SIST EN 3635:2008
(Main)Aerospace series - Weld lip - Geometrical configuration
Aerospace series - Weld lip - Geometrical configuration
The purpose of this standard is to specify the dimensions and tolerances for orbital-welding fittings, intended for stainless steel fluid pipes to EN 3717.
Luft- und Raumfahrt - Rohranschlussenden geschweißt - Masse
Der Zweck dieser Norm ist die Festlegung der Maße und Grenzabmaße von Anschlussenden zum Umfangsschweißen für Fluid-Rohre nach EN 3717 aus nicht rostendem Stahl.
Série aérospatiale - Embout à souder - Configuration géometrique
Aeronavtika - Varjeni zaključek priključne cevi - Geometrijski načrt
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Aerospace series - Weld lip - Geometrical configurationþUWSérie aérospatiale - Embout à souder - Configuration géometriqueLuft- und Raumfahrt - Rohranschlussenden geschweißt - Masse49.080Aerospace fluid systems and componentsICS:SIST EN 3635:2008enTa slovenski standard je istoveten z:EN 3635:200801-julij-2008SIST EN 3635:2008SLOVENSKI
STANDARD
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 3635April 2008ICS 49.080 English VersionAerospace series - Weld lip - Geometrical configurationSérie aérospatiale - Embout à souder - ConfigurationgéometriqueLuft- und Raumfahrt - Rohranschlussenden geschweißt -MasseThis European Standard was approved by CEN on 21 December 2007.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2008 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 3635:2008: E
EN 3635:2008 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Fitting dimensions.4 4 Tube end geometry.6 5 Designation.6 6 Indications on drawings.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.