ISO 18639-5:2018
(Main)PPE ensembles for firefighters undertaking specific rescue activities — Part 5: Helmet
PPE ensembles for firefighters undertaking specific rescue activities — Part 5: Helmet
This document provides the principles that govern the development of incident type and/or hazard specific test methods and minimum performance requirements for helmets for firefighters while engaged in specific rescue activities. Helmets related to specific rescue activities, such as road traffic crash (RTC) and urban search and rescue (USAR), are documented in individual subclauses of this document. NOTE Further guidance can be found in ISO 18639-1. The purpose of this document is to ensure that minimum performance requirements for incident type and/or hazard specific helmets are designated. This document covers general helmet design, the minimum performance level of the materials used and the methods of test for determining this performance level. It does not cover special helmets for use in other high risk situations such as firefighting. This document does not cover protection for the torso, arms, legs and feet or protection of the hands against other hazards, e.g. chemical, biological, radiation and electrical hazards, except for limited, accidental exposure to fire ground chemicals and contaminated blood or body fluids. Selection of the appropriate system of personal protective equipment, (PPE), including helmets, is dependent on carrying out an effective risk assessment which identifies the hazard to be faced, evaluates the likelihood of those hazards and provides the means of reducing or eliminating these hazards.
Équipements de protection personnelle pour pompiers entreprenant des activités de sauvetage particulières — Partie 5: Casque
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 18639-5
First edition
2018-11
PPE ensembles for firefighters
undertaking specific rescue
activities —
Part 5:
Helmet
Équipements de protection personnelle pour pompiers entreprenant
des activités de sauvetage particulières —
Partie 5: Casque
Reference number
ISO 18639-5:2018(E)
©
ISO 2018
---------------------- Page: 1 ----------------------
ISO 18639-5:2018(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 18639-5:2018(E)
Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Physical requirements . 3
4.1 Material and construction . 3
4.2 Projections . 3
4.3 Retention system . 3
4.4 Accessories and non-integral additional protective devices . 3
4.5 Inspection . 3
5 Sampling and pre-treatment . 4
5.1 Sampling and helmet adjustment . 4
5.1.1 Samples . 4
5.1.2 Helmet adjustment. 4
5.2 Pre-conditioning . 4
5.2.1 General. 4
5.2.2 'Thermal plus' conditioning . 4
5.2.3 'Thermal minus' conditioning . 4
5
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.