EN ISO 10591:1997

SLOVENSKI STANDARD
SIST EN ISO 10591:2001
01-december-2001
Gradnja objektov - Tesnilne mase - Ugotavljanje adhezijskih/kohezijskih lastnosti
po namakanju v vodi
Building construction - Sealants - Determination of adhesion/cohesion properties after
immersion in water (ISO 10591:1991)
Hochbau - Fugendichtstoffe - Bestimmung des Haft- und Dehnverhaltens nach dem
Tauchen in Wasser (ISO 10591:1991)
Construction immobiliere - Mastics - Détermination des propriétés d'adhésivité/cohésion
apres immersion dans l'eau (ISO 10591:1991)
Ta slovenski standard je istoveten z: EN ISO 10591:1997
ICS:
91.100.50 Veziva. Tesnilni materiali Binders. Sealing materials
SIST EN ISO 10591:2001 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 10591:2001

---------------------- Page: 2 ----------------------

SIST EN ISO 10591:2001

---------------------- Page: 3 ----------------------

SIST EN ISO 10591:2001

---------------------- Page: 4 ----------------------

SIST EN ISO 10591:2001

---------------------- Page: 5 ----------------------

SIST EN ISO 10591:2001

---------------------- Page: 6 ----------------------

SIST EN ISO 10591:2001
INTERNATIONAL
STANDARD
First edi tion
1991-11-01
----
-------_l_p
Building construction - Sealants -
Determination of adhesionkohesion properties
after immersion in water
- Determination des proprietes
Consfruction immobili&-e - Mastics
d ’adh&ivMlcoh&ion apr& immersion dans I ’eau
--- .---- ---- p--q-
---~ ----
=- ---
Reference numher
ISO 10591:1991(E)

---------------------- Page: 7 ----------------------

SIST EN ISO 10591:2001
ISO 18591:1991(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide
federation of national Standards bodies (ISO member bodies). The work
of preparing International Standards is normally carried out through ISO
technical committees. Esch member body interested in a subject for
which a technical committee has been established has the right to be
represented on that committee. International organizations, govern-
mental and non-governmental, in liaison with ISO, also take part in the
work. ISO collaborates closely with the International Electrotechnical
Commission (IEC) on all matters of electrotechnical standardization.
Draft International Standards adopted by the technical committees are
circulated to the member bodies for voting. Publication as an Interna-
tional Standard requires approval by at least 75 % of the member bodies
casting a vote.
International Standard ISO 10591 was prepared by Technical Committee
ISO/TC 59, Building construction, Sub-Committee SC 8, Joinfing pro-
dcrc ts.
0 ISO 1991
All rights reserved. No part of this publication may be reproduced or utilized in any form
or by any means, electronie or mechanical, including photocopying and microfilm, without
Permission in writing from the publisher.
International Organization for Standardization
Case Postale 56 + CH-121 1 Geneve 20 l Switzerland
Printed in Switzerland
ii

---------------------- Page: 8 ----------------------

SIST EN ISO 10591:2001
---
INTERNATIONAL STANDARD ISO 10591:1991(E)
Building construction - Sealants - Determination of
adhesionkohesion properties after immersion in water
1 Scope
5 Apparatus
This International Standard specifies a method for
5.1 Concrete and/or aluminium and/or flat glass
the determination of the influence of water immer-
supports, for the preparation of test specimens (two
sion on adhesionkohesion properties of sealants
supports are required for each specimen), of di-
used in joints in building construction.
mensions as shown in figures 1 and 2.
5.2 Spacers, of dimensions 12 mm x 12 mm
x 12,5 mm, with anti-adherent surface for the prep-
2 Normative reference aration of the test specimens (see figures 1 and 2).
NOTE 1 If spacers are made of material to which the
The following Standard contains provisions which,
sealant adheres, their surfaces should be made anti-
through reference in this text, constitute provisions
adherent, e.g. by a thin wax coating.
of this International Standard. At the time of publi-
cation, the edition indicated was valid. All Standards
5.3 Anti-adherent Substrate, for the preparation of
are subject to revision, and Parties to agreements
test specimens, e.g. polytetrafluoroethylene (PTFE)
based on this International Standard are encour-
film or vellum Paper, preferably according to the
aged to investigate the possibility of applying the
advice of the sealant manufacturer.
most recent edition of the Standard indicated below.
Members o
...