standard was approved by CENELEC on 2017-02-01.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden,
Switzerland, Turkey and the United Kingdom.


European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2017 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
 Ref. No. EN 50341-2-5:2017 E

---------------------- Page: 3 ----------------------

SIST EN 50341-2-5:2018
EN 50341-2-5:2017  -2/12- Denmark




Contents
 Page

European foreword . 4
1 Scope . 5
1.1  DK.1 Reliability levels . 5
2 Normative references, definitions and symbols . 5
2.1 DK.1 Normative references . 5
2.3    DK.1 Symbols . 5
3 Basis of design . 6
3.2    Requirements of overhead lines . 6
3.2.2  DK.1 Reliability levels . 6
4 Actions on lines . 6
4.1  DK.1 Introduction . 6
4.3    Wind loads . 6
4.3.1  DK.1 Field of application and basic wind velocity . 6
Table 4.3.1/DK.1 - Reference wind speeds in Denmark . 6
4.3.3  DK.1 Mean wind pressure . 6
4.4    Wind forces on overhead line components . 6
4.4.1  Wind forces on conductors . 6
4.4.1.1 DK.1 General . 6
DK.2 General . 6
4.4.1.3 DK.1 Drag factor . 7
4.4.3  Wind forces on lattice towers . 7
4.4.3.1  DK.1 General . 7
4.4.4  DK.1 Wind forces on poles . 7
4.5    Ice loads . 7
4.5.1  DK.1 General . 7
4.5.2  DK.1 Ice forces on conductors . 7
4.6   Combined wind and ice loads . 7
4.6.6  Combination of wind velocity and ice loads . 7
4.6.6.1  DK.1 Extreme ice load IT combined with a high probability wind velocity VIH . 7
4.6.6.2  DK.1 Nominal ice load l3 combined with a low probability wind velocity VIL . 7
4.7   DK.1 Temperature effects . 7
4.8    Security loads . 7
4.8.2  DK.1 Torsional loads . 8
4.8.3  DK.1 Longitudinal loads . 9
4.12   Load cases . 9
4.12.1 DK.1 General . 9
4.12.2 DK.1 Standard load cases . 9
4.13   DK.1 Partial factors for actions . 9
5 Electrical requirements . 9
5.6 Load cases for calculation of clearances . 9
5.6.1  DK.1 Load conditions . 9
5.6.2  DK.1 Maximum conductor temperature. 9
5.6.3  DK.1 Wind loads for determination of electric clearances . 9
5.6.3.2  DK.1 Nominal wind loads for determination of internal and external clearances . 10
5.6.4   DK.1 Ice loads for determination of electric clearances . 10
5.6.5 DK.1 Combined wind and ice loads . 10
5.8 DK.1 Internal clearances within the span and at the top of support . 10
5.9   External clearances . 10
5.9.3   DK.1 External clearances to residential and other buildings . 10
5.9.4   DK.1 External clearances to crossing traffic routes . 10
5.9.7   DK.1 External clearances to recreational areas (playgrounds, sports areas, etc.) . 10
6       Earthing systems . 11
7       Supports . 11
7.1     Initial design considerations . 11
7.1.1   DK.1 Introduction . 11
7.2.1   DK.1 Steel materials, bolts, nuts and washers, welding consumables . 11

---------------------- Page: 4 ----------------------

SIST EN 50341-2-5:2018
Denmark                                -3/12-                       EN 50341-2-5:2017



7.2.4   DK.1 Holding-down bolts . 11
7.3.6    Ultimate limit states . 11
7.3.6.1   DK.1 General . 11
7.4.6.1   DK.1 General . 11
7.4.8    Resistance of connections . 11
7.4.8.3   DK.1 General . 11
7.6.4   DK.1 Ultimate limit states . 11
8       Foundations . 12
8.2.2   DK.1 Geotechnical design by calculation . 12
8.3     DK.1 Soil investigation and geotechnical data (EN 1997-1:2004 – Section 3) . 12
9       Conductors and earth-wires . 12
10      Insulators . 12
10.1  DK.1 Introduction . 12
10.7  DK.1 Mechanical requirements . 12
11      Hardware . 12
12      Quality assurance, checks and taking-over . 12

---------------------- Page: 5 ----------------------

SIST EN 50341-2-5:2018
EN 50341-2-5:2017  -4/12- Denmark



European foreword

1 The Danish National Committee (NC) is identified by the following address:

Dansk Standard
Göteborg Plads 1
DK-2150 Nordhavn
Phone no. +45 39 96 61 01
E-mail: dansk.standard@ds.dk

2 The Danish NC has prepared this Part 2-5 of EN 50341, listing the Danish national normative aspects,
under its sole responsibility, and duly passed it through the CENELEC and CLC/TC 11 procedures.

NOTE  The Danish NC also takes sole responsibility for the technically correct coordination of this EN 50341-2-
5 with EN 50341-1:2012. It has performed the necessary checks in the frame of quality assurance/control. It is
noted however that this quality assurance/control has been made in the framework of the general responsibility
of a standards committee under the national laws/regulations.

3 This EN 50341-2-5 is normative in Denmark and informative for other countries.

4 This EN 50341-2-5 has to be read in conjunction with EN 50341-1:2012, hereinafter referred to as Part
1. All clause numbers used in this Part 2-5 correspond to those of Part 1.

Specific sub clauses, which are prefixed “DK”, are to be read as amendments to the relevant text in
Part 1. Any necessary clarification regarding the application of Part 2-5 in conjunction with Part 1 shall
be referred to the Danish NC who will, in cooperation with CLC/TC 11 clarify the requirements.

When no reference is made in Part 2-5 to a specific sub clause, then Part 1 applies.

5 In the case of “boxed values” defined in Part 1, amended values (if any) which are defined in Part 2-5
shall be taken into account in Denmark.

However any “boxed values“, whether in Part 1 or Part 2-5, shall not be amended in the direction of
greater risk in a Project Specification.


6 The national Danish standards/regulations related to overhead electrical lines exceeding 1 kV (AC)
are identified in 2.1/DK1.

NOTE  All national standards referred to in this Part 2-5 will be replaced by the relevant European Standards as
soon as they become available and are declared by the Danish NC to be applicable and thus reported to the
secretary of CLC/TC 11.

---------------------- Page: 6 ----------------------

SIST EN 50341-2-5:2018
Denmark                                -5/
...