EN 62271-200:2012

SLOVENSKI STANDARD
01-marec-2012
1DGRPHãþD
SIST EN 62271-200:2004
9LVRNRQDSHWRVWQHVWLNDOQHLQNUPLOQHQDSUDYHGHO6WLNDOQHLQNUPLOQH
QDSUDYHYNRYLQVNLKRKLãMLK]DQD]QDþHQHL]PHQLþQHQDSHWRVWLQDGN9LQGR
YNOMXþQRN9,(&
High-voltage switchgear and controlgear - Part 200: AC metal-enclosed switchgear and
controlgear for rated voltages above 1 kV and up to and including 52 kV (IEC 62271-
200:2011)
Hochspannungs-Schaltgeräte und -Schaltanlagen - Teil 200: Metallgekapselte
Wechselstrom-Schaltanlagen für Bemessungsspannungen über 1 kV bis einschließlich
52 kV (IEC 62271-200:2011)
Appareillage à haute tension - Partie 200: Appareillage sous enveloppe métallique pour
courant alternatif de tensions assignées supérieures à 1 kV et inférieures ou égales à 52
kV (CEI 62271-200:2011)
Ta slovenski standard je istoveten z: EN 62271-200:2012
ICS:
29.130.10 Visokonapetostne stikalne in High voltage switchgear and
krmilne naprave controlgear
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 62271-200
NORME EUROPÉENNE
January 2012
EUROPÄISCHE NORM
ICS 29.130.10 Supersedes EN 62271-200:2004

English version
High-voltage switchgear and controlgear -
Part 200: AC metal-enclosed switchgear and controlgear for rated
voltages above 1 kV and up to and including 52 kV
(IEC 62271-200:2011)
Appareillage à haute tension -  Hochspannungs-Schaltgeräte und -
Partie 200: Appareillage sous enveloppe Schaltanlagen -
métallique pour courant alternatif de Teil 200: Metallgekapselte Wechselstrom-
tensions assignées supérieures à 1 kV et Schaltanlagen für
inférieures ou égales à 52 kV Bemessungsspannungen über 1 kV bis
(CEI 62271-200:2011) einschließlich 52 kV
(IEC 62271-200:2011)
This European Standard was approved by CENELEC on 2011-11-28. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels

© 2012 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 62271-200:2012 E
Foreword
The text of document 17C/523/FDIS, future edition 2 of IEC 62271-200, prepared by SC 17C,
"High-voltage switchgear and controlgear assemblies", of IEC/TC 17, "Switchgear and controlgear" was
submitted to the IEC-CENELEC parallel vote and approved by CENELEC as EN 62271-200:2012.

The following dates are fixed:
(dop) 2012-08-28
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
(dow) 2014-11-28
• latest date by which the national
standards conflicting with the
document have to be withdrawn
This document supersedes EN 62271-200:2004.
EN 62271-200:2004. As maintenance result, EN 62271-200:2012 introduces the following significant
changes:
 definitions, classifications and testing procedures are specified more precisely;
 categories LSC2A and LSC2B have been clarified and LSC2 has been assigned a separate definition;
 specific ratings related to fault level to earth (4.5 to 4.7) are introduced;
 solid insulated high-voltage parts are no longer considered as compartments on their own;
 an optional rating "cable test voltage" and the associated requirements and type tests are introduced;
 for testing the internal arc classification, when assigned by the manufacturer, more specific guidance is
provided regarding the test arrangement, room simulation and arc initiation;
 a single phase to earth ignition is also recognised for internal arc testing;
 the Annexes A and B are renumbered Annexes AA and BB.
The level of severity of internal arc testing is maintained without changes.
This European Standard should be read in conjunction with EN 62271-1:2008, to which it refers and
which is applicable unless otherwise specified. In order to simplify the indication of corresponding
requirements, the same numbering of clauses and subclauses is used as in EN 62271-1. Amendments to
these clauses and subclauses are given under the same numbering, whilst additional subclauses, are
numbered from 101.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
- 3 - EN 62271-200:2012
Endorsement notice
The text of the International Standard IEC 62271-200:2011 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 60059:1999 NOTE  Harmonized as EN 60059:1999 (not modified).
IEC 60243-1:1998 NOTE  Harmonized as EN 60243-1:1998 (not modified).
IEC 60909-0:2001 NOTE  Harmonized as EN 60909-0:2001 (not modified).
IEC 62271-203:2003 NOTE  Harmonized as EN 62271-203:2004 (not modified).
IEC/TR 62271-303:2008 NOTE  Harmonized as CLC/TR 62271-303:2009 (not modified).

Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications

The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.

