ISO/TC 24/SC 8/WG 2 - Industrial wire cloth

ISO 9044:2016 defines terms regarding industrial woven wire cloth for screening purposes and specifies maximum permissible error, requirements, and test methods. It applies to industrial woven wire cloth with square apertures, made of steel, stainless steel, or non-ferrous metals (see ISO 4783‑2). It does not apply to woven wire cloth coated after weaving nor does it apply to pre-crimped and welded wire screens which are covered in ISO 4783‑3 and ISO 14315. It is of limited application to woven wire cloth used for purposes other than screening which may necessitate other requirements. The alternative requirements may be agreed between the purchaser and the supplier at the time of placing the order.

Gives terms and definitions in English and French to facilitate understanding of the terminology relating to test sieves and test sieving. This second edition cancels and replaces the first edition (1972).

Tabulates a comprehensive range from which preferred groups of combinations may be chosen. The percentage open area of each combination is stated. The screens shall be designated in the following sequence by a) width of aperture, b) diameter of wire, c) material of wire, d) type of weave or type of crimp.

Tabulates values which are taken from the general list of combinations given in ISO 4783/1. Applies to aperture sizes from 16 mm to 0.02 mm. The wire cloth shall be designated in the following sequence by a) width of aperture, b) diameter of wire, c) material of wire, d) type of weave.

Tabulates values which are taken from the general list of combinations given in ISO 4783/1. Applies to aperture sizes from 125 to 1 mm. The screens shall de designated in the following sequence by a) width of aperture, b) diameter of wire, c) material of wire, d) type.