NOTE  When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD
applies.
Publication Year Title EN/HD Year

IEC 60050-151 - International Electrotechnical Vocabulary - -
(IEV) -
Part 151: Electrical and magnetic devices

IEC 60050-441 1984 International Electrotechnical Vocabulary - -
(IEV) -
Chapter 441: Switchgear, controlgear and
fuses
IEC 60060-1 - High-voltage test techniques - EN 60060-1 -
Part 1: General definitions and test
requirements
IEC 60270 - High-voltage test techniques - Partial EN 60270 -
discharge measurements
1)
IEC 60470 1999 High-voltage alternating current contactors EN 60470 2000
and contactor-based motor starters + corr. June 2000

IEC 60529 1989 Degrees of protection provided by enclosures EN 60529 1991
(IP Code) + corr. May 1993
IEC 62262 - Degrees of protection provided by enclosures EN 62262 -
for electrical equipment against external
mechanical impacts (IK code)
IEC 62271-1 2007 High-voltage switchgear and controlgear - EN 62271-1 2008
Part 1: Common specifications
IEC 62271-100 - High-voltage switchgear and controlgear - EN 62271-100 -
Part 100: Alternating current circuit-breakers

IEC 62271-102 2001 High-voltage switchgear and controlgear - EN 62271-102 2002
+ corr. April 2002 Part 102: Alternating current disconnectors + corr. July 2008
+ corr. February 2005 and earthing switches + corr. March 2005
+ corr. May 2003
IEC 62271-103 - High-voltage switchgear and controlgear - EN 62271-103 -
Part 103: Switches for rated voltages above 1
kV up to and including 52 kV
IEC 62271-105 - High-voltage switchgear and controlgear - EN 62271-105 -
Part 105: Alternating current switch-fuse
combinations
IEC 62271-201 2006 High-voltage switchgear and controlgear - EN 62271-201 2006
Part 201: AC insulation-enclosed switchgear + corr. November 2006
and controlgear for rated voltages above 1 kV
and up to and including 52 kV
1)
EN 60470:2000 is superseded by EN 62271-106:2011, which is based on IEC 62271-106:2011.

- 5 - EN 62271-200:2012
Publication Year Title EN/HD Year

IEC/TS 62271-304 - High-voltage switchgear and controlgear - CLC/TS 62271-304 -
Part 304: Design classes for indoor enclosed
switchgear and controlgear for rated voltages
above 1 kV up to and including 52 kV to be
used in severe climatic conditions

ISO/IEC Guide 51 1999 Safety aspects - Guidelines for their inclusion - -
in standards
Annex ZB
(informative)
A-deviations
A-deviation: National deviation due to regulations, the alteration of which is for the time being outside the
competence of the CENELEC member.
This European Standard does not fall under any Directive.
In the relevant CEN/CENELEC countries these A-deviations are valid instead of the provisions of the
European Standard until they have been removed.
Clause Deviation
1 Italy (Italian pressure vessel code for electrical switchgear DM 1 December 1980 and DM
10 September 1981 published in Gazzetta Ufficiale n° 285 dated 16.10.1981)
For metal-enclosed switchgear and controlgear containing gas-filled compartments, the
design pressure is limited to a maximum of 0,5 bar (gauge) and the volume is limited to a
maximum of 2 m . Gas filled compartments having a design pressure exceeding 0,5 bar
(gauge) or a volume exceeding 2 m shall be designed according to the Italian pressure
vessel code for electrical switchgear.

IEC 62271-200 ®
Edition 2.0 2011-10
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
High-voltage switchgear and controlgear –
Part 200: AC metal-enclosed switchgear and controlgear for rated voltages
above 1 kV and up to and including 52 kV

Appareillage à haute tension –
Partie 200: Appareillage sous enveloppe métallique pour courant alternatif
de tensions assignées supérieures à 1 kV et inférieures ou égales à 52 kV

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
PRICE CODE
INTERNATIONALE
CODE PRIX XC
ICS 29.130.10 ISBN 978-2-88912-743-6

– 2 – 62271-200  IEC:2011
CONTENTS
FOREWORD . 5
1 General . 7
1.1 Scope . 7
1.2 Normative references . 8
2 Normal and special service conditions . 8
3 Terms and definitions . 9
4 Ratings . 15
4.1 Rated voltage (U ) . 15
r
4.2 Rated insulation level . 16
4.3 Rated frequency (f ) . 16
r
4.4 Rated normal current and temperature rise . 16
4.5 Rated short-time withstand currents (I ). 16
k
4.6 Rated peak withstand current (I ) . 16
p
4.7 Rated durations of short circuit (t ) . 17
k
4.8 Rated supply voltage of closing and opening devices and of auxiliary and
control circuits (U ) . 17
a
4.9 Rated supply frequency of closing and opening devices and of auxiliary
circuits . 17
4.10 Rated pressure of compressed gas supply for controlled pressure systems . 17
4.11 Rated filling levels for insulation and/or operation . 17
4.101 Ratings of the internal arc classification (IAC). 17
4.102 Rated cable test voltages . 19
5 Design and construction . 19
5.1 Requirements for liquids in switchgear and controlgear . 19
5.2 Requirements for gases in switchgear and controlgear . 19
5.3 Earthing of switchgear and controlgear . 20
5.4 Auxiliary and control equipment . 21
5.5 Dependent power operation . 21
...